Airbags must be allowed to fully deploy without restriction. The
deployment of airbags is not compatible with any configuration of police
equipment mounting that places objects in the airbag deployment path.
Equipment mounted or placed in the deployment path area of an airbag
will reduce the effectiveness of the airbag, damage the airbag and
potentially damage or dislodge the equipment. Further such items could
become projectiles in the event of an airbag deployment.
WARNING:Always use safety belts with the airbag
supplemental restraint system.
There are four very important reasons to always use seat belts with the
airbag system. Safety belts:
•help restrain the occupant to increase the effectiveness of the airbag
when it inflates.
•reduce the risk of injury in rollover, side or rear impact accidents for
which airbags are not designed to inflate.
•reduce the risk of injury in frontal collisions that are not severe
enough to activate the airbag.
•reduce the risk of passengers being thrown from the vehicle.
SOME COMMON POLICE QUESTIONS AND ANSWERS ABOUT
AIRBAGS
Will there be any way to special order police vehicles without the
airbag systems?
No. Based on the federal law (FMVSS #208), after August 31, 1993, the
Original Equipment Manufacturers (OEMs) will not be able to sell
passenger cars that do not contain passive restraint systems.
Can the installation of push bumpers on the front end of the
vehicle affect the deployment of an airbag?
Different push bumper designs may each have different deformation
characteristics in a crash situation that may or may not affect the
deployment of airbags. Without the benefit of crash tests on vehicles
equipped with push bumpers (there are a number of different styles
available), it is Ford’s opinion that installation of some push bumpers
could affect the timing of the airbag deployment. Use of a push bumper
that mounts solely to the vehicles bumper should not have a significant
effect upon airbag deployment.
Crown Victoria Severe Duty
298
2011 Crown Victoria(cro)
Owners Guide, 3rd Printing
USA(fus)
Every 15,000 miles
(24,000 km)Replace cabin air filter (if equipped)
Every 30,000 miles
(48,000 km)Replace climate-controlled seat filter (if
equipped)
Replace engine air filter
Replace fuel filter (Crown Victoria, Grand
Marquis and Town Car)
Every 105,000 miles
(168,000 km)Change engine coolant
1
Replace spark plugs
Inspect accessory drive belt(s)2
Every 150,000 miles
(240,000 km)Change automatic transmission fluid and filter
(filter not required on 6F35, 6F50, DPS6 and
AWF-21 transmissions); consult dealer for
requirements
Change manual transmission fluid
Change rear axle fluid (RWD vehicles)
Replace accessory drive belt(s) if not replaced
within the last 100,000 miles (160,000 km)
Replace timing belt (Fiesta);failure to replace
belt can cause internal engine damage
1Initial replacement at 105,000 miles (168,000 km) or 72 months; every
45,000 miles (72,000 km) or 36 months thereafter
2Perform a follow-up inspection at 120,000 miles (192,000 km)
Scheduled Maintenance
314
2011 Crown Victoria(cro)
Owners Guide, 3rd Printing
USA(fus)
