2011 HONDA CR-Z headlights

118
Controls
Adjusting the Mirror
Interior Rearview Mirror
Adjust the angle of the rearview mirror when you are sitting in the correct driving posture.Rearview Mirror with Day and Night Positions

■
Flip the tab to switch the position. The night position will help to reduce the glare from headlights behind you when driving after dark.
Door Mirrors You can adjust the door mirrors when the ignition switch is in ON
II.
Mirror Position Adjustment
■
L/R selector switch: Select the left or right
mirror. After adjusting the mirror, return the switch to the center position. Mirror position adjustment switch: Press
the switch left, right, up, or down to move the mirror.
Adjusting the Mirror
Keep the inside and outside mirrors clean and adjusted for best visibility.Adjust the mirrors before you start driving.
Ta b
Adjustment Switch
Selector Switch
Main MenuTable of Contents

238
Maintenance
Before Performing Maintenance
Inspection and Maintenance
For your safety, perform all listed inspections and maintenance to keep your vehicle
in good condition. If you become aware of any abnormality (noise, smell, insufficient brake fluid, oil residue on the ground, etc.), have your vehicle inspected by a dealer. (Note, however, that service at a dealer is not mandatory to keep your warranties in effect.) Refer to the separate maintenance booklet for detailed maintenance and inspection information.Types of Inspection and Maintenance

■
Daily Inspections
■
Perform inspections before long distance trips, when washing the vehicle, or when refueling.
Periodic Inspections
■
Check the automatic transmission fluid level monthly.
•
Automatic Transmission Fluid P.254
Check the brake fluid level monthly.
•
Brake/Clutch Fluid P.256
Check the tire pressure monthly. Examine the tread for wear and foreign objects.
•
Checking and Maintaining Tires P.269
Check the operation of the headlights, parking lights, taillights, high-mount
•
brake light, and license plate lights monthly.
Replacing Light Bulbs P.258
Check the condition of the wiper blades at least every six months.
•
Checking and Maintaining Wiper Blades P.266
Inspection and Maintenance
U.S. models only Maintenance, replacement, or repair of emissions control devices and systems may be done by any automotive repair establishment or individual using parts that are "certiied" to EPA standards. According to state and federal regulations, failure to perform maintenance on the items marked with # will not void your emissions warranties. However, all maintenance services should be performed in accordance with the intervals indicated by the multi-information display.
Maintenance Service Items P. 2 4 3
If you want to perform complex maintenance tasks that require more skills and tools, purchase the service manual.
Authorized Manuals P. 3 1 9
If you want to perform maintenance yourself, make sure that you have the necessary tools and skills irst.After performing maintenance, complete the records in the separate maintenance booklet.
Main MenuTable of Contents

258
Maintenance
Replacing Light Bulbs
Headlight Bulbs
When replacing, use the following bulbs.
High beam headlight: 60W (HB3)
Low beam headlight: 55W (H11 for halogen bulb type)
35W (D4S for high voltage discharge)High Beam Headlight

■
1. Remove the cover.
2. Remove the coupler.
It can be removed by pushing the tab.
Rotate the old bulb to the left to remove.
3.
Insert a new bulb into the headlight
4.
assembly and turn it to the right.
Insert the coupler into the connector of the
5.
bulb.
Headlight Bulbs
NOTICE Halogen bulbs get very hot when lit. Oil, perspiration, or a scratch on the glass can cause the bulb to overheat and shatter.
NOTICE The headlight aim is set by the factory, and typically does not need to be adjusted. However, if you regularly carry heavy items in the cargo area, have the aiming readjusted by a dealer or another qualiied technician. The HB3 and H11 types are halogen bulbs. When replacing a bulb, handle it by its base, and protect the glass from contact with your skin or hard objects. If you touch the glass, clean it with denatured alcohol and a clean cloth. The exterior lights’ inside lenses (headlights, brake lights, etc.) may fog temporarily after a vehicle wash or while driving in the rain. This does not impact the exterior light function.However, if you see a large amount of water or ice accumulated inside the lenses, have your vehicle inspected by a dealer.
Cover
Bulb
TabCoupler
Main MenuTable of Contents

259
Maintenance
Replacing Light Bulbs Headlight Bulbs
Low Beam Headlights (High Voltage Discharge Type)
■*
Ask a dealer to inspect and replace low beam headlights.
Low Beam Headlights (Halogen Headlights)

■*
1. Remove the coupler.
It can be removed by pushing the tab.
Rotate the old bulb to the left to remove.
2.
Insert a new bulb into the headlight
3.
assembly and turn it to the right.
Insert the coupler into the connector of the
4.
bulb.Bulb
Tab
Coupler
*Not available on all models
Main MenuTable of Contents

305
Handling the Unexpected
Fuses Fuse Locations
Interior Fuse Box
■
Located under the driver side dashboard.
Circuit Protected and Amps for Each Fuse
■
Fuse Locations
Fuse locations are shown on the label on the back side of the cover.
Locate the fuse in question by the fuse number and label number.
Label
Fuse BoxCover
Circuit Protected Amps
1 Back Up 15 A
2 TPMS* 1
7.5 A
3 Driver’s Power Window 20 A
4 - -
5 Back-Up Light 10 A
6 SRS 10 A
7 Transmission* 2
10 A
8 SRS 7.5 A
9 Fog Light* 20 A
10 A/C 7.5 A
11 ABS/VSA ®
7.5 A
12 IMA 10 ACircuit Protected Amps
13 Accessory Power Socket 20 A
14 Radio 7.5 A
15 Daytime Running Lights 7.5 A
16 Rear Wiper 10 A17 Passenger’s Power Window 20 A
18 - -
19 - -
20 Fuel Pump 15 A
21 Washer 15 A
22 Meter 7.5 A
23 Hazard 10 A
24 Stop/Horn 10 ACircuit Protected Amps
25 Audio AMP* 20 A
26 LAF 10 A
27 Door Lock Main 20 A
28 Headlight Main 20 A
29 Small Light 10 A
30 Main Fan Motor 30 A
31 IGPS 7.5 A
32 Right Headlight Low* 3
Right Headlight Low (HID)* 410 A 15 A
*1: U.S. models only *2: Automatic transmission (CVT)*3: Vehicle with halogen bulb low beam headlights*4: Vehicle with discharge headlights
continued
* Not available on all models
Main MenuTable of Contents

306
Handling the Unexpected
Fuses Fuse Locations
Circuit Protected and Amps for Each Fuse
■
Circuit Protected Amps
33 Ignition Coil 15 A 34 Left Headlight Low*
1
Left Headlight High* 210 A 10 A
35 Door Lock 7.5 A
36 Door Lock 10 A
37 ABS FSR/VSA ®
FSR 30 A
38 - -
39 IGP 15 A
40 - -
41 - -
42 IMA 1 7.5 A
43 MG Clutch 7.5 A
44 STS 7.5 A
45 Door Lock 20 A
46 - -
47 Sub Fan Motor 30 A 48 Left Headlight High*
1
Left Headlight Low (HID)* 210 A 15 A
49 Door Lock Motor 2
(UNLOCK) 7.5 A
50 - -
51 Right Headlight High 10 A
52 DBW 15 A
53 IMA 2 15 A
54 - -Circuit Protected Amps
55 Heated Mirror* 10 A
56 Front Wiper 30 A
57 Blower Motor 30 A
58 ABS/VSA ®
MTR 30 A
59 Rear Defogger 40 A*
3
30 A* 4
60 IG Main 50 A
61 - -
62 - -
*1: Vehicle with halogen bulb low beam headlights *2: Vehicle with discharge headlights*3: With heated door mirror*4: Without heated door mirror
* Not available on all models
Main MenuTable of Contents

307
Handling the Unexpected
Fuses Inspecting and Changing Fuses
Inspecting and Changing Fuses1. Turn the ignition switch to LOCK
0. Turn
headlights and all accessories off. Check the fuses in the engine
2.
compartment.
If the fuse is blown, have it replaced by a dealer.
3. Inspect the small fuses in the vehicle interior.
If there is a burned out fuse, remove it
with the fuse puller and replace it with a new one.
Fuse
Blown
Inspecting and Changing Fuses
NOTICE Replacing a fuse with one that has a higher rating greatly increases the chances of damaging the electrical system. If you do not have a replacement fuse with the proper rating for the circuit, install one with a lower rating. Replace fuse with a spare fuse of the same speciied amperage.Conirm the speciied amperage using the charts on P.304 to P.306. There is a fuse puller on the interior fuse box.
Fuse Puller
Main MenuTable of Contents

312
Information
Speciications
Vehicle Specifications
■
Model Honda CR-Z No. of Passengers:
Front RearTotal 2–2
Weights: Gross Vehicle Weight Rating U.S.: 3,164 lbs (1,435 kg)Canada: 1,435 kg
Gross Axle Weight Rating (Front) U.S.: 1,797 lbs (815 kg)Canada: 815 kg
Gross Axle Weight Rating (Rear) U.S.: 1,378 lbs (625 kg)Canada: 625 kg
Air Conditioning: Refrigerant TypeCharge QuantityLubricant Type HFC-134a (R-134a)15.8 – 17.6 oz (450 – 500 g)SP-10
Engine Specifications
■
Displacement 91 cu-in (1,497 cm 3
)
Spark Plugs NGK DIFR6A13G
DENSO DK20PR-D13
Fuel
■
Fuel: Type Unleaded gasoline, Pump octane number of 87 or higher
Fuel Tank Capacity 10.6 US gal (40 ℓ)
12 Volt Battery
■
Capacity/Type 32AH(5)/40AH(20) 34AH(5)/40AH(20)
Washer Fluid
■
Tank Capacity U.S.: 2.6 US qt (2.5 ℓ) Canada: 4.8 US qt (4.5 ℓ)
Light Bulbs
■
Headlights (Low Beam) 35W (D4S)*
1
55W (H11)* 2
Headlights (High Beam) 60W (HB3)
Fog Lights* 55W (H11)Front Turn Signal/Parking/ Side Marker Lights 28W/8W
Side Turn Signal Lights(on Door Mirrors) LED
Brake/Taillights LED
Rear Turn Signal Lights 21W (Amber)
Back-Up Lights 16W
Rear Side Marker Lights 3CP
High-Mount Brake Light LED
License Plate Lights 5W
Cargo Area Light 5WInterior Lights
Front
Rear 8W3.4W
Vanity Mirror Lights* 2W
Glove Box Light 1.4W
Courtesy Lights 2CP (3.8W)
*1: Vehicle with discharge headlights
*2: Vehicle with halogen bulb low beam headlights
* Not available on all models
Main MenuTable of Contents