2011 JEEP WRANGLER light

[x] Cancel search: light

Page 156 of 603

JEEP WRANGLER 2011 JK / 3.G Owners Manual NOTE:The Daytime Running Lights will turn off
automatically when a turn signal is in operation and turn
on again when the turn signal is not operating.
Interior Lights
The overhead light will turn on

Page 157 of 603

JEEP WRANGLER 2011 JK / 3.G Owners Manual When a door is open and the interior lights are on,
rotating the dimmer control to the extreme bottom posi-
tion will cause all the interior lights to turn off. This is
also known as the “Party” m

Page 162 of 603

JEEP WRANGLER 2011 JK / 3.G Owners Manual The Electronic Speed Control buttons are located on the
right side of the steering wheel.
NOTE:In order to ensure proper operation, the Elec-
tronic Speed Control System has been designed to shut
down

Page 164 of 603

JEEP WRANGLER 2011 JK / 3.G Owners Manual decrease until the button is released. Release the button
when the desired speed is reached, and the new set speed
will be established.
Pressing the SET (-) button once will result ina1mph
(2 km/h) de

Page 165 of 603

JEEP WRANGLER 2011 JK / 3.G Owners Manual The front power outlet is powered from the ignition
switch. Power is available when the ignition switch is in
the ON or ACC position.
When the optional cigar lighter heating element is used
in the pow

Page 166 of 603

JEEP WRANGLER 2011 JK / 3.G Owners Manual On vehicles equipped with a rear subwoofer, there is a
third power outlet located in the right rear cargo area.
Rear Power Outlet — If Equipped
Power Outlet Fuse Locations
1 — M7 Fuse 20 A Yellow

Page 167 of 603

JEEP WRANGLER 2011 JK / 3.G Owners Manual WARNING!
To avoid serious injury or death:
•Only devices designed for use in this type of
outlet should be inserted into any 12 Volt outlet.
•Do not touch with wet hands.
•Close the lid when not

Page 169 of 603

JEEP WRANGLER 2011 JK / 3.G Owners Manual may have to be reset manually. To reset the inverter
manually press the power inverter button OFF and ON.
To avoid overloading the circuit, check the power ratings
on electrical devices prior to using