2011 Citroen C6 belt

98
III
1
2
REAR SEATS
FOLDING BENCHSEAT
The whole or just part of the benchseat can be folded. It is necessary to remove the head restraints.
Seat cushion
Use the strap to lift the seat cushion, then rest it against the front seat back-rests. When repositioning the seat cushion, make sure that the seat belt buckles are correctly in place.
FLAP FOR TRANSPORT OFLONG OBJECTS
A fl ap in the backrest, located to
the rear of the armrest, facilitates
the carr
ying of long objects.
Before installing any long objects,
fold the interior blind and thenmake sure that the loads areproperly secured, not obstructingthe movements of the gear lever.
This fl ap can be concealed b
y meansof a foldable cover with a tab.

99
III
A
BC
D
REAR SEATS
Seat cushion folded.
Stow the head restraints.
Pr
ess the controlA located at theend of the backrest and fully tilt
forwards.
The benchseat backrest can befolded in two sections. When youreposition the backrest, make sure
that it locks in place.Your vehicle's boot can be kept
isolated from the passen
ger com-
partment.
T
o lock the access to the boot:1.Place the benchseat in its correct position.The red warning lamp oncontrol Ashould no longer be
visible.
2.Insert the ignition key in thelock.3. Lock it.
Before moving the seats
So as to avoid damaging the seat belts by jamming them, takecare to keep them to the sides of the backrest.
LOCKING/UNLOCKING OF THE ACCESS INTO THE BOOT VIA THE REAR BENCHSEATREAR CENTRAL SEAT BELT
For easier opening of the seat beltcover D, you should fi rst raise thecentral head restraint.
Insert the fi rst fasteningC into thefront left hand (black) buckle, then
insert the second fastening B intothe front right hand buckle.

101
IIIA
AIRBAGS
AIRBAG EQUIPMENT
Yo ur vehicle has:A driver's front airbag.
A driver's knees airbag.
A front passenger's airbag
which can be deactivated.
Front lateral airba
gs.
Front and rear curtain airbags.
Rear lateral airbags.
Deplo
yment of your airbags is
dependent on the degree of vio-lence of the collision.
•
•
•
••
•
REACTIVATING THE FRONTPASSENGER'S AIRBAG
Do not forget to reactivate thefunction.
For that:With the ignition switched off, insert the key into the switch A.Turn the key to the"ON"position, the airbag isactivated.
The warning lamp in the
instrument panel lights up for a few seconds when you switch
on the ignition.Note: It is compulsory to wear theseat belt.
Never deactivate the passenger's
airbag when a passenger is present(unless a child in a rear-facing childseat).
•
•
FRONT PASSENGER'SAIRBAG DEACTIVATION
In order to be able to use a rear-facing child seat in the front passenger's seat
position, it is imperative to deactivate
the passenger's airbag.
For that:With the ignition switched off,
insert the key into the switchA.
Turn the key to the "OFF"
position, the passenger's airbag is deactivated.The front passenger's airbag
deactivation warning lamp,
in the instrument panel, lightsup when you switch on the
ignition.
•
•

103
III
CHILD RESTRAINTS
CHILD SEATS SECURED BY MEANS OF THE VEHICLE
SEAT BELT
In conformity with European law,
this table shows you the possibili-
ties for the installation of univer-sally approved child seats using aseat belt, depending on the weightof the child.
Consult "User Precautions", chap-ter on "Child Safety" at the end of this handbook, in order to ensurethat you are installing your child inconditions of maximum safety.
Seat position(s)
Weight of child
Up to 10 kgand up to 13 kg(groups 0 and 0+)
9 - 18 kg (group 1)15 - 25 kg(group 2)22 - 36 kg(group 3)
Front passenger’s (a)U (R)U (R)U (R)U (R)
Lateral rearUUUU
Central rearL1XL3L3
In the front passenger's seat position, it is imperative to deactivate the front passenger's airbag if you are installing a "rear-facing child seat" there. Otherwise the child risks being killed or seriously injured should the airbag deploy.
Take care to comply with the fi tting instructions given in the child seat manufacturer’s installation guide.
U: Seat position suitable for the installation of a universal rear-facing child
seat and a universal forward-facing child seat position.
U (R): Seat position suitable for installation of a universal rear-facing child
seat and of a forward-facing seat. The vehicle seat should be adjusted to
the highest position.
(a): In the front passenger's seat position, it is imperative to deactivate the
front passenger's airbag if you are installing a "rear-facing child seat" there.Otherwise the child risks being killed or seriously injured should the airbagdeploy.
Before placin
g your child in the front passenger’s seat position, consult thelegislation currently in force in your country on the carrying of children in this
position.
L-:
Only the child seats indicated may be installed in the seat positionconcerned (depending on country).
X: Position not suitable for installation of a child seat of the weight groupindicated.

104
III
ab
ab
Pack Lounge seats
ISOFIX ANCHORINGPOINTS AND THE ISOFIX
FASTENING SYSTEM
Your vehicle is type-approvedaccording to new ISOFIX direc-
tives. The lateral rear seats of your vehicle are each equipped
with regulation ISOFIX anchoringpoints.
Incorrect installation of a child seat
in a vehicle compromises protec-
tion of the child in the event of a col-lision. The ISOFIX system enablesyou to minimise the risks posed byincorrect fi tting. The ISOFIX fas-
tening system gives you a conven-
ient, strong and reliable fi tting for achild seat in your vehicle.B
enchseat
The ISOFIX fastening
system
The ISOFIX system features3ringsfor each lateral rear seat position:Two bottom rings aandblocated between the backrestand the seat cushion. These are about 28 cm apart,concealed in the case of a
benchseat under a fl ap with the
logo
ISOFIX.
One top ring c fi xed on the rear shelf,concealedunder a fl ap
with the logo
TOP TETHERbehind the head restraint.
•
•
The ISOFIX child seat
fastening system
ISOFIX child seats have two latches
which are easy to secure on the two
bottom rings aandb.
Some ISOFIX child seats also have
a top belt which is for attaching on
the ISOFIX top ringc.
To attach the top belt, raise thehead restraint of the vehicle seat,
then pass the buckle between the
two su
pports. Next fi x the buckle
on the top ringc and tension thetop belt.
This fi xing system is intended for children weighingup to 18 kg.
The ISOFIX child seats that can beinstalled in your vehicle are given
in the table opposite.
CHILD RESTRAINTS

105
III
TABLE SUMMARISING THE INSTALLATION OF ISOFIX CHILD
SEATS
In compliance with European legislation (ECE 16), this table indicates which
of the ISOFIX child seats can be installed in seat positions in your vehicle
that are equipped with ISOFIX anchoring points.
For ISOFIX universal and semi-universal child seats, the ISOFIX size class,
defi ned by a letter from A to G, is shown on the child seat to the right of the
ISOFIX logo.
When an ISOFIX child seat is installed on a Loun
ge seat, the Lounge
seat must be adjusted to the most upright position.
RECOMMENDED ISOFIX
CHILD SEAT
The ISOFIX child seat recom-mended for your vehicle is theISOFIX RÖMER Duo Plusy. It
is available from the CITROËNdealer network.
It is equipped with a top belt and so
is approved as an "ISOFIX univer-sal" child seat, size class B1. It isessential to use the top belt.
This ISOFIX child seat can also beinstalled in seat positions that arenot equipped with ISOFIX anchor-
ing points. In this case, it is com-pulsory to secure it to the vehicleseat by means of the vehicle seatbelt.
IUF: Seat position suitable for installation of an ISOFIX universal child seat. ISOFIX "forward-facing" child
seats equipped with a top belt for attaching on the top ring in the vehicle's ISOFIX seat positions.
IL-SU: Seat position suitable for installation of an ISOFIX semi-universal child seat. ISOFIX "forward-
facing" child seats equipped with a bar, ISOFIX "rear-facing" child seats, or ISOFIX shell seats equipped
with either a top belt or a bar.
Weight of child/Age given as a guide
Up to 10 kg(group 0)Up to around 6 months
Up to 10 kg and up to 13 kg(groups 0 and 0+)Up to around 1 year old
9 - 18 kg (group 1)From approx. 1 to 3 years
Type of ISOFIXchild seatShell"Rear-facing""Rear-facing""Forward-facing

ISOFIX size classFGCDECDABB1
ISOFIX lateral rear seats
ISOFIX universaland semi-universalchildseats
-IL-SUIL-SUIUFIL-SU
CHILD RESTRAINTS

129
IV
TABLE OF FUSES
Ref.RatingFunction
F1––
F2––
F 35 AAirbags
F 410 ABraking system – Active bonnet – Cruise contol/speed limiter – Photochromic rear view mirror – Diagnostic socket –Multifunction screen inclination motorgygy
F 530 AFront window – Sun roof
F 630 ARear window
F 75 ASun visor lighting – Glove box lighting – Interior lamps – Rear cigar-lighter
F 820 AControls at the steering wheel – Display – Opening of windows (Micro-descent) – Alarm – Radio
F 930 AFront cigar-lighter
F 1015 ABoot relay unit – Trailer relay unit
F 1115 ASteering lock
F1215 ADriver’s and front passenger’s seat belt warning lamp – Opening of windows (Micro-descent) – Electric seats – Parkingassistance – Audio system JBL
F 135 AActive bonnet – Rain and brightness sensor – Windscreen wiper – Engine relay unit supply
F 1415 ALane Departure Warning System – Air conditioning – Instrument panel – Head-up display – Airbags – Bluetooth®(Hands-free kit) – BHI relaygyg
F 1530 ACentral locking – Child safety
F 16SHUNT–
F 1740 AVentilation
DASHBOARD FUSES (BOX C)

141
V
4
3
8
9
61
2
5
7
CHANGING A WHEEL
ACCESS TO THE SPARE WHEEL
To access the spare wheel1.Lift the boot fl oor by means of the strap.2.Anchor the strap on the roof of the boot.3.To remove the spare wheel, detach the belt then push the wheelforwards so as to be able to lift it.
TO REPOSITION THE SPARE WHEEL
To put the spare wheel back in the boot1.Position the spare wheel fl at in the boot, then pull it towards you.2.Next place the toolbox inside the wheel, then secure the assembly with
the belt.3.Release the strap to return the boot fl oor to its initial position.
Tyre pressures
Tyre pressures are indicated on the label which is positioned low down on
the front pillar. See "Vehicle identifi cation" and "User Precautions". (On this label you will see a pressure for normal speeds and a pressure for high speeds).
1.Handle2.Jack3. Tool for removing/refi tting the
wheel bolts4. Tool for removing the anti-theft
bolt protector
5. Centring guide6. Tool for removing foglamps
and reversing lamps
7. Handle extension8. Towing eye9. Movable chock
TOOLS
The tools are to be found in a pro-
tective holder inside the spare
wheel. Pull back the retaining strap
t
o have access.