
L
(FM8) SEMCON JLR OWNER GUIDE VER 1.00  EURO
LANGUAGE: english-en; MARQUE: jaguar; MODEL: XF
Touch screen
62
DESELECTING VALET MODE
When you enter the vehicle, select the Valet 
mode screen.
Enter your four digit PIN and touch the  OK 
button. A pop-up is displayed. Read the 
information and stow th e emergency key in the 
Jaguar Smart Key.
Valet off is displayed to indicate that your PIN 
has been accepted.
• The luggage compartment  will return to the 
previously set security requirement.
• The glove box will now open as normal.
Note:  If the PIN is forgotten, open the luggage 
compartment using the emergency key blade 
to cancel Valet mode. 

R
(FM8) SEMCON JLR OWNER GUIDE VER 1.00  EURO
LANGUAGE: english-en; MARQUE: jaguar; MODEL: XF
Luggage compartment
67
Luggage compartmentOPENING AND CLOSING THE LUGGAGE COMPARTMENT
If the luggage compartment is opened 
after the driver and passenger doors are 
locked, ensure that the Jaguar Smart 
Key remains outside the vehicle when it 
is closed again.
If the Smart Key is inadvertently left 
inside the luggage compartment and 
the vehicle is locked and alarmed, a 
warning sounds and the compartment 
will re-open after 3 seconds. The Smart Key may not be detected if it 
is placed within a meta
l container or if it 
is shielded by a device with a back-lit 
LCD screen, such as a smart phone, 
laptop (including la ptop bag), games 
console etc. 

L
(FM8) SEMCON JLR OWNER GUIDE VER 1.00  EURO
LANGUAGE: english-en; MARQUE: jaguar; MODEL: XF
Luggage compartment
68
Do not repeatedly attempt to close the 
luggage compartment after it 
automatically re-ope ns, or the latch 
may overheat. If the cause of the 
automatic re-ope ning cannot be 
determined: Unlock all the doors and 
the luggage compartment with the 
Smart Key; make sure that all doors, the 
bonnet and the luggage compartment 
are closed properly; lock the vehicle 
again with the Smart Key.
The luggage compartment can be opened 
using the appropriate button (1) on the Smart 
Key, or via keyless entry (see  6, KEYLESS 
ENTRY ). Provided the vehicle is not locked, the 
luggage compartment can also be opened 
using either the interior  release button (7) or 
the exterior release button (4).
The emergency key blade in the Smart Key can 
also be used to open the luggage 
compartment, as follows:
1. Press and hold the release button (3) on 
the Smart Key, then remove the emergency 
key blade (2).
2. Use the emergency key blade to remove 
the cap (5) from the trim panel above the 
license plate.
3. Insert the emergency key blade into the 
lock (6) and turn clockwise to open the 
luggage compartment.
If the security system is armed, the alarm 
will sound when the luggage compartment 
is opened. To deactiva te the alarm, press 
the vehicle unlock button on the Smart Key 
or press the engine START/STOP button 
with the Smart Key inside the vehicle.SOFT-CLOSE LID
Care should be taken when manually 
latching the boot lid as the soft-close 
feature will automat ically close the 
latch and possible injury may occur.
To activate the soft-close feature, lower the 
luggage compartment lid  onto the latch. The lid 
will then automatically move to the fully closed 
and latched position.
LUGGAGE ANCHOR POINTS
All items carried in the vehicle should 
be properly secured.
Four securing points are provided in the 
luggage area to assist in safely securing items.
Note:  A range of approved luggage retention 
accessories are available from your Dealer/ 
Authorised Repairer. 

L
(FM8) SEMCON JLR OWNER GUIDE VER 1.00  EURO
LANGUAGE: english-en; MARQUE: jaguar; MODEL: XF
Starting the engine
74
Starting the engineSTARTING A PETROL ENGINE
The Smart Key may not  be detected if it 
is placed within a metal container or if it 
is shielded by a device with a back-lit 
LCD screen, such as a smart phone, 
laptop (including laptop bag), games 
console etc. Keep the Smart Key clear of 
such devices when attempting Keyless 
entry or Keyless starting.
With the brake pedal applied ( 1) and with a 
valid Jaguar Smart Key in the vehicle, press 
and release the STAR T/STOP button. The 
engine will start, the Ja guarDrive selector will 
elevate out of the cent re console and a drive 
gear can be selected.
Note:  If, during the start procedure, the brake 
pedal is released, a gear  change is made or if a 
fault occurs,  Smart Start cancelled  is 
displayed in the message centre and the start 
procedure is cancelled.
STARTING A DIESEL ENGINE
The Smart Key may not be detected if it 
is placed within a meta l container or if it 
is shielded by a device with a back-lit 
LCD screen, such as a smart phone, 
laptop (including la ptop bag), games 
console etc. Keep the Smart Key clear of 
such devices when attempting Keyless 
entry or Keyless starting.
With the brake pedal applied and with a valid 
Jaguar Smart Key in the vehicle, press and 
release the START/STOP button. In ambient 
conditions, within 3 se conds, the engine will 
start to crank. The JaguarDrive selector will 
elevate out of the centre console.
In very cold conditions, expect engine cranking 
times to increase.
Note:   If, during the start procedure, the brake 
pedal is released, a gear  change is made or if a 
fault occurs,  Smart Start cancelled  is 
displayed in the message centre and the start 
procedure is cancelled.
SWITCHING ON THE IGNITION
To turn on the ignition without starting the 
engine, make sure th e brake pedal is not 
applied and that there is  a valid Smart Key in 
the vehicle, then press and release the 
START/STOP button.
Note:  If the brake pedal is pressed when the 
START/STOP button is pressed, the engine will 
start. 

R
(FM8) SEMCON JLR OWNER GUIDE VER 1.00  EURO
LANGUAGE: english-en; MARQUE: jaguar; MODEL: XF
Starting the engine
75
STEERING COLUMN LOCK
The steering column has an electronic lock, 
which locks and unlocks in conjunction with 
the vehicle Locking/Alarm system. The steering 
column lock also locks when the ignition is 
switched off, after a time delay. If the steering 
column lock malfunctions,  Steering Column 
Locked  is displayed in the message centre. If 
this occurs:
1. Lock and then unlock  the vehicle using the 
Smart Key.
2. Try again to unlock the steering column 
lock, by turning the steering wheel gently 
to the left and right.
3. If the malfunction pers ists, seek qualified 
assistance immediately.
SWITCHING OFF THE ENGINE
With the gear sele ctor in position P, press the 
engine START/STOP butt on. The engine will 
stop and the ignition sy stem will return to 
convenience mode. The  audio, telephone and 
touch screen systems will revert to stand-by 
mode and the JaguarDrive  selector will retract 
into the centre console. 

L
(FM8) SEMCON JLR OWNER GUIDE VER 1.00  EURO
LANGUAGE: english-en; MARQUE: jaguar; MODEL: XF
Starting the engine
76
IF THE ENGINE FAILS TO START
If the brake pedal has been pumped prior to an 
attempt to start the engine, it may require 
greater pressure on the pedal in order for the 
engine to start.
If the Jaguar Smart Key  is placed in the door 
pocket, it may be outside the range of the 
sensors when the door is open.
 If the Smart Key fails to operate,  Smart Key 
Not Found- Refer to Handbook  is displayed in 
the message centre. To start the engine it will 
be necessary to dock the Smart Key, as 
follows:
1. Insert the Smart Key fully into the starter 
control unit, as shown.
Note:  When docking the Smart Key, it is 
recommended that the emergency key 
blade is left in place.  The end of the blade 
can then be used as a handle, to pull the 
Smart Key from the control unit when 
undocking.
2. Ensure the Smart Key is securely docked, 
then press and release the START/STOP 
button with the brake pe dal applied to start 
the engine. 3.
To undock the smart key, ensure that the 
gear selector is in the  P position and the 
ignition is switched off, then press and 
release the Smart Key. The Smart Key will 
eject from the st arter control unit.
Ensure that the ignition is switched 
off before undocking the Smart 
Key, otherwise damage to the 
Smart Key may occur.
4. Remove the Smart Key.
If the engine still fails to  start, seek qualified 
assistance. 

R
(FM8) SEMCON JLR OWNER GUIDE VER 1.00  EURO
LANGUAGE: english-en; MARQUE: jaguar; MODEL: XF
Stability control
83
Stability controlWINTER MODE
Winter mode optimises stability of the vehicle 
to suit slippery conditions, when grip is 
reduced. This helps the vehicle to perform in a 
more gentle and controlled manner, to avoid 
skidding, allowing more confident progress 
under adverse conditions.
Note:  Winter mode cannot be active at the 
same time as Dynamic m ode. Winter mode will 
remain selected indefinitely, even after the 
ignition is switched off.  Winter mode must be 
deselected if no longer required.
DYNAMIC MODE
Note:  When the transmission is set to 
permanent manual mode  and Dynamic mode is 
selected, transmission upshifts are fully 
controlled by the driver . The transmission will 
not change up automatically, even when the rev 
limit is reached (the ge ar position indicator in 
the message centre will gl ow amber, to indicate 
that the next gear should be selected).
Note:  Dynamic mode cannot  be active at the 
same time as Winter mode. Dynamic mode will 
remain selected for  approximately six hours 
after the ignition is switched off, after which 
point it will need to be  reselected if required.
TRACDSC
Vehicle safety may be reduced by 
inappropriate use of of Trac DSC. Trac 
DSC should only be used in suitable 
conditions.
Trac DSC is an alternative setting of DSC, with 
reduced system interventions. With Trac DSC 
engaged, traction may be  increased, although 
stability may be reduced compared to normal 
DSC. Trac DSC is intended for use only on dry 
tarmac, by suitably experienced drivers. Trac 
DSC should not be selected for other surfaces 
or by drivers with insuff icient skill and training 
to operate the vehicle safely with Trac DSC 
function engaged.
Press to operate. Designed for use 
in slippery conditions, when 
active, Winter mode selects 2nd 
gear for driving away on level 
ground (no incline), softens the 
responsiveness of the engine and 
modifies the gear change strategy. 
This helps ensure that optimum 
traction is maintained.
Press to operate. Dynamic mode 
co-ordinates the vehicle's control 
systems to deliver a high 
performance driving experience. 
This setting enhances key vehicle 
systems so that the vehicle's full 
potential can be exploited. The 
vehicle's responses are aimed at 
involving the driver more in 
focused and purposeful driving. 

R
(FM8) SEMCON JLR OWNER GUIDE VER 1.00  EURO
LANGUAGE: english-en; MARQUE: jaguar; MODEL: XF
Audio/video overview
105
7. Seek down:
Short press:
•To auto seek down the frequency to the 
next radio station.
• To select the previous  track or start of 
current track on chosen audio source - 
CD, MP3 etc.
• To select the previous TV channel on 
the channel list or the previous DVD 
chapter.
Long press:
• To activate radio  manual seek mode.
• To skip backward through current 
audio source track.
With radio manual seek  mode activated, 
further short presse s will change the 
frequency in single decrements. A further 
long press will scan backward through the 
current waveband until the button is 
released.
8. CD/DVD eject button.
9. Rotate to adjust volume.
10. Rotate (up or down) and release repeatedly 
to scroll through:
•The radio presets.
• The previous track or  start of next track 
on chosen audio source - CD, MP3 etc.
11. MODE : Press repeatedly to scroll through 
all audio/video sources.
12. If Telephone and Voice control are not 
fitted, press to mute/un-mute audio. 
Otherwise, if Tele phone is fitted, see  128, 
TELEPHONE SYSTEM OVERVIEW. If Voice 
control is fitted, see  126, USING VOICE 
CONTROL .AUDIO SETTINGS
To view the audio settings menu, select 
Settings and then  Sound on the touch screen.
To adjust the sound settings:
1. Touch the  + or - soft keys to adjust Bass, 
Treble or Subwoofer levels.
2. If surround sound is fitted, touch the 
appropriate soft  key to select DPL II X, DTS 
Neo6 or select  Off to switch surround 
sound off.
To adjust balance and fade:
1. From the Sound settings menu, select 
Balance/Fade.
2. Touch the arrow soft keys to move the 
sound focal point to the desired area of the 
vehicle (the focal cr oss-hairs will appear 
red when not in the default position). 
Alternatively, touch  the sound focal point 
and 'drag' it to  the required position.