2011 Acura TSX ignition

Opening and Closing the Trunk
Using the Remote Transmitter
96Controls
Using the Remote Transmitter
Press the trunk release button for
approximately one second to unlock and
open the trunk.
Using the Remote Transmitter
When the driver's door is locked:
The trunk will lock when it is closed.
When the driver's door is unlocked:
The trunk will not lock when it is closed.
When the ignition switch is in any position except
LOCK
0
, you cannot open the trunk using the
trunk release button on the remote transmitter.
Push up the release switch on the trunk lid
after the doors are unlocked.
Using the Trunk Release SwitchTrunk
Button
Release
Switch

Security System
98Controls
Immobilizer SystemThe immobilizer system prevents a key that has not been pre-registered from
starting the engine. Each key contains electronic transmitters that use electronic
signals to verify the key.
Pay attention to the following when inserting the key into the ignition switch.
Do not allow objects that emit strong radio waves near the ignition switch. t
Make sure the key is not covered by or touching a metal object. t
Do not bring a key from another vehicle's immobilizer system near the ignition t
switch.
Immobilizer System NOTICE Leaving the ignition key in the vehicle can result in
theft or accidental movement of the vehicle.
Always take the ignition key with you whenever you
leave the vehicle unattended.
Do not alter the system or add other devices to it.
Doing so may damage the system and make your
vehicle inoperable. Security System Alarm
The security alarm continues for a maximum of two
minutes until the security system deactivates.
Security System AlarmThe security system alarm activates when the doors, trunk, or hood are opened
without the key, or remote transmitter. It also activates if you turn the ignition
switch to ON
II
after locking the doors with the remote transmitter.
When the security system alarm activates
The horn sounds intermittently, and all of the exterior lights flash. To deactivate the security system alarm
Unlock the vehicle using the key, or remote transmitter. The system, along with
the horn and flashing lights, are deactivated.

Security System
Security System Alarm
99Controls
Setting the security system alarm
The security system alarm automatically sets when the following conditions have
been met:
The ignition switch is in LOCK t
0
, and the key has been removed from the
ignition switch.
The hood is closed. t
All doors are locked. t
When the security system alarm sets
The security system indicator in the instrument panel blinks. When the blinking
interval changes after about 15 seconds, the security system is set. To cancel the security system alarm
The security system is canceled when the vehicle is unlocked using the key or
remote transmitter. The security system indicator goes off at the same time.
Security System Alarm
Do not set the security system alarm when someone
is in the vehicle or a window is open. The system
can accidentally activate when:
Unlocking the door with the lock tab or the tmaster door lock switch.
Opening the trunk with the release button on the tdriver's door or the emergency trunk opener.

If the battery goes dead after you have set the
security system alarm, the security alarm may go off
once the battery is recharged or replaced.
If this occurs, deactivate the security system alarm
by unlocking a door using the key or remote
transmitter.
Do not attempt to alter this system or add another
device to it.
The panic button on the remote
transmitter
If you press the panic button for
approximately one second, the following will
occur:
The horn sounds. t
Some exterior lights flash for about 30 t
seconds.
Panic Mode Canceling panic mode
Press any button on the remote transmitter, or turn the ignition switch to ON
II
.
Panic
Button

Opening and Closing the Windows
100Controls
Opening/Closing the Power WindowsThe power windows can be opened and closed when the ignition switch is in ON II
, using the switches on the doors. The driver's side switch can be used to open
and close all of the windows.
The main switch on the driver's side must be switched off (not pushed in, indicator
off) to open and close the windows from anywhere other than the driver's seat.
When the main switch is turned on (pushed in, indicator on), you can only operate
the windows from the driver's seat. Turn the main switch on when children are in
the vehicle.
Opening/Closing the Power Windows
WARNING
Closing a power window on someone's
hands or fingers can cause serious injury.
Make sure your passengers are away from
the windows before closing them.
Opening/Closing Windows with Auto-Open/Close Function
The power windows can be operated for up to 10
minutes after you turn the ignition switch off.
Opening either front door cancels this function.
Auto Reverse
If a power window senses resistance when closing
automatically, it will stop closing and reverse
direction.
The driver’s window auto reverse function is
disabled when you continuously pull up the switch.
The auto reverse function stops sensing when
the window is almost closed to ensure that it fully
closes.
Automatic operation
To o p e n : Push the switch down firmly
To close: Pull the switch up firmly.
The window opens or closes completely. To
stop the window at any time, push or pull the
switch briefly. Manual operation
To open: Push the switch down lightly.
To close: Pull the switch up lightly.
Release the switch when the window reaches
the desired position.
ONOFF
Main Switch
Driver’s Window Switch
Indicator
Front Passenger’sWindow Switch

Opening and Closing the Windows
Opening/Closing the Power Windows
101
Continued
Controls
Opening/Closing Windows without Auto-Open/Close Function Opening Windows and Moonroof with the Remote
Tra n s m i t t e r
To o p e n : Press the UNLOCK button twice
within 10 seconds and hold it down for the
second time. If the windows stop midway,
repeat the procedure.
Opening Windows and Moonroof with the Remote Transmitter
You cannot operate the power windows with the
remote transmitter when the key is in the ignition
switch.
To open: Push the switch down.
To close: Pull the switch up.
Release the switch when the window reaches
the desired position.
Unlock
Button
Close
Open

103
Opening and Closing the Moonroof
Controls
Opening/Closing the Moonroof
You can only operate the moonroof when the ignition switch is in ON
II
. Use the
switch in the front of the ceiling to open and close the moonroof.
Automatic operation
To open: Pull the switch back firmly, then
release.
To close: Push the switch forward firmly,
then release.
The moonroof will automatically open or
close all the way. To stop the moonroof
midway, touch the switch briefly. Manual operation
To open: Pull the switch back, and hold it
until the desired position is reached.
To close: Push the switch forward, and hold
it until the desired position is reached. Tilting the moonroof up
To tilt: Push on the center of the moonroof
switch.
To close: Push the switch forward firmly,
then release.
WARNING
Opening or closing the moonroof on
someone's hands or fingers can cause
serious injury.
Make sure all hands and fingers are clear
of the moonroof before opening or
closing it. Opening/Closing the Moonroof NOTICE Opening the moonroof in below freezing
temperature or when it is covered with snow or ice
can damage the moonroof panel or motor.
The power moonroof can be operated for up to 10
minutes after you turn the ignition switch off.
Opening either front door cancels this function.
When resistance is detected, the auto reverse
function causes the moonroof to change directions,
then stop. Auto reverse stops sensing when the
moonroof is almost closed to ensure that it fully
closes. Make sure that all objects, including fingers,
are clear of the moonroof.

Operating the Switches Around the Steering Wheel
104Controls
0 LOCK: Insert and remove the key in this
position.
I ACCESSORY: Operate the audio system and
other accessories in this position.
II ON: This is the position when driving.

III
START: This position is for starting the engine.
The switch returns to ON
II when you let go of
the key.
Ignition Switch
Ignition Switch Manual transmission models
Automatic transmission models You cannot take the key out unless the shift lever is
in
P.
All models If you open the driver's door when the key is in
LOCK
0 or ACCESSORY
I , a warning buzzer will
sound to remind you to take the key out.
When this happens, the following messages appear
on the multi-information display:
In LOCK
t
0 : "REMOVE KEY."
In ACCESSORY
t
I : "REMOVE KEY" The buzzer
will stop when you take the key out.
If the key won't turn from LOCK
0 to ACCESSORY
I, turn the key while moving the steering wheel
left and right. The steering wheel will unlock,
allowing the key to turn.
WARNING
Removing the key from the ignition switch
locks the steering. If you do this while the
vehicle is in motion, you can lose control
of the vehicle.
Only remove the key from the ignition
switch when parked.

105
Continued
Controls
Operating the Switches Around the Steering Wheel
Turn Signals
Light Switches
Turn Signals
The turn signals can be used when the
ignition switch is in ON
II
.
Rotating the light switch turns the lights on
and off, regardless of the position of the
ignition switch.
High beams
Push the lever forward until you hear a click. Low beams
When in high beams, pull the lever back to
return to low beams. Flashing the high beams
Pull the lever back, and release it.
Manual Operation
Light Switches
If you remove the key from the ignition switch while
the light is on, a chime sounds when the driver’s
door is opened.
When the lights are on, the lights on indicator in
the instrument panel will be on.
Indicators


P. 6 4
Repeatedly turning the headlights on and off
reduces the life of the HID headlight bulbs.
If you sense that the level of the headlights is
abnormal, have the vehicle inspected by a dealer.
Do not leave the lights on when the engine is off
because it will cause the battery to discharge.
Light Switches
Right Turn
Left Turn
High Beams
Low BeamsFlashing the
high beams
Turns on side marker, tail and
license plate lights Turns on headlights, parking,
side marker, tail, and license
plate lights