2011 Alfa Romeo 147 engine oil

VEHICLE MAINTENANCE
228
SELESPEED TRANSMISSION
OIL
(fig. 4)
The Selespeed transmission oil should be
checked with the vehicle on a level surface
and with the engine stopped and cold.
To check the level, proceed as follows:
– turn the ignition key to MAR;
– disconnect the breather tube and re-
move the cap (A) checking that the level
corresponds with the MAXmark on the dip-
stick integrated with the cap;– if the oil is below the MAXmark, top
up to reach the correct level;
– after refitting the cap, insert the breather
tube firmly on the housing on the cap and
turn the ignition key to STOP.
Used gearbox oil contains
dangerous substances for
the environment. For chang-
ing the oil we advise contacting Al-
fa Romeo Authorised Services who
are equipped for disposing of used
oil respecting nature and the law.Do not add oil with spec-
ifications other than that
already in the gearbox.
fig. 4
A0A00197m
Be very careful working in-
side the engine compart-
ment if the engine is hot: danger of
burns. Remember that the fan may
cut in if the engine is very hot: dan-
ger of injury.
WARNING

VEHICLE MAINTENANCE
229
POWER STEERING FLUID
(fig. 6)
Check that the level of the oil in the reser-
voir is at maximum.
This operation should be carried out with
the vehicle on a level surface and the en-
gine switched off and cold.
Check that the level reaches the MAX
mark on the reservoir or coincides with the
upper notch (maximum level) on the dip-
stick (A) integral with the reservoir cap. The cooling system is
pressurised. If necessary,
replace the cap only with
another genuine one, otherwise
system efficiency could be compro-
mised.
Top up only with the same
fluid contained in the cool-
ing circuit. PARAFLU UP
(red) cannot be mixed with
PARAFLU 11 (blue) or with other
fluids. Should this take place, do
not start the engine and contact Al-
fa Romeo Authorized Service.
fig. 6
A0A0407m
ENGINE COOLANT FLUID
(fig. 5)
The level of the coolant in the header tank
(reservoir) should be checked with the en-
gine cold and the car on a level surface and
it should be between the MINandMAX
marks on the tank.
If the level is low, loosen the header tank
cap (A) and slowly pour a mixture of the
fluid specified in the ”Fluids and lubricants”
table in section “Technical Specifications”,
through the filler neck until nearing the
MAXmark; have this operation carried out
at Alfa Romeo Authorised Services.
fig. 5
A0A0240m
The antifreeze mixture contained in the
cooling circuit guarantees protection down
to –40°C.
Do not remove the cap
when the engine is hot:
danger of burns.
WARNING

VEHICLE MAINTENANCE
230
If the oil level in the reservoir is below the
specified one, top up only with one of the
products listed in the “Fluids and lubricants”
table in the “Technical Specifications” chap-
ter proceeding as follows.
– Start the engine and wait for the oil lev-
el in the reservoir to stabilise.
– With the engine running, turn the steer-
ing wheel lock to lock a few times.
– Top up to the MAXlevel notch, then
refit the cap.
Oil consumption is very
low, if topping up again is
needed shortly afterwards,
have the system checked for pos-
sible leaks by Alfa Romeo Autho-
rised Services.BRAKE AND HYDRAULIC
CLUTCH FLUID
(fig. 7)
Slacken the cap (A) and check that the
fluid contained in the reservoir reaches the
maximum mark.
fig. 7
A0A0408m
When loosening the
reservoir cap do not allow
the fluid to come into con-
tact with painted parts. If it does,
wash it off immediately with wa-
ter.
Do not allow the power
steering fluid to touch hot
parts of the engine: it is inflam-
mable.
WARNING

VEHICLE MAINTENANCE
242
CLEANING LEATHER SEATS
– Remove dried on dirt with a lightly
moistened chamois leather or cloth with-
out pressing too hard.
– Remove liquid and grease stains with
a dry absorbent cloth without rubbing. Then
wipe with a soft cloth or chamois leather
with water and neutral soap. If the stain per-
sists, use specific products, carefully follow-
ing the instructions for use.
IMPORTANTNever use alcohol. Make
sure that cleaning products do not contain
alcohol and alcohol derivatives even at low
strength.
INTERIOR PLASTIC PARTS
Use appropriate products designed to pre-
serve the appearance of components.
IMPORTANTNever use spirit or petro-
leum to clean the instrument cluster. Engine compartment
At the end of the winter the engine com-
partment should be carefully washed, with-
out directing the jet against electronic con-
trol units. Contact a specialised workshop to
have this done.
INTERIOR FITTINGS
Periodically check that water is not trapped
under the mats (due to water dripping off
shoes, umbrellas, etc.) which could cause ox-
idisation of the sheet metal.
Detergents cause water
pollution. Therefore the en-
gine compartment should
be washed in areas equipped for
collecting and purifying the liquid
used in the washing process.
IMPORTANTThe vehicle should washed
with the engine cold and the ignition key at
STOP. After washing make sure that the
various protections (e.g. rubber caps and
various covers) have not been damaged or
removed.CLEANING SEATS AND FABRIC
AND VELVET PARTS
– Use a soft brush or vacuum cleaner to
remove dust. Velvet is cleaned better if the
brush is moistened.
– Rub the seats with a sponge moistened
with a solution of water and neutral deter-
gent.
Never use inflammable
products like fuel oil ether
or rectified petrol for cleaning inside
the car. The electrostatic charges
generated when rubbing to clean
may cause fire.
WARNING
Do not keep aerosol cans in
the car. They might ex-
plode. Aerosol cans must never be
exposed to a temperature above
50°C. The temperature inside the
car exposed to the sun may go well
beyond that figure.
WARNING

3.2 V6 24V
63
7
9.2
5.90
2
–
2.5
5.3
TECHNICAL SPECIFICATIONS
254
REFILLING
Specified fuels
Recommended products
Unleaded petrol with no less than 95 R.O.N
(Specification EN228)
Mixture of distilled water and PARAFLU 11
(blue) at 50% or PARAFLU UP(red) at 50%
SELENIA RACING
TUTELA CAR MATRYX
TUTELA CAR CS SPEED
Mixture of water and liquid
TUTELA PROFESSIONAL SC 35
3.2 V6 24V
Selespeed
63
7
9.2
5.90
2
0.6
2.5
5.3
Fuel tank: litres
– including a reserve of litres
Engine cooling
system litres
Oil sump and filter litres
Mechanical gearbox/
differential litres
Selespeed hydraulic control system litres
Windscreen washer and rearscreen
washer fluid reservoir: litres
– with headlamp washer litres

TECHNICAL SPECIFICATIONS
255
FLUIDS AND LUBRICANTS
USABLE PRODUCTS AND THEIR SPECIFICATIONS
IMPORTANTDo not top up with oil with different specifications that the oil already in the engine. Use Quality features of fluids and lubricants Recommended fluids Applications
for correct vehicle operation and lubricants
Lubricants for
petrol engines
SAE 10W-60 engine oil synthetic lubricant
SELENIA RACING
A0M0464m

ALPHABETICAL INDEX
275
Brake and clutch hydraulic fluid
- checking level and topping up.... 230
Brakes
- checking fluid level and
topping up .............................. 230
- handbrake .............................. 108
- specifications .......................... 247
Braking lights
- changing bulbs ........................ 205
Bulbs
- general instructions .................. 196
- replacement............................ 198
- types of bulbs ......................... 196
Card holder ................................ 123
Catalyst ...................................... 174
Cell phones (provision) ................. 125
Changing battery of key with
remote control .......................... 10
Changing bulbs- general information.................. 196
- types of bulbs ......................... 196
Checking levels ............................ 226
- checking level and topping
up brake and clutch fluid........... 230
- checking level and topping
up coolant fluid ....................... 229
- checking level and topping
up engine oil ........................... 227
- checking level and topping
up power steering oil................ 229
- checking level and topping up
windscreen/rearscreen/
headlamp washer fluid ............. 231
Children (carrying safely) .............. 31
Cigar lighter ................................ 122
Cleaning and maintenance
- body ...................................... 240
- car interior .............................. 242
- engine compartment ................ 242- leather seats ........................... 242
- plastic parts ............................ 242
- windows ................................ 241
Climate control, automatic
two-zone.................................. 91
Climate control system.............. 89
- air vents ........................ 89-90
- controls .................................. 93
Clock.......................................... 60
Clutch
- checking fluid level and
topping up .............................. 230
CO
2emissions ............................. 258
CODE card................................... 7
Controls ...................................... 106
Correct use of the car............ 175
Courtesy light .............................. 121
- changing bulbs ........................ 207
Cruise control .............................. 47

ALPHABETICAL INDEX
277
- marking ................................. 244
- specifications .......................... 245
Engine codes ............................... 244
Engine compartment
- bonnet ................................... 130
- washing ................................. 242
Engine coolant fluid
- checking level
and topping up ........................ 231
- temperature gauge and
warning light........................... 52
Engine oil
- checking the level and
topping up .............................. 227
- consumption ........................... 227
Engine starting ............................ 175
- emergency starting .................. 177
- ignition switch ......................... 14
- switching off ........................... 176
- warming the engine ................. 176Engine oil consumption ................. 227
EOBD (system)............................ 139
Environment (safeguarding) .......... 174
- emission reducing devices ......... 174
- reducing running costs
and environment pollution......... 181
- running economy ..................... 183
- safeguarding emission
reduction devices ..................... 184
- use of non-toxic materials ......... 174
Extending the luggage compartment
- partial .................................... 20
- total ...................................... 19
External lights (switching on) ........ 42
First-aid kit................................. 220
Flashing high beams..................... 43
Fluids (specifications) ................... 255
Fluids and lubricants.............. 255-256
Follow me home device ................ 44Foglights
- changing bulbs................. 199-201
- switching on ........................... 106
Front ceiling light ......................... 120
- changing bulbs ........................ 206
Fuel
- automatic shut off switch .......... 107
- consumption ........................... 257
- fuel cap.................................. 173
- level gauge and reserve
warning light........................... 52
- refilling .................................. 173
Fuel flap ..................................... 173
Fuel reserve ................................ 52
Fuel supply (technical data)........... 246
Fuses
- in control box in engine
compartment .......................... 210
- in control box on battery post .... 211