2011 HONDA CR-Z warning light

Quick Reference Guide
14
TachometerSpeedometer
Ambient Meter
IMA Battery Charge Level Indicator CHRG/ASST Indicators
Instant Fuel Economy GaugeMulti-Information Display
Security Alarm System Indicator
Shift Lever Position Indicator
Shift Up/Down Indicator *
7-Speed Manual Shift Mode Indicator
* Fuel Gauge
Instrument Panel
P. 6 7
Gauges P.81 Multi-Information Display
P.83 System Indicators
P.68
Lights On Indicator

High Beam Indicator

Fog Light Indicator *
Malfunction
Indicator Lamp

Low Oil Pressure Indicator

12 Volt Battery Charging System
Indicator

Anti-lock Brake System (ABS)
Indicator

Vehicle Stability Assist (VSA ®
)
System Indicator

VSA ®
OFF Indicator

Turn Signal and Hazard Warning
Indicators

Electric Power Steering (EPS)
Indicator

IMA System Indicator

Auto Idle Stop Indicator
Seat Belt Reminder Indicator

Immobilizer System Indicator
Parking Brake and Brake System
Indicator

Supplemental Restraint System
Indicator
Side Airbag Off Indicator
U.S. models only
Low Tire Pressure/ TPMS Indicator

Door/Hatch Open Indicator

Cruise Main Indicator

Cruise Control Indicator

System Message Indicator
Lights Reminders
System Indicators System Indicators
High Temperature
Indicator

Low Temperature Indicator

Low Fuel Indicator
System Indicators
SPORT Mode Indicator

NORMAL Mode Indicator

ECON Mode Indicator
System Indicators
Main Menu

75
Instrument Panel
Indicators
IndicatorName On/Blinking Explanation Message
Lights On Indicator Comes on whenever the light

•
switch is on, or in AUTO when the exterior lights are on. If you remove the key from the

•
ignition switch while the light is on, a chime sounds when the driver’s door is opened.
—
Fog Light Indicator * Comes on when the fog lights are

•
on. ——
Turn Signal IndicatorsThe turn signal indicators blink

•
when you operate the turn signal lever.If you press the hazard warning

•
button, both indicators and all turn signals blink at the same time. Does not blink or blinks rapidly

• -
A turn signal light bulb has blown. Change the bulb immediately. Replacing Light Bulbs P.262, 263—
Immobilizer System IndicatorComes on briefly when you turn

•
the ignition switch to ON
II, then
goes off. Comes on if the immobilizer

•
system cannot recognize the key information. Blinks

• - You cannot start the engine.
Turn the ignition switch to LOCK
0, pull the key out, and then insert
the key and turn it to ON
II again.
Repeatedly blinks

• - The system may
be malfunctioning. Have the vehicle checked by a dealer.Do not attempt to alter this system

•
or add other devices to it. Electrical problems can occur.
—
*Not available on all models
Main MenuTable of Contents

78
Instrument Panel
Indicators Multi-Information Display Warning and Information Messages
Multi-Information Display Warning and Information Messages The following messages appear only on the multi-information display. Press the
(information) button to see the message again
with the system message indicator on.
Message Condition Explanation
Appears when the fuel fill cap is loose or is not

•
installed.
Tighten the Fuel Fill Cap P.301
Appears if there is a problem with the DRL system.

•
Daytime Running Lights P.112
Canadian models only Appears when washer fluid gets low.

• Refilling washer fluid.

•
Refilling Window Washer Fluid P.257
Appears when the scheduled maintenance is due

•
soon. Consequently, “SERVICE DUE NOW” and “SERVICE

•
PAST DUE” follow.
Maintenance Minder ™
P.241
Appears when you open the driver’s door while the

•
ignition key is in ACCESSORY
I. Turn the ignition switch to LOCK

•
0, then
remove the key.
Main MenuTable of Contents

107
Controls
Opening and Closing the Windows
Opening/Closing the Power Windows
Opening/Closing the Power Windows
The auto-reverse function stops sensing when the window is almost closed to ensure that it fully closes. The power windows can be operated for up to 10 minutes after you turn the ignition switch off.Opening either door cancels this function. Auto Reverse If a power window senses resistance when closing automatically, it will stop closing, and reverse direction. The driver’s window auto reverse function is disabled when you continuously pull up the switch.
WARNING
Closing a power window on someone’s hands or fingers can cause serious injury. Make sure your passenger is away from the window before closing it.
The power windows can be opened and closed when the ignition switch is in ON
II, using the switches on the doors. The driver side switch can be used to open and
close both windows. The main switch on the driver side must be switched off (not pushed in) to open and close the passenger’s window from the passenger side. When the main switch is turned on (pushed in), you can only operate the passenger’s window from the driver’s seat. Turn the main switch on if a child rides in the passenger’s seat.
Opening/Closing the Driver’s Window

■
■ Automatic Operation
To open: Push the switch down firmly.
To close: Pull the switch up firmly.
The window opens or closes completely. To stop the window at any time, push or pull the switch briefly.
Manual Operation
■
To open: Push the switch down lightly.
To close: Pull the switch up lightly.
Release the switch when the window reaches the desired position.
On
Main Switch
Passenger’s Window Switch
Driver’s Window Switch Off
Main MenuTable of Contents

121
Controls
Adjusting the Seats Adjusting the Seat Position
Head Restraints
■
Your vehicle is equipped with head restraints in both seating positions. However, they are non-adjustable.Head restraints are effective for protection against whiplash and other rear-impact crash injuries.
Removing and Installing the Head Restraint for Cleaning
■
To remove the head restraint:
1. Unhook the strap on the outside edge of the seat-back.Pull out the strap throughout the band
2.
on the outside under edge of the head restraint.Push the release button, and pull the head
3.
restraint upward.
To install the head restraint: 1. Put the legs back in place, then slightly lower it.
Do not push it down fully until it locks
in place.
Insert the strap onto the band, then hook
2.
it to the magnet on the outside edge of the seat-back.Push the head restraint down until it locks.
3.
Make sure the head restraint locks in place when you reinstall it.
Head Restraints
The driver’s and passenger’s seats have active head restraints.
WARNING
Failure to reinstall the head restraints can result in severe injury during a crash. Always replace the head restraints before driving.
Band Strap
Release Button
Magnet
Main MenuTable of Contents

125
Controls
Interior Lights/Interior Convenience Items Interior Convenience Items
Interior Convenience Items
Glove Box
■
Pull the handle to open the glove box. You can keep beverage bottles and cans cool with the air conditioning system.
Push the lever forward to open the air vent
1.
in the glove box.Turn on the climate control system and
2.
adjust the temperature to cool.Set the mode control
3.
or .
The cool air is diverted through the air
vent.
Glove Box
The glove box light comes on when the parking lights are on. Use only resealable containers or keep unopened cans in the glove box.Spilled liquids can damage the upholstery and electrical components in the glove box and inside the dashboard. When the heater begins to divert warm air, the airlow into the glove box is shut off.
WARNING
An open glove box can cause serious injury to your passenger in a crash, even if the passenger is wearing the seat belt.
Always keep the glove box closed while driving.
Glove Box
Handle
Lever
Open
Close
Main MenuTable of Contents

128
Controls
Interior Lights/Interior Convenience Items Interior Convenience Items
Rear Cargo Console
■
Rear trays to store small items are located on the rear cargo console. To access the rear cargo console, open the door, slide the seat by pulling up on the bar, then pull up on the seat-back adjustment lever.
■Separator
Folding down the separator will create more cargo area.
Remove any items from the rear trays.
1.
Pull up the release handle on the top of
2.
the separator.
Trays
Rear Trays
Make sure all items on the rear trays are secured. They could be thrown around and cause injury during a crash. To return the separator upright, push it backwards until it locks. Make sure that the folded separator does not press against the passenger seat, as this could cause the weight sensors to work improperly.
Side Airbag Off Indicator P. 5 4
Make sure all items in the cargo area are secured. Loose items can ly forward if you have to brake hard.
WARNING
This vehicle is not equipped with rear seats or seatbelts. Sitting in this area may result in injury or death, and may violate state laws. Only the driver and one front seat passenger may be safely seated in this vehicle.
Bar
Seat-back
Adjustment Lever
Seat-back Adjustment Lever
Separator Release Handle
Main MenuTable of Contents

219
Driving
Braking
Brake System
Parking Brake
■
Use the parking brake to keep the vehicle stationary when parking.
To apply: Pull the lever fully up without pressing the release button. To release:
Pull the lever slightly, and press and hold
1.
the release button. Lower the lever down all the way, then
2.
release the button.
Parking Brake
NOTICE Release the parking brake fully before driving. The rear brakes and axle can be damaged if you drive with the parking brake applied. If you start driving without fully releasing the parking brake, a buzzer sounds as a warning, and "RELEASE PARKING BRAKE" appears on the multi-information display. Always apply the parking brake when parking.When the outside temperature is extremely cold, do not apply the parking brake to prevent it from freezing, and do the following:
Automatic transmission model Put the shift lever in , then place a block or other
wheel chock to stop the wheels from turning.
Manual transmission model Put the shift lever in or , then place a block
or other wheel chock to stop the wheels from turning.
Main MenuTable of Contents