Page 112 of 396
Deactivate the interior volumetric and anti-tilt
monitoring to avoid unwanted triggering of the
alarm in cer tain cases such as:
- leaving a pet in the vehicle,
- leaving a window par tially open,
- washing your vehicle,
- changing a wheel,
- having your vehicle towed,
- transpor t by sea.
Locking the vehicle
with exterior perimeter
monitoring only
Deactivation of the interior
volumetric and anti-tilt
monitoring
)
Switch off the ignition.
)
Within ten seconds, press the button until
the indicator lamp is on continuously.
)
Get out of the vehicle.
)
Press the locking button on the remote
control immediately.
The exterior perimeter monitoring alone is
activated: the indicator lamp in the button
flashes once per second. To be effective, this deactivation must
be carried out each time the ignition is
switched off.
Reactivation of the interior
volumetric and anti-tilt
monitoring
)
Press the unlocking button on the remote
control to deactivate the exterior perimeter
monitoring.
)
Press the locking button on the remote
control to activate all the monitoring
functions.
The indicator lamp in the button again flashes
once per second.
Page 132 of 396
Cornering lighting
With dipped or main beams, this function
makes use of the beam from a front foglamp to
illuminate the inside of a bend, when the vehicle
speed is below 25 mph (approximately 40 km/h)
(urban driving, winding road, intersections,
parking manouevres...).
Switching on
with cornering lighting
without cornering lighting
Switching off
The system does not operate:
- below a cer tain angle of rotation of the
steering wheel,
- above 25 mph (40 km/h),
- when reverse gear is engaged,
The system is activated by default.
Programming
The system is activated or
deactivated in the vehicle
configuration menu. This function starts:
- when the corresponding direction indicator
is switched on,
or
- from a cer tain angle of rotation of the
steering wheel.
Page 156 of 396
To remove the shelf:
)
unhook the two cords,
)
raise the shelf slightly, then remove it.
There are several options for storing the shelf:
- either upright behind the front seats,
- or flat at the base of the boot.
Rear parcel shelf
The hooks can be used to secure shopping
bags.
Hooks
Access to the storage box
An additional hook under the shelf is
used to hold up the boot floor using its
cord, to facilitate access to the tools
and spare wheel or the temporary
puncture repair kit...
Page 158 of 396
Use
)
Extract the torch from its location pulling it
upwards.
)
Press the switch, located on the back,
to switch the torch on or off.
)
Unfold the suppor t, located on the back,
to set down and raise the torch; for
example, when changing a wheel.
Storing
)
Put the torch back in place in its location
starting with the lower part.
If you have forgotten to switch off the torch,
this switches it off automatically.
Storage box
)
Raise the boot carpet for access to
the storage box.
This has areas for the storage a box of spare
bulbs, a first aid kit, two warning triangles...
It also contains the vehicle tools, the temporary
puncture repair kit...
It the torch is not engaged correctly,
it may not charge and may not come on
when the boot is opened.
Page 175 of 396
173
Safety
Automatic operation of
hazard warning lamps
When braking in an emergency, depending on
the deceleration, the hazard warning lamps
come on automatically.
They switch off automatically the first time you
accelerate.
)
You can also switch them off by pressing
the button.
Horn
Audible warning system to aler t other road
users to an imminent danger.
)
Press the central part of the mutlifunction
steering wheel.
Use the horn moderately and only in
the following circumstances:
- immediate danger,
- approaching a location lacking
visibility.
Emergency or
assistance call
This system allows you to make an emergency
or assistance call to the emergency ser vices or
to the dedicated CITROËN ser vice.
For more information on the use of this
function, refer to the "Audio and telematics"
section.
Page 176 of 396
Ty r e u n d e r - i nfl ation detection
System which automatically and continuously
checks the pressure of the tyres while driving.
Sensors fitted in each valve trigger a warning
in the event of problem (speed above 12 mph
(20 km/h)).
Puncture
The tyre under-inflation detection
system is an aid to driving which does
not replace the need for the driver to be
vigilant or to drive responsibly.
Under-infl ated tyre
This warning lamp is displayed on the
instrument panel and/or a message
appears in the screen, accompanied
by an audible signal, to identify the
wheel concerned. The STOP
warning lamp comes on
and/or this warning lamp is displayed on
the instrument panel, accompanied by
an audible signal and a message in the
screen identifying the wheel concerned.
)
Stop as soon as it is safe to do so, avoiding
any sudden movement of the steering
wheel and the brakes.
)
Repair or change the damaged wheel
(punctured or very deflated tyre), and have
the tyre pressure checked as soon as
possible.
)
Check the tyre pressures as soon as
possible.
This check must be carried out when the tyres
are cold.
Page 177 of 396
175
Safety
Sensor(s) not detected or faulty
A message appears in the screen,
accompanied by an audible signal, to identify
the wheel or wheels which are not detected or
to indicate a malfunction in the system.
Contact a CITROËN dealer or a qualified
workshop to replace the faulty sensor(s). All repairs and changing of tyres on a
wheel fitted with this system must be
carried out by a CITROËN dealer or a
qualified workshop.
If, when changing a tyre, you install a
wheel which is not detected by your
vehicle (example: fitting of snow tyres),
you must have the system reinitialised
by a CITROËN dealer or a qualified
workshop. This system does not avoid the need
to have the tyre pressures checked
regularly (refer to the "Identification
markings" section) to ensure that
the optimum dynamic per formance
of the vehicle is maintained and
prevent premature wear of the
tyres, par ticularly in arduous driving
conditions (heavy load, high speed).
The tyre pressures must be checked
cold, at least once a month. Remember
to check the pressure of the spare
wheel.
The tyre under-inflation detection
system may experience temporary
inter ference due to electro-magnetic
emissions on a frequency close to that
used by the system.
This message is also displayed when
one of the wheels is away from the
vehicle (being repaired) or when one
or more wheels without a sensor are
fitted.
If your vehicle is equipped with a spare
wheel, this is not fitted with a sensor.
Page 178 of 396
Braking assistance systems
Group of supplementary systems which help
you to obtain optimum braking in complete
safety in emergency situations:
- anti-lock braking system (ABS),
- electronic brake force distribution (EBFD),
- emergency braking assistance (EBA).
Anti-lock braking system
and electronic brake force
distribution
Linked systems which improve the stability and
manoeuvrability of your vehicle when braking,
in par ticular on poor or slippery sur faces.
Activation
The anti-lock braking system comes into
operation automatically when there is a risk of
wheel lock.
Normal operation of the ABS may make itself
felt by slight vibration of the brake pedal.
When braking in an emergency, press
very firmly without releasing the
pressure.
Operating fault
If this warning lamp comes on,
together with the STOP
and ABS
warning lamps, accompanied by an
audible signal and a message in the screen, it
indicates a malfunction of the electronic brake
force distribution which could result in loss of
control of the vehicle when braking.
You must stop as soon as it is safe to do so.
When replacing wheels (tyres and
rims), ensure that they conform to the
manufacturer's recommendations.
If this warning lamp comes on,
accompanied by an audible signal
and a message in the screen, it
indicates a malfunction of the anti-lock braking
system which could result in loss of control of
the vehicle when braking.
In either case, contact a CITROËN dealer or a
qualified workshop.
