2011 Alfa Romeo MiTo ECU

IN AN EMERGENCY181
4
DIPPED BEAM HEADLIGHTS
With incandescent bulb
To change the bulb, proceed as follows:
❍remove cover B-fig. 22;
❍remove cover A-fig. 24 protecting the bulb;
❍remove the bulb and replace it;
❍refit the lamp holder making sure it is correctly secured;
❍refit cover B-fig. 22.
With gas discharge bulbs (Bi-xenon)
(for versions/markets, where provided)
DIRECTION INDICATORS
Front indicators
To change the bulb take key A-fig. 25 (located in the document
holder case), insert in seat B and turn the bulb holder anticlock-
wise. Remove the bulb and replace it.
fig. 24A0J0040m
Contact an Alfa Romeo Authorised Service Provider
to replace these bulbs.
fig. 25A0J0018m

184IN AN EMERGENCY
REPLACING AN INTERIOR BULB
FRONT COURTESY LIGHT
To change the bulb, proceed as follows:
❍remove courtesy light A-fig. 31 by applying leverage at the
points shown by the arrows;
❍open flap B-fig. 32 replace bulb C, releasing it from the side
contacts. Make sure that the new bulbs are correctly secured
between the contacts;
❍close flap B-fig. 32 and secure courtesy light A-fig. 31 in its
housing.
LUGGAGE COMPARTMENT COURTESY LIGHT
To change the bulb, proceed as follows:
❍open the luggage compartment and remove courtesy light A-fig.
33, by applying leverage at the points shown by the arrows;
fig. 31A0J0120m
fig. 32A0J0121m
fig. 33A0J0119m

186IN AN EMERGENCY
SUN VISOR COURTESY LIGHT
(for versions/markets, where provided)
To change the bulb, proceed as follows:
❍lower the sun visor and remove courtesy light A-fig. 36 by ap-
plying leverage at the points shown by the arrows;
❍remove protective cover B, releasing it from tabs C, replace bulb
D-fig. 37 by pulling it outwards and releasing it from the side
contacts;
❍insert a new bulb, making sure that it is correctly secured be-
tween the contacts;
❍refit protective cover B by inserting it between tabs C;
❍refit the courtesy light by inserting into side E-fig. 37 and then
pressing the other side until hearing the locking click of tab F.
fig. 36A0J0123mfig. 37A0J0124m

CARE AND MAINTENANCE221
5
Replacing the windscreen wiper blades
Proceed as follows:
❍lift the windscreen wiper arm and position the blade so that it
forms an angle of 90° with the arm;
❍press tabs (one on each side) A-fig. 8 on the attachment clip
and remove the blade from the arm;
❍fit the new blade, inserting the tab into the dedicated housing
in the arm. Make sure that the new blade is secured in posi-
tion.
Replacing the rearscreen wiper blade
Proceed as follows:
❍lift cover A-fig. 9, undo nut B and remove arm C;
❍position the new arm, fully tighten nut B and then lower
cover A.
SPRAY NOZZLES
Windscreen washer fig. 10
The windscreen washer jets are fixed.
fig. 8A0J0054m
fig. 9A0J0057m
fig. 10A0J0053m