Page 65 of 352
Downloaded from www.Manualslib.com manuals search engine III
63
COMFORT
9. Rapid demisting/defrosting
of the front and rear
windows
- Press button 9
. The warning
lamp comes on.
This function gives a rapid
demisting/defrosting of the
vehicle simultaneously with:
- front demisting/defrosting at op-
timum temperature,
- optimum air fl ow,
- intake of exterior air,
- demisting/defrosting of the door
mirrors and rear screen,
- air conditioning, if necessary.
Press button 9
again or " AUTO"
to stop the function. Demisting/
defrosting of the door mirrors and
rear screen remains activated.
10. Air conditioning
)
Press button 10
to activate the
air conditioning.
The A/C
warning lamp comes on.
B. PASSENGER CONTROL PANELS
11. Front passenger
The front passenger can adjust their
temperature control independently
at any time by pressing buttons +
and -
.
The front passenger con-
trols the adjustment of their
own temperature.
The temperature setting for
the passenger is aligned
with that for the driver.
12. Rear passengers (right/left)
By default, in AUTO
position, the adjust-
ment of the air fl ow is
aligned on the front
ventilation.
)
Rotate the button
to decrease or in-
crease the air fl ow.
You can adjust the air fl ow only if this
is enabled by the driver (see button 6
of the driver’s control panel).
With Stop & Start, when demist-
ing has been activated, the STOP
mode is not available.
Page 66 of 352
Downloaded from www.Manualslib.com manuals search engine III
64
COMFORT
ADDITIONAL AIR
CONDITIONING
Additional air conditioning allows you
to optimise comfort levels in warm
weather conditions. It produces ad-
ditional fresh air which is supplied
using the rear air vents. The supply
of warm air via the rear air vents is
not possible using this system.
C. REAR PASSENGER
CONTROL PANELS
(RIGHT/LEFT)
13. Adjustment of
temperature
The rear passengers can adjust their
temperature controls independently
via buttons +
and -
.
Their setting cannot be greater than
that of the driver by more than 2.
Attainment of this maximum setting
is confi rmed by the fl ashing of its
display.
14. Adjustment of air fan
speed
The air fan operates only when the
engine is running.
To adjust the fl ow of air, press on
button:
to increase the air fl ow,
to decrease the air fl ow. The level of air fl ow is indicated on
the display by the progressive fi lling
of the fan blades.
By reducing the fl ow to minimum,
you switch off the air conditioning
system (OFF).
You can adjust the temperature and
the air fl ow only if the driver enables
you to (see button 6
of the driver’s
control panel).
This warning lamp signifi es
that the passenger controls
are locked, you can adjust
neither the temperature nor
the air fl ow, which remain aligned on
the preferences of the driver.
This warning lamp indi-
cates that the supply of air
is cut off
.
This position is recommended in
cold weather conditions, as the air
vents do not supply warm air.
Page 67 of 352
Downloaded from www.Manualslib.com manuals search engine III
65
COMFORT
SCENTED AIR FRESHENER
The scented air freshener releases a
fragrance into the passenger compart-
ment via the central air vents.
)
Rotate the button A
to adjust (to
the left to reduce, to the right to
increase) or stop (maximum to
the left) the fl ow of scented air.
The central air vents have to be
open.
)
Press the button A
, rotating it a
quarter turn to the left as far as it
will go.
)
Remove the air freshener from
the dashboard.
)
Replace the cartridge (see
"Replacing a cartridge”).
After fi tting or changing a cartridge:
)
place the air freshener back in its
housing.
)
rotate it a quarter turn to the right.
Adjustment of flow
To remove the air freshener
To insert the air freshener
The air freshener contains an
empty cartridge when your vehicle
is delivered. You therefore need to
insert a cartridge in order to use
the air freshener.
A cartridge lasts on average 3 months,
based on one hour’s usage per day.
Page 68 of 352
Downloaded from www.Manualslib.com manuals search engine III
66
COMFORT
The recharge for the air freshener
consists of a cartridge B
and its
sealed container C
.
)
Remove the protective fi lm D
.
)
Place the head of the cartridge B
on the button A
of the air fresh-
ener.
)
Rotate it a quarter turn to lock
it on the button and remove the
container.
)
Insert the air freshener into its
housing.
You can change cartridges at any
time, keeping the used cartridges in
their original containers. The air freshener button A
is inde-
pendent of the cartridge. Cartridges
are supplied without the air freshener
button A
.
The button of the air freshener A
can only be fi tted to the centre of
the dashboard with a cartridge at-
tached.
Therefore always keep the air fresh-
ener button A
and one cartridge.
Replacement cartridges are avail-
able, depending on country, either on
the Internet site or from a CITROËN
dealer or a qualifi ed workshop.
Locations are provided in the glove
box for storing cartridges and con-
tainers.
Replacing a cartridge
Air freshener button
For safety, use only cartridges that
are provided for this purpose.
Retain the containers for storing
used cartridges.
Do not recharge or dismantle the
cartridges.
Keep them out of reach of children
and animals.
Avoid all contact with the skin and
with the eyes.
In the event of ingestion, consult a
doctor and show them the product
packaging or label.
Do not install or remove a cartridge
while you are driving.
Page 69 of 352
Downloaded from www.Manualslib.com manuals search engine III
67
COMFORT
FRONT SEATS
MANUAL ADJUSTMENTS
1. Forwards-backwards
adjustment
Raise the control bar, then slide the
seat to the position desired.
2. Lumbar support
Rotate the control until you attain
the position desired.
3. Seat height adjustment
Raise or lower the the control the
number of times necessary to obtain
the position desired.
4. Backrest angle
Operate the control and adjust the
angle of the backrest.
It is possible to incline the back-
rest 45° rearwards by tilting it until it
locks; to unlock it, lift the control.
5. Armrest
To adjust the position of the armrest,
pull it up and then fully down, and
then raise it to the desired position.
6. Head restraint
To raise it, pull it upwards. To lower
it, press on the control as well as on
the head restraint.
The adjustment is correct when the
top of the head restraint is level with
the top of the head.
It can also be adjusted for tilt (de-
pending on version).
To remove it, press on the unlocking
button and pull it upwards.
To adjust the head restraint for-
wards/backwards, move the base of
the head restraint to obtain the posi-
tion desired.
Never drive without the head re-
straints fi tted. They must be in
place and adjusted correctly.
Page 70 of 352
Downloaded from www.Manualslib.com manuals search engine III
68
COMFORT
FRONT SEATS
1. Adjustment of the
seat height and angle,
forwards-backwards
2. Adjustment of backrest
angle and lumbar support
The seats can also be adjusted elec-
trically for a short period:
- on opening one of the front
doors,
- after switching off the ignition.
Heated seats control
ELECTRIC ADJUSTMENTS
Raise or lower the front of
control to raise or lower the
front of the seat base (on
driver’s seat).
Raise or lower the rear of
control to raise or lower the
seat.
Action control forwards or
backwards to slide the seat
forwards/backwards. Push the top of control
forwards or backwards to
adjust the backrest angle.
Raise or lower control to
increase or decrease the
lumbar support.
With the engine running, the front
seats can be heated individually.
)
Use the corresponding adjust-
ment wheel, placed on the inner
side of each front seat, to switch
on and select the level of heating
required:
0
: Off.
1
: Low.
2
: Medium.
3
: High.
Page 71 of 352
Downloaded from www.Manualslib.com manuals search engine III
69
COMFORT
Storing driving positions
System which registers the electrical
settings of the driver's seat and door
mirrors. It enables you to store and
recall two positions using the but-
tons on the side of the driver's seat.
Storing a position
Using buttons M/1/2
)
Switch on the ignition.
)
Adjust your seat and the door
mirrors.
)
Press button M
, then press but-
ton 1
or 2
within four seconds.
An audible signal indicates that
the position has been stored.
Storing a new position cancels the
previous position.
Recalling a stored position
Ignition on or engine running
)
Press button 1
or 2
to recall the
corresponding position.
An audible signal indicates the end
of the adjustment.
You can interrupt the current move-
ment by pressing button M
, 1
or 2
or
by using one of the seat controls.
A stored position cannot be recalled
while driving.
Recalling stored positions is deacti-
vated 45 seconds after switching off
the ignition.
Page 72 of 352
Downloaded from www.Manualslib.com manuals search engine III
70
COMFORT
REAR HEAD RESTRAINTS
The rear head restraints can be
removed and have two positions:
- high, position for use,
- low, storage position.
To raise a head restraint, pull it up-
wards.
To lower it, press the lug then the
head restraint.
To remove it, place it in the high posi-
tion, push the lug and pull it upwards.
To r efi t it, engage the head restraint
rods in the holes taking care to re-
main in line with the seat back.
SECOND ROW SEATS
Forwards-backwards adjustment
Lift the control A
, located at the front
of the seat, then move the seat to
the desired position.
"Comfort" position
The 3 second-row seats are inde-
pendent of each other and all the
same width. They all can have a
"comfort" position.
Placing a seat in the "comfort"
position
)
Pull on the control B
and guide
the seat rearwards.
The backrest reclines and the seat
base pivots slightly.
Returning the seat to the initial
position
)
Pull on the control B
and allow
the seat to come forwards.
Always supervise any movements
of seats by children. Never drive with the head restraints
removed, they must be in place
and correctly adjusted.