73
II
ELECTRONIC STABILITY PROGRAMME
TheESP system offers increased
driving safety but is not in place toencourage the driver to take addi-
tional risks or to drive at excessivespeeds.
The operation of this s
ystem is
assured provided that the manufac-
turer’s recommendations concern-
ing the wheels (tyres and rims),
braking components and electricalcomponents are observed, as wellas the fi tting and repair proceduresused by CITROËN dealers andgpp
qualifi ed workshops.
Following an accident, have thesystem checked by a CITROËNg,
dealer or a qualifi ed workshop.
ELECTRONIC STABILITY PROGRAMME (ESP) AND TRACTION CONTROL (ASR)
These systems are closely associated with ABS and additional to it. In the event of a loss of control of the vehicle by the driver, theESPsystem acts
automatically on one or more wheels and also on the engine to bring the
vehicle back on trajectory. The ASRsystem optimises traction and prevents
wheel spin by acting on the brakes of the driving wheels as well as on the engine. It also improves steering stability during acceleration.
OPERATION
When either the ESPor the ASR system is brought into operation
the warning lamp "ESP/ASR" fl ashes.
DEACTIVATION
In exceptional conditions (vehicle stuck in snow, soft ground, etc.) it mayprove useful to deactivate theESP/ASR systems to allow the wheels tospin and thus regain traction.
Press on buttonA, the"ESP/ASR" warning lamp, as well as the lamp on
the buttonA, light up. TheESP/ASR systems are no longer active.
The ESP/ASR systems will activate again:Automatically after the ignition has been switched off.
Automatically when you drive at above approx. 30 mph (50 km/h).
Manuallywith another press on button A.
OPERATIONAL ANOMALY
Should there be a system malfunction, the "ESP/ASR"warning lamp willlight up.
Contact a CITROËN dealer or a qualifi ed workshop to have the systemchecked.
96
III
Replacing the battery
The remote control is powered bya 6 V-28L battery cell, which isincluded.
Information appears on the screen
when this battery should be replaced.
Unclip the casing and replace thebattery.
Th
e remote control must then bere-initialised, as described on thispage.
Do not discard old batteries; take
them to an approved recyclingpoint.
Re-initialisation of the remote control
Always switch off the program-mable heating while refuelling inorder to avoid the risk of fi re or explosion.
To avoid the risk of intoxicationor asphyxiation, the program-mable heating should not beused, even for a short time, inan enclosed space such as agarage, or workshop withoutexhaust gas extraction.
Do not park the vehicle over infl ammable materials (drygrass, dead leaves, papers…),as there is a risk of fi re.
The programmable heating sys-tem is supplied by the vehicleísfuel tank. Before using it, ensurethat there is suffi cient fuel in thetank. If the low fuel warning lampis on we strongly recommendthat you do not programme theheating to come on.
PROGRAMMABLE HEATING
If the battery is disconnected or
replaced, the remote control must be re-initialised.
After switchin
g on, within fi veseconds press button4(OFF) for
1 second.
If the o
peration is successful, the "OK" message appears in the
remote control screen.
If not, the
"FAIL"message
appears. Repeat the procedure.
As a secondar
y advantage, use of your programmable heating sys-
tem allows it to be used to pre-heat
t
he passenger compartment.
