Page 108 of 396
Do not throw the remote control
batteries away, they contain metals
which are harmful to the environment.
Take them to an approved collection
point.
Lost keys
Visit a CITROËN dealer with the vehicle's registration document, your personal
identification documents and if possible the key code label.
The CITROËN dealer will be able to find the key code and the transponder code required to
order a new key.
Remote control
The high frequency remote control is a sensitive system; do not operate it while it is in your
pocket as there is a possibility that it may unlock the vehicle, without you being aware of it.
Do not repeatedly press the buttons of your remote control out of range and out of sight of
your vehicle. You run the risk of stopping it from working and the remote control would have
to be reinitialised.
The remote control does not operate when the key is in the ignition switch, even when the
ignition is switched off, except for reinitialisation.
Locking the vehicle
Driving with the doors locked may make access to the passenger compar tment by the
emergency services more difficult in an emergency.
As a safety precaution (with children on board), remove the key from the ignition switch
when you leave the vehicle, even for a shor t time.
Anti-theft protection
Do not make any modifications to the electronic engine immobiliser system; this could
cause malfunctions.
When purchasing a second-hand vehicle
Have the pairing of all of the keys in your possession checked by a CITROËN dealer,
to ensure that only your keys can be used to open and start the vehicle.
Page 109 of 396
107Access
Locking
)
Press this button to lock the vehicle.
The red indicator lamp in the button comes on.
Central locking control
This control allows the simultaneous locking or unlocking of the doors and boot from inside the
vehicle.
If one of the doors is open, central
locking from the inside does not take
place.
Unlocking
)
Press the button again to unlock the
vehicle.
The red indicator lamp in the button goes off.
If the vehicle is locked from the outside,
this button is inactive.
)
In this case, use the remote control
or the key to unlock the vehicle or
pull an interior door handle to open
a door.
Page 113 of 396
111Access
Tr i g g e r i n g o f t h e a l a r m
This is indicated by sounding of the siren and
flashing of the direction indicators for
thirty seconds.
The monitoring functions remain active until
the alarm has been triggered eleven times in
succession.
When the vehicle is unlocked using the remote
control, rapid flashing of the indicator lamp
in the button informs you that the alarm was
triggered during your absence. When the
ignition is switched on, this flashing stops
immediately.
Failure of the remote control
To deactivate the monitoring functions:
Locking the vehicle without
activating the alarm
)
Lock or deadlock the vehicle using the key
in the driver's door lock.
)
unlock the vehicle using the key in the
driver's door lock,
)
open the door; the alarm is triggered,
)
switch on the ignition; the alarm stops;
the indicator lamp in the button goes off.
Operating fault
When the ignition is switched on, fixed
illumination of the indicator lamp in the button
indicates a fault with the system.
Have it checked by a CITROËN dealer or a
qualified workshop.
Page 114 of 396
Doors
Opening
From outside
)
After unlocking the vehicle completely
using the remote control or the key, pull the
door handle.
From inside
)
Pull the interior control lever of a front door;
this unlocks the vehicle completely.
Closing
When a door is not closed correctly:
- when the engine is running
,
this warning lamp comes
on, accompanied by an aler t
message for a few seconds,
- when the vehicle is moving
(speed
higher than 6 mph (10 km/h)), this warning
lamp comes on, accompanied by an aler t
message for a few seconds.
When the selective unlocking is
activated, the first press of the remote
control unlocking button permits
unlocking of the driver's door only. With the selective unlocking activated:
- opening the the driver's door
unlocks the driver's door only (if the
vehicle has not already been
completely unlocked).
- opening one of the passenger
doors unlocks the rest of the
vehicle.
Page 115 of 396
11 3Access
System allowing the doors to be locked and
unlocked manually in the event of a malfunction
of the central locking system or battery failure.
Emergency control
Locking the driver's door
)
Inser t the key in the door lock, then turn it
to the rear.
You can also apply the procedure described
for the passenger doors.
Unlocking the driver's door
)
Inser t the key in the door lock, then turn it
to the front.
Locking the front and rear
passenger doors
)
Open the doors.
)
On the rear doors, check that the child lock
is not on (see Child Safety).
)
Remove the black cap, located on the edge
of the door, using the key.
)
Insert the key in the socket without forcing
it, then without turning it, move the latch
sideways towards the inside of the door.
)
Remove the key and refit the cap.
)
Close the doors and check that the vehicle
has locked correctly from the outside.
Unlocking the front and rear
passenger doors
)
Pull the interior door opening control.
Page 116 of 396
Boot
System allowing the mechanical unlocking of
the boot in the event of a battery or central
locking system malfunction.
Ta i l g a t e r e l e a s e
Unlocking
)
Fold back the rear seats to gain access to
the lock from inside the boot.
)
Inser t a small screwdriver into hole A
of the
lock to unlock the tailgate.
)
Move the latch to the left.
)
After unlocking the boot or the vehicle
using the remote control or the key, press
the opening control, then raise the tailgate.
Opening
Closing
)
Lower the boot lid using the interior grab
handle.
- when the engine is running
,
this warning lamp comes on,
accompanied by the display of an
aler t message for a few seconds,
- when the vehicle is moving
(speed above
6 mph (10 km/h)), this warning lamp comes
on, accompanied by an audible signal and
the display of an aler t message for a few
seconds.
Locking after closing
If the fault persists after closing again, the boot
will remain locked.
If the tailgate is not closed correctly:
Page 118 of 396
Safety anti-pinch
When the window rises and meets an obstacle,
it stops and partially lowers again.
Reinitialisation
If a window does not rise automatically,
its operation must be reinitialised:
)
pull the control until the window stops,
)
release the control and pull it again until
the window closes fully,
)
continue to hold the control for
approximately one second after the
window has closed,
)
press the control to lower the window
automatically to the low position,
)
when the window has reached the low
position, press the control again for
approximately one second.
The safety anti-pinch function is not
operational during these operations.
If the window cannot be closed
(for example, in the presence of ice),
once the window has lowered:
)
press and hold the control until the
window opens fully,
)
then pull the control immediately
and hold it until the window closes,
)
continue to hold the control for
approximately one second after the
window has closed.
The safety anti-pinch function is not
operational during these operations.
Always remove the key from the ignition
when leaving the vehicle, even for a
shor t time.
If an obstacle is encountered during
operation of the electric windows,
you must reverse the movement of the
window. To do this, press the control
concerned.
When the driver operates the
passenger's electric window control,
they must ensure that nothing is
preventing the windows closing
correctly.
The driver must ensure that the
passengers use the electric windows
correctly.
Be aware of children when operating
the windows.
Page 119 of 396
11 7Access
Fuel tank
Capacity of the tank: approximately 60 litres.
Low fuel level
Refuelling
Additions of fuel must be of at least 5 litres to
be registered by the fuel gauge.
Opening the filler cap may result in an inrush of
air. This vacuum is entirely normal and results
from the sealing of the fuel system.
)
Press control A
until the automatic opening
of the fuel flap is heard.
This control remains active for a few minutes
after switching off the ignition. If necessary,
switch the ignition on again to reactivate it.
)
Take care to select the pump that delivers
the correct fuel for your vehicle.
)
Introduce the nozzle so as to push in the
metal non-return flap B.
)
Make sure that the nozzle is pushed in as
far as possible before star ting to refuel (risk
of blowback).
)
Maintain this position while refuelling.
)
Push the fuel flap to close it.
If you are filling your tank to the top, do not
persist after the third cut- off; this could
cause your vehicle to malfunction.
When the low fuel level in the tank
is reached, this warning lamp on
the instrument panel comes on,
accompanied by an audible warning
and a message in the screen.
When it first comes on, around 6 litres of fuel
remain in the tank.
You must refuel as soon as possible to avoid
running out.
With Stop & Star t, never refuel with the
system in STOP mode; you must switch
off the ignition with the key.
