2011 DODGE JOURNEY key battery

Because air bag sensors estimate deceleration over time,
vehicle speed and damage are not good indicators of
whether or not an air bag should have deployed.
NOTE:In a rollover the pretensioners and/or SAB and
SABIC air bags may deploy on both sides of the vehicle.
Front And Side Impact Sensors
In front and side impacts, impact sensors can aid the
ORC in determining appropriate response to impact
events.
Enhanced Accident Response System
In the event of an impact causing air bag deployment, if
the communication network remains intact, and the
power remains intact, depending on the nature of the
event the ORC will determine whether to have the
Enhanced Accident Response System perform the follow-
ing functions:
•Cut off fuel to the engine.
•Flash hazard lights as long as the battery has power or
until the ignition is cycled to off.
•Turn on the interior lights, which remain on as long as
the battery has power or until the ignition key is
removed.
•Unlock the doors automatically.
If A Deployment Occurs
The Advanced Front Air Bags are designed to deflate
immediately after deployment.
NOTE: Front and/or side air bags will not deploy in all
collisions. This does not mean something is wrong with
the air bag system.
If you do have a collision which deploys the air bags, any
or all of the following may occur:
•The nylon air bag material may sometimes cause
abrasions and/or skin reddening to the driver and
2
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 71

Join Calls
When two calls are in progress (one active and one on
hold), touch the “Join Calls” soft-key on the Phone main
screen to combine all calls into a Conference Call.
Call Termination
To end a call in progress, momentarily press the End
soft-key or the
button. Only the active call(s) will be
terminated and if there is a call on hold, it will become
the new active call. If the active call is terminated by the
far end, a call on hold may not become active automati-
cally. This is cell phone-dependent.
Redial
•
Press the “Redial” soft-key,
•or press thebutton and after the “Listening”
prompt and the following beep, say “Redial”,
•After the “Listening” prompt and the following beep,
say “Redial”,
•The Uconnect™ Phone will call the last number that
was dialed from your mobile phone.
Call Continuation
Call continuation is the progression of a phone call on the
Uconnect™ Phone after the vehicle ignition key has been
switched to OFF.
•After the ignition key is switched to OFF, a call can
continue on the Uconnect™ Phone either until the call
ends, or until the vehicle battery condition dictates
cessation of the call on the Uconnect™ Phone and
transfer of the call to the mobile phone.
Uconnect™ Phone Features
Emergency Assistance
If you are in an emergency and the mobile phone is
reachable:
•Pick up the phone and manually dial the emergency
number for your area.
118 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

•Touch the “Display” soft-key, then scroll down to
Voice Response Length,
•Select either “Brief” or “Detailed” by touching the box
next to the selection. A check-mark will appear to
show your selection.
Phone And Network Status Indicators
Uconnect™ Phone will provide notification to inform
you of your phone and network status when you are
attempting to make a phone call using Uconnect™
Phone. The status is given for roaming, network signal
strength and phone battery strength.
Dialing Using The Mobile Phone Keypad
You can dial a phone number with your mobile phone
keypad and still use the Uconnect™ Phone (while dialing
via the mobile phone keypad, the user must exercise
caution and take precautionary safety measures). By
dialing a number with your paired Bluetoothmobile
phone, the audio will be played through your vehicle’s audio system. The Uconnect™ Phone will work the same
as if you dial the number using voice command.
NOTE:
Certain brands of mobile phones do not send the
dial ring to the Uconnect™ Phone to play it on the vehicle
audio system, so you will not hear it. Under this situa-
tion, after successfully dialing a number the user may feel
that the call did not go through even though the call is in
progress. Once your call is answered, you will hear the
audio.
Mute/Un-Mute (Mute OFF)
When you mute the Uconnect™ Phone, you will still be
able to hear the conversation coming from the other
party, but the other party will not be able to hear you. In
order to mute the Uconnect™ Phone simply touch the
“Mute” button on the Phone main screen.
122 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

•Pauses, wait or other characters that are supported by
some phones are not supported over Bluetooth.
These additional symbols will be ignored in the dial-
ing a numbered sequence.
Barge In — Overriding Prompts
Thebutton can be used when you wish to skip
part of a prompt and issue your voice command imme-
diately. For example, if a prompt is asking “There are 2
numbers with the name John. Say the full name” you
could press the
button and say, “John Smith” to
select that option without having to listen to the rest of
the voice prompt.
Voice Response Length
It is possible for you to choose between Brief and
Detailed Voice Response Length.
•Touch the “More” soft-key, then touch the “Settings”
soft-key,
•Touch the “Display” soft-key, then scroll down to
Voice Response Length,
•Select either “Brief” or “Detailed” by touching the box
next to the selection. A check-mark will appear to
show your selection.
Phone And Network Status Indicators
Uconnect™ Phone will provide notification to inform
you of your phone and network status when you are
attempting to make a phone call using Uconnect™
Phone. The status is given for network signal strength
and phone battery strength.
Dialing Using The Mobile Phone Keypad
You can dial a phone number with your mobile phone
keypad and still use the Uconnect™ Phone (while dialing
via the mobile phone keypad, the user must exercise
caution and take precautionary safety measures). By
dialing a number with your paired Bluetooth mobile
phone, the audio will be played through your vehicle’s
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 149

A loose, improperly installed, or damaged fuel filler cap
may also turn on the MIL.
EMISSIONS INSPECTION AND MAINTENANCE
PROGRAMS
In some localities, it may be a legal requirement to pass
an inspection of your vehicle’s emissions control system.
Failure to pass could prevent vehicle registration.For states that require an Inspection and Mainte-
nance (I/M), this check verifies the “Malfunction
Indicator Light (MIL)” is functioning and is not
on when the engine is running, and that the OBD II
system is ready for testing.
Normally, the OBD II system will be ready. The OBD II
system may notbe ready if your vehicle was recently
serviced, recently had a dead battery or a battery replace-
ment. If the OBD II system should be determined not
ready for the I/M test, your vehicle may fail the test. Your vehicle has a simple ignition key-actuated test,
which you can use prior to going to the test station. To
check if your vehicle’s OBD II system is ready, you must
do the following:
1. Turn the ignition switch to the ON position, but do not
crank or start the engine.
2. If you crank or start the engine, you will have to start
this test over.
3. As soon as you turn the ignition switch to the ON
position, you will see the MIL symbol come on as part of
a normal bulb check.
4. Approximately 15 seconds later, one of two things will
happen:
a. The MIL will flash for about 10 seconds and then
return to being fully illuminated until you turn OFF
454 MAINTAINING YOUR VEHICLE

Automatic Oil Change Indicator............. 275
Automatic Temperature Control (ATC) ......... 319
Automatic Transaxle ................... 338,480
Adding Fluid .................. 481,482,505
Filter ............................. 482
Fluid and Filter Changes ............... 482
Fluid Level Check ................. 481,482
Interlock System ..................... 339
Reset Mode ......................... 342
Selection Of Lubricant ................. 505
Shifting ........................... 338
Special Additives ..................... 480
Autostick ............................. 343
Auxiliary Electrical Outlet (Power Outlet) ...... 230
Auxiliary Power Outlet ................... 230
B-Pillar Location ........................ 367
Back-Up Lights ......................... 499 Battery
............................... 461
Keyless Transmitter Replacement (RKE) ..... 24
Location ........................... 461
Belts, Seat ............................ 46,91
Body Mechanism Lubrication ............... 466
Booster Seat ............................ 77
Brake Assist System ...................... 356
Brake Control System, Electronic ............. 354
Brake Fluid ............................ 505
Brake System ........................ 352,478
Anti-Lock (ABS) .................. 353,354
Fluid Check ..................... 478,505
Master Cylinder ..................... 478
Parking ........................... 350
Warning Light ....................... 264
Brake, Parking .......................... 350
Brake/Transaxle Interlock .................. 339
Brakes ............................. 352,478
Break-In Recommendations, New Vehicle ........ 88
10
INDEX 533

TransaxleAdditives .......................... 480
Automatic ....................... 338,480
Autostick .......................... 343
Filter ............................. 482
Maintenance ........................ 480
Operation .......................... 338
Overdrive .......................... 342
Selection of Lubricant ................. 505
Transmission ........................... 338
Transmitter Battery Service
(Remote Keyless Entry) .................... 24
Transmitter Programming
(Remote Keyless Entry) .................... 21
Transmitter, Garage Door Opener (HomeLink®) . . 220
Transmitter, Remote Keyless Entry (RKE) ........ 21
Transporting Pets ........................ 88
Tread Wear Indicators .................... 378
Trip Odometer .......................... 261 Turn Signals
...................... 195,261,499
UCI Connector ......................... 308
Underhood Fuses ........................ 492
Uniform Tire Quality Grades ................ 529
Universal Consumer Interface (UCI) Connector . . . 308
Universal Transmitter ..................... 220
Unleaded Gasoline ....................... 393
Untwisting Procedure, Seat Belt .............. 51
Upholstery Care ........................ 487
Vanity Mirrors .......................... 104
Vehicle Certification Label ................. 403
Vehicle Identification Number (VIN) ............ 6
Vehicle Loading ................... 368,403,405
Vehicle Modifications/Alterations .............. 7
Vehicle Storage ....................... 325,495
Vehicle Theft Alarm (Security Alarm) .......... 17
552 INDEX