2011 DODGE DURANGO brake light

6. Shift the transmission into NEUTRAL.
7. Press and hold the transfer case NEUTRAL button
(located by the selector switch). The NEUTRAL indicator
light will blink while the shift is in progress. The light
will stop blinking (stay on solid) when the shift to
NEUTRAL is complete.8. After the shift is completed and the NEUTRAL light
stays on, release the NEUTRAL button.
9. Start the engine.
10. Shift the transmission into REVERSE.
11. Release the brake pedal for five seconds and ensure
that there is no vehicle movement.
12. Repeat steps 9 and 10 with transmission in DRIVE.
13. Turn OFF the engine.
14. Firmly apply the parking brake.
15. Shift the transmission into PARK.
NEUTRAL Switch
5
STARTING AND OPERATING 443

CAUTION!
Damage to the transmission may occur if the trans-
mission is shifted into PARK with the transfer case in
NEUTRAL and the engine running. With the transfer
case in NEUTRAL, ensure that the engine is OFF
prior to shifting the transmission into PARK.
16. Remove the key fob from the ignition switch.
17. Attach the vehicle to the tow vehicle using a suitable
tow bar.
18. Release the parking brake.
NOTE:
•Steps 1 through 6 are requirements that must be met
prior to pressing the NEUTRAL button, and must
continue to be met until the shift has been completed.
If any of these requirements are not met prior to
pressing the NEUTRAL button or are no longer met during the shift, the NEUTRAL indicator light will
flash continuously until all requirements are met or
until the NEUTRAL button is released.
•The ignition switch must be in the ON/RUN position
for a shift to take place and for the position indicator
lights to be operable. If the ignition switch is not in the
ON/RUN position, the shift will not take place and no
position indicator lights will be on or flashing.
•A flashing NEUTRAL indicator light indicates that
shift requirements have not been met.
Shifting Out Of Neutral
Use the following procedure to prepare your vehicle for
normal usage:
1. Bring the vehicle to a complete stop, leaving it con-
nected to the tow vehicle.
2. Firmly apply the parking brake.
444 STARTING AND OPERATING

3. Insert the key fob into the ignition switch and turn it to
the ON/RUN position, but do not start the engine.
4. Press and hold the brake pedal.
5. Shift the transmission into NEUTRAL.
6. Press and hold the transfer case NEUTRAL button
(located by the selector switch) until the NEUTRAL
indicator light turns off.7. After the NEUTRAL indicator light turns off, release
the NEUTRAL button.
8. After the NEUTRAL button has been released, the
transfer case will shift to the position identified by the
selector switch.
NEUTRAL Switch
5
STARTING AND OPERATING 445

NOTE:When shifting out of transfer case NEUTRAL,
turning the engine OFF may be required to avoid gear
clash.
9. Shift transmission into PARK.
10. Release the brake pedal.
11. Disconnect vehicle from the tow vehicle.
12. Start the engine.
13. Press and hold the brake pedal.
14. Release the parking brake.
15. Shift the transmission into gear, and check that the
vehicle operates normally.
16. The Keyless Enter-N-Go button (if equipped) may
now be reinstalled if desired. Refer to “Starting
Procedures/Keyless Enter-N-Go” in “Starting and Oper-
ating” for further information. NOTE:
•Steps 1 through 5 are requirements that must be met
prior to pressing the transfer case NEUTRAL button
and must continue to be met until the shift has been
completed. If any of these requirements are not met
prior to pressing the NEUTRAL button, or are no
longer met during the shift, the NEUTRAL indicator
light will flash continuously until all requirements are
met or until the NEUTRAL button is released.
•The ignition switch must be in the ON/RUN position
for a transfer case shift to take place and for the
position indicator lights to be operable. If the ignition
switch is not in the ON/RUN position, the shift will
not take place and no position indicator lights will be
on or flashing.
•A flashing NEUTRAL position indicator light indicates
that shift requirements have not been met.
446 STARTING AND OPERATING

6. Remove the dipstick again, and note the fluid level on
both sides. The fluid level should be between the “HOT”
(upper) reference holes on the dipstick at normal operat-
ing temperature. The fluid level is only valid if there is a
solid coating of oil on both sides of the dipstick. If the
fluid is low, add as required into the dipstick tube.Do
not overfill. After adding any quantity of oil through the
oil fill tube, wait a minimum of two minutes for the oil to
fully drain into the transmission before rechecking the
fluid level.
NOTE: If it is necessary to check the transmission below
the operating temperature, the fluid level should be
between the two “COLD” (lower) holes on the dipstick
with the fluid at approximately 70°F (21°C) (room tem-
perature). If the fluid level is correctly established at
room temperature, it should be between the “HOT”
(upper) reference holes when the transmission reaches
180°F (82°C). Remember it is best to check the level at the
normal operating temperature.CAUTION!
Be aware that if the fluid temperature is below 50°F
(10°C) it may not register on the dipstick. Do not add
fluid until the temperature is elevated enough to
produce an accurate reading.
7. Check for leaks. Release parking brake.
To prevent dirt and water from entering the transmission
after checking or replenishing fluid, make certain that the
dipstick cap is properly reseated. It is normal for the
dipstick cap to spring back slightly from its fully seated
position, as long as its seal remains engaged in the
dipstick tube.
Appearance Care And Protection From Corrosion
Protection Of Body And Paint From Corrosion
Vehicle body care requirements vary according to geo-
graphic locations and usage. Chemicals that make roads
506 MAINTAINING YOUR VEHICLE

referring to the steps described under “Electronic Vehicle
Information Center (EVIC)/Oil Change Required” in
“Understanding Your Instrument Panel” for further in-
formation.
At Each Stop For Fuel
•Check the engine oil level about five minutes after a
fully warmed engine is shut off. Checking the oil level
while the vehicle is on level ground will improve the
accuracy of the oil level reading. Add oil only when
the level is at or below the ADD or MIN mark.
•Check the windshield washer solvent and add if
required.
Once A Month
•Check tire pressure and look for unusual wear or
damage.
•Inspect the battery and clean and tighten the terminals
as required.
•Check the fluid levels of the coolant reservoir, brake
master cylinder, power steering and transmission
(5.7L only) and add as needed.
•Check all lights and other electrical items for correct
operation.
At Each Oil Change
•Change the engine oil filter.
•Inspect the brake hoses and lines.
CAUTION!
Failure to perform the required maintenance items
may result in damage to the vehicle.
Required Maintenance Intervals
Refer to the Maintenance Schedules on the following
pages for the required maintenance intervals.
8
M A I
N T
E
N A
N CE
S
C
H E
D
U L
E
SMAINTENANCE SCHEDULES 529

Adaptive Cruise Control (ACC) (Cruise Control) . . 166
Adding Fuel........................... 418
Additives, Fuel ......................... 413
Air Cleaner, Engine (Engine Air Cleaner Filter) . . . 484
Air Conditioner Maintenance ............... 487
Air Conditioning Refrigerant ............... 488
Air Conditioning System .................. 319
Air Conditioning, Operating Tips ............ 328
Air Conditioning, Rear Zone ................ 326
Air Filter .............................. 484
Air Pressure, Tires ....................... 388
Airbag .............................. 67,77
Airbag Deployment ....................... 78
Airbag Light ................... 75,76,81,98,250
Airbag Maintenance ....................... 80
Airbag, Side ...................... 71,74,76,77
Airbag, Window (Side Curtain) ...........72,74,77
Alarm (Security Alarm) .................20,250
Alarm, Panic ............................ 26 All Wheel Drive (AWD)
................... 350
Alterations/Modifications, Vehicle ............. 9
Antenna, Satellite Radio ................... 305
Anti-Lock Brake System (ABS) .............. 368
Anti-Lock Warning Light .................. 247
Anti-Theft System ....................... 250
Antifreeze (Engine Coolant) ................ 524
Appearance Care ........................ 506
Assist, Hill Start ........................ 374
Auto Down Power Windows ................ 43
Automatic Dimming Mirror ................ 108
Automatic Door Locks ..................... 35
Automatic Headlights .................... 147
Automatic Temperature Control (ATC) ......... 319
Automatic Transmission ................343,503
Adding Fluid ....................... 506
Fluid and Filter Changes ............... 503
Fluid Level Check ................. 504,505
Fluid Type ......................... 503
554 INDEX

Special Additives..................... 504
Torque Converter .................... 349
Autostick ............................. 345
Auxiliary Electrical Outlet (Power Outlet) ...... 216
Auxiliary Power Outlet ................... 216
B-Pillar Location ........................ 383
Battery ............................... 485
Keyless Transmitter Replacement (RKE) ..... 27
Belts, Seat ............................ 52,98
Blind Spot Monitoring .................... 111
Body Mechanism Lubrication ............... 488
Brake Assist System ...................... 369
Brake Control System, Electronic ............. 368
Brake Fluid ............................ 500
Brake System ........................... 499
Anti-Lock (ABS) ..................... 368
Fluid Check ........................ 500
Master Cylinder ..................... 500 Parking
........................... 365
Warning Light ....................... 250
Brake/Transmission Interlock ............... 343
Break-In Recommendations, New Vehicle ........ 95
Bulb Replacement ..................... 517,518
Bulbs, Light ............................ 100
Calibration, Compass ..................... 273
Camera, Rear ........................... 202
Capacities, Fluid ........................ 524
Caps, Filler Fuel .............................. 418
Power Steering ...................... 364
Radiator (Coolant Pressure) ............. 497
Car Washes ............................ 507
Carbon Monoxide Warning ...............97,414
Cargo (Vehicle Loading) ................... 422
Cargo Area Cover ....................... 226
Cargo Area Features ...................... 225
10
INDEX 555