Page 112 of 396
Deactivate the interior volumetric and anti-tilt
monitoring to avoid unwanted triggering of the
alarm in cer tain cases such as:
- leaving a pet in the vehicle,
- leaving a window par tially open,
- washing your vehicle,
- changing a wheel,
- having your vehicle towed,
- transpor t by sea.
Locking the vehicle
with exterior perimeter
monitoring only
Deactivation of the interior
volumetric and anti-tilt
monitoring
)
Switch off the ignition.
)
Within ten seconds, press the button until
the indicator lamp is on continuously.
)
Get out of the vehicle.
)
Press the locking button on the remote
control immediately.
The exterior perimeter monitoring alone is
activated: the indicator lamp in the button
flashes once per second. To be effective, this deactivation must
be carried out each time the ignition is
switched off.
Reactivation of the interior
volumetric and anti-tilt
monitoring
)
Press the unlocking button on the remote
control to deactivate the exterior perimeter
monitoring.
)
Press the locking button on the remote
control to activate all the monitoring
functions.
The indicator lamp in the button again flashes
once per second.
Page 113 of 396
111Access
Tr i g g e r i n g o f t h e a l a r m
This is indicated by sounding of the siren and
flashing of the direction indicators for
thirty seconds.
The monitoring functions remain active until
the alarm has been triggered eleven times in
succession.
When the vehicle is unlocked using the remote
control, rapid flashing of the indicator lamp
in the button informs you that the alarm was
triggered during your absence. When the
ignition is switched on, this flashing stops
immediately.
Failure of the remote control
To deactivate the monitoring functions:
Locking the vehicle without
activating the alarm
)
Lock or deadlock the vehicle using the key
in the driver's door lock.
)
unlock the vehicle using the key in the
driver's door lock,
)
open the door; the alarm is triggered,
)
switch on the ignition; the alarm stops;
the indicator lamp in the button goes off.
Operating fault
When the ignition is switched on, fixed
illumination of the indicator lamp in the button
indicates a fault with the system.
Have it checked by a CITROËN dealer or a
qualified workshop.
Page 114 of 396
Doors
Opening
From outside
)
After unlocking the vehicle completely
using the remote control or the key, pull the
door handle.
From inside
)
Pull the interior control lever of a front door;
this unlocks the vehicle completely.
Closing
When a door is not closed correctly:
- when the engine is running
,
this warning lamp comes
on, accompanied by an aler t
message for a few seconds,
- when the vehicle is moving
(speed
higher than 6 mph (10 km/h)), this warning
lamp comes on, accompanied by an aler t
message for a few seconds.
When the selective unlocking is
activated, the first press of the remote
control unlocking button permits
unlocking of the driver's door only. With the selective unlocking activated:
- opening the the driver's door
unlocks the driver's door only (if the
vehicle has not already been
completely unlocked).
- opening one of the passenger
doors unlocks the rest of the
vehicle.
Page 115 of 396
11 3Access
System allowing the doors to be locked and
unlocked manually in the event of a malfunction
of the central locking system or battery failure.
Emergency control
Locking the driver's door
)
Inser t the key in the door lock, then turn it
to the rear.
You can also apply the procedure described
for the passenger doors.
Unlocking the driver's door
)
Inser t the key in the door lock, then turn it
to the front.
Locking the front and rear
passenger doors
)
Open the doors.
)
On the rear doors, check that the child lock
is not on (see Child Safety).
)
Remove the black cap, located on the edge
of the door, using the key.
)
Insert the key in the socket without forcing
it, then without turning it, move the latch
sideways towards the inside of the door.
)
Remove the key and refit the cap.
)
Close the doors and check that the vehicle
has locked correctly from the outside.
Unlocking the front and rear
passenger doors
)
Pull the interior door opening control.
Page 116 of 396
Boot
System allowing the mechanical unlocking of
the boot in the event of a battery or central
locking system malfunction.
Ta i l g a t e r e l e a s e
Unlocking
)
Fold back the rear seats to gain access to
the lock from inside the boot.
)
Inser t a small screwdriver into hole A
of the
lock to unlock the tailgate.
)
Move the latch to the left.
)
After unlocking the boot or the vehicle
using the remote control or the key, press
the opening control, then raise the tailgate.
Opening
Closing
)
Lower the boot lid using the interior grab
handle.
- when the engine is running
,
this warning lamp comes on,
accompanied by the display of an
aler t message for a few seconds,
- when the vehicle is moving
(speed above
6 mph (10 km/h)), this warning lamp comes
on, accompanied by an audible signal and
the display of an aler t message for a few
seconds.
Locking after closing
If the fault persists after closing again, the boot
will remain locked.
If the tailgate is not closed correctly:
Page 117 of 396
11 5Access
1.
Driver's electric window control.
2.
Passenger's electric window control.
- manual mode
)
Press or pull the control gently.
The window stops when the control is
released.
- automatic mode
)
Press or pull the control firmly.
The window opens or closes fully when
the control is released.
)
Pressing the control again stops the
movement of the window.
The electric window controls remain
operational for approximately
45 seconds after the ignition is
switched off or until the vehicle is
locked after a door is opened.
If the passenger 's window cannot be
operated from the driver's door control
panel, carry out the operation from the
passenger's door control panel,
and vice versa.
Electric windows
Fitted with a safety anti-pinch system.
One-touch electric
windows
There are two options:
After approximately ten consecutive
complete opening/closing movements
of the window, a protection function is
activated which only authorises closing
of the window to prevent damage to the
electric window motor.
Once the window is closed, the controls
will become available again after
approximately 40 minutes.
Page 129 of 396
127Visibility
Welcome lighting
The remote switching on of the passenger compar tment lighting makes your access to the vehicle easier in poor light. It is activated depending on the
light level detected by the sunshine sensor.
Switching on
Switching off
On the outside, the welcome lighting switches
off automatically after a set time, when the
ignition is switched on or on locking the vehicle.
On the inside, the welcome lighting switches off
automatically after a pre-determined time or on
opening one of the doors.
Programming
)
Press the open padlock on the
remote control; your vehicle is
unlocked.
On the outside, the sidelamps and dipped
beam headlamps, as well as the side
spotlamps, located under the door mirrors,
come on. The lighting duration for the welcome
lighting is selected via the vehicle
configuration menu.
On the inside, the footwell and courtesy lamps
come on.
Page 138 of 396
1.
Front cour tesy lamp
2.
Front map reading lamps
3.
Rear courtesy lamp
4.
Rear map reading lamps
Courtesy lamps
In this position, the courtesy
lamp comes on gradually:
Front and rear courtesy lamps
- when the vehicle is unlocked,
- when the key is removed from the ignition,
- on opening a door,
- when the remote control locking button is
used to locate your vehicle.
It switches off gradually:
- when the vehicle is locked,
- when the ignition is switched on,
- 30 seconds after the last door is closed.
Permanently off.
Permanent lighting. In permanent lighting mode, the
lighting time varies according to the
circumstances:
- with the ignition off, approximately
ten minutes,
- in energy economy mode,
approximately thirty seconds,
- with the engine running, unlimited.
When the cour tesy lamp is in the
"permanent lighting" position, the rear
courtesy lamp also comes on, except if
it is in the "permanently off " position.
To switch off the rear cour tesy lamp,
put it in the the "permanently off "
position.
Front and rear map reading
lamps
)
With the ignition on, press the
corresponding switch.
Take care not to put anything in contact
with the cour tesy lamps.
