2011 HONDA CIVIC COUPE flat tire

[x] Cancel search: flat tire

Page 67 of 400

HONDA CIVIC COUPE 2011 8.G Owners Manual This indicator normally comes on f or 
a f ew seconds when you turn the
ignition switch to the ON (II)
position. If it comes on while driving,
it indicates that one or more of your
vehicle’s tires a

Page 289 of 400

HONDA CIVIC COUPE 2011 8.G Owners Manual For example, if you check and f ill 
your tires in a warm area, then drive
in extremely cold weather, the tire
pressure will be lower than
measured and could be underinf lated
and cause the low tire p

Page 290 of 400

HONDA CIVIC COUPE 2011 8.G Owners Manual As required by the FCC:This device complies with Part 15 of theFCC rules. Operation is subject to the
f ollowing two conditions: (1) This devicemay not cause harmf ul interf erence, and(2) this device

Page 327 of 400

HONDA CIVIC COUPE 2011 8.G Owners Manual Keeping the tires properly inf lated 
provides the best combination of
handling, tread lif e, and riding
comf ort.Underinf lated tires wear unevenly,
adversely affect handling and fuel
economy, and ar

Page 341 of 400

HONDA CIVIC COUPE 2011 8.G Owners Manual This section covers the more 
common problems that motorists
experience with their vehicles. It
gives you inf ormation about how to
safely evaluate the problem and what
to do to correct it. If the pro

Page 342 of 400

HONDA CIVIC COUPE 2011 8.G Owners Manual Use the compact spare tire as a 
temporary replacement only. Get
your regular tire repaired or replaced,
and put it back on your vehicle as
soon as you can. 
Check the air pressure of the 
compact spa

Page 343 of 400

HONDA CIVIC COUPE 2011 8.G Owners Manual CONT INUED
If you have a f lat tire while driving, 
pull over saf ely. Drive slowly along
the shoulder until you get to an area
far away from traffic lanes.Turn on the hazard warning lights,
and turn

Page 344 of 400

HONDA CIVIC COUPE 2011 8.G Owners Manual Placethejackunderthejacking 
point nearest the tire you need to
change. Turn the end bracket
clockwise until the top of the jack
contacts the jacking point. Make
sure the jacking point tab is
restingi
Page:   1-8 9-16 next >