Malfunction IndicatorsIf an indicator remains on, there may be a problem; see your dealer
On\bOff Indicators
Condition IndicatorsAction is needed by driver
PASSENGERAIRBAG
OFFPASSENGER AIRBAG OFF(located on center panel)
SIDE AIRBAG OFF
CRUISE CONTROL on
ECOECO on
VSA Activation on
Fog lights on (if equipped)
Headlights on
Turn signals/hazards on
High beams on
Charging system
Low brake fluid
Low oil pressure
ABS (anti\block brake system)
VTM\b4 (4WD only)
Malfunction lamp (check engine light)
VSA(vehicle stability assist)SRS (supplemental restraint system)
Light controlDRL(daytime running lights)
TPMS(tire pressure monitoring system)
Parking brake on:
Release
Door/Tailgate open:
Close door(s) / tailgate
Seat belt reminder:
Fasten seat belt(s)
Maintenance Information:
Make dealer appointmentWasher Level (if equipped):
Add fluid
A/T Temperature (4WD only):
Pull over and let engine idleStarter System: Hold
ignition switch in START
(III) for up to 15 seconds
Low fuel:
Refill
Low tire pressure:
Add air
INSTRUMENT PANEL INDICATORS
Immobilizer
Flashes: improperly coded key;
use correct key
Briefly appear with each engine start. Red and amber indicators are most critical. Blue
and green indicators are used for general information.
23
CRUISE MAIN on
L L X
XE
E X
XE
E X
XL
L
11 PilotTRG\fATG_NEW STYLE 1/2\b/2010 12\f35 PM Page 3
2011 Pilot
A U T O D O O R L O C K SAllows you to program how and when the vehicle doors automatically lock and unlock.
Default Lock\bUnlock Setting
Default Lock Setting
All doors are preset to lock when
your vehicle reaches about 9 mph.
Modifying the Auto Door Unlock Setting
Programmable Auto Door Lock\bUnlock SettingsPresseither Info ( / ) button to toggle to the “Keyless Memory Settings” display
on the MID, then pressSEL/RESET to activate the menu.
Below are the different programmable options you can choose. See Auto Door Lock
ing/Unlocking in your owner's manual for instructions on programming these settings. \f. Select
“CHANGE SETTING.”
2. Select “DOOR\bWINDOW SETUP.”
3. Select “AUTO DOOR UNLOCK.”
4 . Select “SHIFT TO P.”
5 . Select“ALL DOORS.”
6. Select“EXIT” to save the setting and
exit the menu.
Default Lock Setting
Only the driver’s door is preset to
unlock when you shift into Park (P).
1011
AUTO DOOR UNLOCK
Auto Unlock
(all doors)
When you turn
the ignition OFFWhen you shift into Park
Auto Unlock
(only driver’s door)
When you turn
the ignition OFFWhen you shift into Park
Turn off
Auto Unlock
Operate manually
AUTO DOOR LOCK
Auto Lock
When you
reach 9 mphWhen you shift out of Park
Turn off
Auto Lock
Operate manually
E E X
XL
LN
NT
T R
R N
N G
G
Modifying the Auto Door Unlock Setting
\f. Close the driver’s door. Shiftinto
Park.
2. Turn the ignition to the ON (II)
position.4. Within 5 seconds, turn the ignition to
the LOCK (0) position.
3. Press and hold the unlock side of
the master lock switch for about
\f0 seconds. In that time, you will
hear three clicks.
To program all doors to unlock when you shift to Park:
L L X
XE
E X
XE
EX
XL
L
L
LX
XE
E X
XE
EX
XL
LE
EX
XL
LN
NT
TR
R N
N G
G
11 PilotTRG\fATG_NEW STYLE 1/2\b/2010 12\f37 PM Page 7
2011 Pilot
