2011 JEEP WRANGLER battery

[x] Cancel search: battery

Page 157 of 603

JEEP WRANGLER 2011 JK / 3.G Owners Manual When a door is open and the interior lights are on,
rotating the dimmer control to the extreme bottom posi-
tion will cause all the interior lights to turn off. This is
also known as the “Party” m

Page 165 of 603

JEEP WRANGLER 2011 JK / 3.G Owners Manual The front power outlet is powered from the ignition
switch. Power is available when the ignition switch is in
the ON or ACC position.
When the optional cigar lighter heating element is used
in the pow

Page 167 of 603

JEEP WRANGLER 2011 JK / 3.G Owners Manual WARNING!
To avoid serious injury or death:
•Only devices designed for use in this type of
outlet should be inserted into any 12 Volt outlet.
•Do not touch with wet hands.
•Close the lid when not

Page 258 of 603

JEEP WRANGLER 2011 JK / 3.G Owners Manual CAUTION!
Do not remove the head impact foam from the side
bars, as damage to the foam may result.
NOTE: Store all of the mounting bolts in their original
threaded holes and tighten for safekeeping.
8.

Page 262 of 603

JEEP WRANGLER 2011 JK / 3.G Owners Manual wiper will continue to operate as long as the switch is
held. Upon release, the wiper will cycle two to three
times before returning to the set position.
If the rear wiper is operating when the igniti

Page 291 of 603

JEEP WRANGLER 2011 JK / 3.G Owners Manual •Right Rear Turn Signal Light Out (with a single chime)
•Key Fob Battery Low (with a single chime)
•Memory #1/#2 Profile Set
•Memory #1/#2 Profile Recall
•Memory System Disabled – Vehicle

Page 345 of 603

JEEP WRANGLER 2011 JK / 3.G Owners Manual Once the audio device is connected and synchronized to
the vehicle’s iPod/USB/MP3 control system (iPodor
external USB device may take a few minutes to connect),
the audio device starts charging an

Page 373 of 603

JEEP WRANGLER 2011 JK / 3.G Owners Manual Turn the ignition switch to the START position and
release when the engine starts. If the engine fails to start
within 10 seconds, turn the ignition switch to the LOCK
position, wait 10 to 15 seconds,