2011 DODGE NITRO lock

CAUTION!
•Do not attempt to use sling type equipment when
towing. When securing the vehicle to a flat bed
truck, do not attach to front or rear suspension
components. Damage to your vehicle may result
from improper towing.
•If the vehicle being towed requires steering, the
ignition must be in the ON/RUN or ACC position,
not in the LOCK position.
Towing Without The Ignition Key Fob
Special care must be taken when the vehicle is towed
with the ignition in the LOCK position. The only ap-
proved method of towing without the ignition key is
with a flatbed truck. Proper towing equipment is neces-
sary to prevent damage to the vehicle.
Two-Wheel Drive Models
The manufacturer recommends towing your vehicle with
all four wheelsOFFthe ground using a flatbed.
If flatbed equipment is not available, and the transmis-
sion is operable, the vehicle may be towed (with rear
wheels on the ground) with the transmission in NEU-
TRAL. Speed must not exceed 30 mph (48 km/h) and the
distance must not exceed 15 miles (24 km).
CAUTION!
Towing faster than 30 mph (48 km/h) or farther than
15 miles (24 km) with rear wheels on the ground can
cause severe damage to the transmission. Such dam-
age is not covered by the New Vehicle Limited
Warranty.
If the transmission is not operable, or the vehicle must be
towed faster than 30 mph (48 km/h) or farther than
396 WHAT TO DO IN EMERGENCIES

15 miles (24 km), tow with the rear wheelsOFFthe
ground (on a flatbed, or with the rear wheels raised using
a wheel lift or towing dolly), or remove the driveshaft.
WARNING!
If the driveshaft is removed, the vehicle can roll even
if the transmission is in PARK, which could cause
serious injury or death.
The parking brake mustbe firmly engaged and the
wheels chocked during driveshaft removal and installa-
tion. The parking brake must remainengaged unless the
vehicle is securely and properly connected to the tow
vehicle, or the driveshaft is completely reinstalled. See
your authorized dealer for proper driveshaft removal
and reinstallation procedures, including flange
orientation/alignment, use of thread-locking compound,
proper bolt torque specifications, etc.
Four-Wheel Drive Vehicles
The manufacturer requires towing with all wheels OFF
the ground. Acceptable methods are to tow the vehicle on
a flatbed or with one end of vehicle raised and the
opposite end on a towing dolly.
CAUTION!
•Front or rear wheel lifts should not be used.
Internal damage to the transmission or transfer
case will occur if a front or rear wheel lift is used
when towing.
•Failure to follow these towing methods could
result in damage to the transmission and/or trans-
fer case. Such damage is not covered by the New
Vehicle Limited Warranty.6
WHAT TO DO IN EMERGENCIES 397

WARNING!
•Use only refrigerants and compressor lubricants
approved by the manufacturer for your air condi-
tioning system. Some unapproved refrigerants are
flammable and can explode, injuring you. Other
unapproved refrigerants or lubricants can cause
the system to fail, requiring costly repairs. Refer to
Warranty Information Book, located on the DVD,
for further warranty information.
•The air conditioning system contains refrigerant
under high pressure. To avoid risk of personal
injury or damage to the system, adding refrigerant
or any repair requiring lines to be disconnected
should be done by an experienced repairman.
Refrigerant Recovery And Recycling
R-134a air conditioning refrigerant is a hydrofluoro-
carbon (HFC) that is endorsed by the EnvironmentalProtection Agency and is an ozone-saving product. How-
ever, the manufacturer recommends that air conditioning
service be performed by authorized dealers or other
service facilities using recovery and recycling equipment.
NOTE:
Use only manufacturer approved A/C system
sealers, stop leak products, seal conditioners, compressor
oil, and refrigerants.
Body Lubrication
Locks and all body pivot points, including such items as
seat tracks, door hinge pivot points and rollers, liftgate,
tailgate, sliding doors and hood hinges, should be lubri-
cated periodically with a lithium based grease, such as
MOPAR Spray White Lube or equivalent, to assure
quiet, easy operation and to protect against rust and
wear. Prior to the application of any lubricant, the parts
concerned should be wiped clean to remove dust and
grit; after lubricating excess oil and grease should be
removed. Particular attention should also be given to
7
MAINTAINING YOUR VEHICLE 413

hood latching components to ensure proper function.
When performing other underhood services, the hood
latch, release mechanism and safety catch should be
cleaned and lubricated.
The external lock cylinders should be lubricated twice a
year, preferably in the Fall and Spring. Apply a small
amount of a high quality lubricant, such as MOPAR
Lock Cylinder Lubricant or equivalent, directly into the
lock cylinder.
Windshield Wiper Blades
Clean the rubber edges of the wiper blades and the
windshield periodically with a sponge or soft cloth and a
mild non-abrasive cleaner. This will remove accumula-
tions of salt or road film.
Operation of the wipers on dry glass for long periods
may cause deterioration of the wiper blades. Always use
washer fluid when using the wipers to remove salt or dirt
from a dry windshield. Avoid using the wiper blades to remove frost or ice from
the windshield. Keep the blade rubber out of contact with
petroleum products such as engine oil, gasoline, etc.
NOTE:
Life expectancy of wiper blades varies depend-
ing on geographical area and frequency of use. Poor
performance of blades may be present with chattering,
marks, water lines or wet spots. If any condition is
present please proceed to clean wiper blades with humid
cloth removing any debris that may be affecting its
function.Adding Washer Fluid
The fluid reservoir in the engine compartment should be
checked for fluid level at regular intervals. Fill the
reservoir with windshield washer solvent/antifreeze (not
radiator antifreeze). Operate the system for a few seconds
to flush out the residual water.
414 MAINTAINING YOUR VEHICLE

Cavity CartridgeFuseMini-
Fuse Description
J4 25 Amp Natural Driver Door Node
J5 25 Amp Natural Passenger Door Node
J6 40 Amp Green Antilock Brakes
Pump, Stability
Control System
J7 30 Amp Pink Antilock Brakes
Valve, Stability
Control System
J8 40 Amp Green Power Seat – If
Equipped
J9 — —
J10 — —
J11 30 Amp Pink Anti–Theft Module
Lock-UnlockCavity Cartridge
FuseMini-
Fuse Description
J12 — —
J13 60 Amp Yellow Ignition Off Draw –
Main
J14 40 Amp Green Rear Defroster
J15 40 Amp Green Front Blower
J17 40 Amp Green Starter Solenoid
J18 20 Amp Blue Powertrain Control
Module
J19 60 Amp Yellow Radiator Fan
J20 30 Amp Pink Front Wiper
7
MAINTAINING YOUR VEHICLE 433

Cavity CartridgeFuseMini-
Fuse Description
J21 20 Amp Blue Front/Rear Washer
J22 25 Amp Natural Sunroof Module – If
Equipped
M1 15 Amp
Blue Rear Center Brake
Lamp, Brake Switch
M2 20 Amp
Yellow Trailer Lighting
M3 20 Amp
Yellow Frt/Rear Axle Lockers
M4 10 Amp
Red Trailer Tow
M5 25 Amp
Natural 115V AC Inverter – If
Equipped
M6 20 Amp
Yellow Rain Sensor – If
EquippedCavity Cartridge
FuseMini-
Fuse Description
M7 20 Amp
Yellow Cigar Lighter
M8 20 Amp
Yellow Front Heated Seat – If
Equipped
M9 — —
M10 15 Amp
Blue Ignition Off Draw –
Video System, Satel-
lite Radio, DVD,
Hands-Free Module,
Antenna, Universal
Garage Door Opener,
Vanity Lamp
M11 10 Amp
Red Ignition Off Draw –
Climate Control Sys-
tem, MW SENSR, Un-
derhood Lamp
434 MAINTAINING YOUR VEHICLE

Cavity CartridgeFuseMini-
Fuse Description
M21 20 Amp
Yellow Automatic Shutdown
#3
M22 10 Amp
Red Right Horn
M23 10 Amp
Red Left Horn
M24 25 Amp
Natural Rear Wiper – If
Equipped
M25 20 Amp
Yellow Fuel Pump, Diesel
Lift Pump – If
Equipped
M26 10 Amp
Red Power Mirror Switch,
Driver Window
SwitchCavity Cartridge
FuseMini-
Fuse Description
M27 10 Amp
Red Ignition Switch, Wire-
less Control Module,
Steering Column Lock
– If Equipped
M28 10 Amp
Red Powertrain Control
Module
M29 10 Amp
Red Occupant Classifica-
tion Module
M30 15 Amp
Blue Rear Wiper Module,
Power Folding Mirror
– If Equipped, Diag-
nostic Link
M31 20 Amp
Yellow Back-Up Lamps
M32 10 Amp
Red Airbag Module
436 MAINTAINING YOUR VEHICLE

Cavity CartridgeFuseMini-
Fuse Description
M33 10 Amp
Red Powertrain Control
Module
M34 10 Amp
Red Park Assist/Rear
Camera, Climate Con-
trol System Module,
Headlamp Wash,
Compass, IR Sensor,
Relay Diesel Cabin
Heater, Radiator Fan
Diesel – If Equipped
M35 10 Amp
Red Heated Mirrors – If
Equipped
M36 — —Cavity Cartridge
FuseMini-
Fuse Description
M37 10 Amp
Red Antilock Brakes, Sta-
bility Control System,
Stop Lamp Switch,
Fuel Pump Relay
M38 25 Amp
Natural Door and Liftgate
Lock/Unlock Motors
CAUTION!
•When installing the integrated power module
cover, it is important to ensure the cover is prop-
erly positioned and fully latched. Failure to do so
may allow water to get into the integrated power
module, and possibly result in a electrical system
failure.
(Continued)
7
MAINTAINING YOUR VEHICLE 437