Page 70 of 324
69Instrument Panel
Indicators
Continued
Indicator Name On/Blinking Explanation Message
System Message
Indicator t $ P N F T P O B M P O H X J U I B C F F Q X I F O
a problem is detected. A system
message on the multi-information
display appears at the same time. t 8 I J M F U I F J O E J D B U P S J T P O
Q S F T T U I F
(information) button to see
the message again.
t 3 F G F S U P U I F * O E J D B U P S T J O G P S N B U J P O J O
this chapter when a system message
appears on the multi-information
display. Take the appropriate action
for the message.
t 5 I F N V M U J J O G P S N B U J P O E J T Q M B Z E P F T
not return to the normal screen
unless the warning is canceled, or the button is pressed.
—
Turn Signal
Indicators t 5 I F U V S O T J H O B M J O E J D B U P S T C M J O L
when you operate the turn signal
lever.
t * G Z P V Q S F T T U I F I B [ B S E X B S O J O H
button, both indicators and all turn
signals blink at the same time. t Does not blink or blinks rapidly-
A turn signal light bulb has blown.
Change the bulb immediately.
Replacing Light Bulbs P.252, 253
—
High-Beam
Indicator t $ P N F T P O X I F O U I F I J H I C F B N
headlights are on.
t $ P N F T P O X J U I S F E V D F E C S J H I U O F T T
when DRL (daytime running lights)
are on.—
—
Lights On
Indicator t $ P N F T P O X I F O F W F S U I F M J H I U
switch is on, or in AUTO when the
exterior lights are on. t * G Z P V S F N P W F U I F L F Z G S P N U I F
ignition switch while the light is on, a
chime sounds when the driver's door
is opened.
—
Page 73 of 324
Indicators
Multi-Information Display Warning and Information Messages
72Instrument Panel
Multi-Information Display Warning and Information Messages
Message Condition Explanation
t " Q Q F B S T X I F O U I F F O H J O F D P P M B O U U F N Q F S B U V S F H F U T
abnormally high.
Overheating P. 2 8 8
t " Q Q F B S T X I F O U I F G V F M m M M D B Q J T M P P T F P S J T O P U
installed.
Tighten the Fuel Fill Cap P. 2 9 1
t " Q Q F B S T J G U I F S F J T B Q S P C M F N X J U I U I F % 3 - T Z T U F N t ) B W F Z P V S W F I J D M F D I F D L F E C Z B E F B M F S
Daytime Running Lights P.1 0 7
Canadian models
t " Q Q F B S T X I F O X B T I F S n V J E H F U T M P X t 3 F m M M J O H X B T I F S G V J M E
Refilling Window Washer Fluid P. 2 4 6
The following messages appear only on the multi-information display. Press the
(information) button to see the message
again with the system message indicator on.
Page 74 of 324
73Instrument Panel
Indicators
Multi-Information Display Warning and Information Messages
Message Condition Explanation
t " Q Q F B S T X I F O U I F T D I F E V M F E N B J O U F O B O D F J T E V F T P P O
t $ P O T F R V F O U M Z
4 & 3 7 * $ & % 6 & / 0 8 B O E 4 & 3 7 * $ &
PAST DUE" follow.
Maintenance Minder
™ P. 2 2 5
t " Q Q F B S T X I F O Z P V P Q F O U I F E S J W F S h T E P P S X I J M F U I F
ignition key is in ACCESSORY
I. t 5 V S O U I F J H O J U J P O T X U J D I U P - 0 $ ,
0
, then
remove the key.
t " Q Q F B S T X I F O U I F J H O J U J P O L F Z J T U V S O F E U P " $ $ & 4 4 0 3 :
I from ON
II
. (The driver's door is closed.)
—
t " Q Q F B S T X I F O Z P V P Q F O U I F E S J W F S h T E P P S X I J M F U I F
ignition key is in LOCK
0
. t 3 F N P W F U I F L F Z G S P N U I F J H O J U J P O T X J U D I
Continued
Page 75 of 324
74Instrument Panel
Indicators
Multi-Information Display Warning and Information Messages
Message Condition Explanation
6-cylinder models U.S. Canada
t " Q Q F B S T X I F O U I F T U B S U F S T Z T U F N I B T B Q S P C M F N t " T B U F N Q P S B S Z N F B T V S F
I P M E U I F J H O J U J P O
switch to START
III
for up to 15 seconds and
start the engine. Have the vehicle checked by
a dealer.
Page 77 of 324
Gauges and Multi-Information Display
Multi-Information Display
76Instrument Panel
Multi-Information DisplayThe multi-information display shows the odometer, trip meter, outside temperature
indicator, and other gauges.
It also displays important messages such as warnings and other helpful information.
Switching the Display
Press the
(information) button or the SEL /RESET button to change the
display.
* Not available on all models
Button
SEL/RESET Button
OdometerEngine Oil Life
Outside Temperature Trip B Trip A
: Press the
button. Trip Computer
: Press the SEL/RESET button.
Shown when Bluetooth
®
HandsFreeLink
® is activated.Tire Pressure
for each tireHFL
*
Page 101 of 324
Opening and Closing the Windows
100Controls
Opening/Closing the Power WindowsThe power windows can be opened and closed when the ignition switch is in ON II
, using the switches on the doors. The driver's side switch can be used to open
and close all of the windows.
The main switch on the driver's side must be switched off (not pushed in, indicator
off) to open and close the windows from anywhere other than the driver's seat.
When the main switch is turned on (pushed in, indicator on), you can only operate
the windows from the driver's seat. Turn the main switch on when children are in
the vehicle.
Opening/Closing the Power Windows
WARNING
Closing a power window on someone's
hands or fingers can cause serious injury.
Make sure your passengers are away from
the windows before closing them.
Opening/Closing Windows with Auto-Open/Close Function
The power windows can be operated for up to 10
minutes after you turn the ignition switch off.
Opening either front door cancels this function.
Auto Reverse
If a power window senses resistance when closing
automatically, it will stop closing and reverse
direction.
The driver’s window auto reverse function is
disabled when you continuously pull up the switch.
The auto reverse function stops sensing when
the window is almost closed to ensure that it fully
closes.
Automatic operation
To o p e n : Push the switch down firmly
To close: Pull the switch up firmly.
The window opens or closes completely. To
stop the window at any time, push or pull the
switch briefly. Manual operation
To open: Push the switch down lightly.
To close: Pull the switch up lightly.
Release the switch when the window reaches
the desired position.
ONOFF
Main Switch
Driver’s Window Switch
Indicator
Front Passenger’sWindow Switch
Page 104 of 324
103
Opening and Closing the Moonroof
Controls
Opening/Closing the Moonroof
You can only operate the moonroof when the ignition switch is in ON
II
. Use the
switch in the front of the ceiling to open and close the moonroof.
Automatic operation
To open: Pull the switch back firmly, then
release.
To close: Push the switch forward firmly,
then release.
The moonroof will automatically open or
close all the way. To stop the moonroof
midway, touch the switch briefly. Manual operation
To open: Pull the switch back, and hold it
until the desired position is reached.
To close: Push the switch forward, and hold
it until the desired position is reached. Tilting the moonroof up
To tilt: Push on the center of the moonroof
switch.
To close: Push the switch forward firmly,
then release.
WARNING
Opening or closing the moonroof on
someone's hands or fingers can cause
serious injury.
Make sure all hands and fingers are clear
of the moonroof before opening or
closing it. Opening/Closing the Moonroof NOTICE Opening the moonroof in below freezing
temperature or when it is covered with snow or ice
can damage the moonroof panel or motor.
The power moonroof can be operated for up to 10
minutes after you turn the ignition switch off.
Opening either front door cancels this function.
When resistance is detected, the auto reverse
function causes the moonroof to change directions,
then stop. Auto reverse stops sensing when the
moonroof is almost closed to ensure that it fully
closes. Make sure that all objects, including fingers,
are clear of the moonroof.
Page 105 of 324
Operating the Switches Around the Steering Wheel
104Controls
0 LOCK: Insert and remove the key in this
position.
I ACCESSORY: Operate the audio system and
other accessories in this position.
II ON: This is the position when driving.
III
START: This position is for starting the engine.
The switch returns to ON
II when you let go of
the key.
Ignition Switch
Ignition Switch Manual transmission models
Automatic transmission models You cannot take the key out unless the shift lever is
in
P.
All models If you open the driver's door when the key is in
LOCK
0 or ACCESSORY
I , a warning buzzer will
sound to remind you to take the key out.
When this happens, the following messages appear
on the multi-information display:
In LOCK
t
0 : "REMOVE KEY."
In ACCESSORY
t
I : "REMOVE KEY" The buzzer
will stop when you take the key out.
If the key won't turn from LOCK
0 to ACCESSORY
I, turn the key while moving the steering wheel
left and right. The steering wheel will unlock,
allowing the key to turn.
WARNING
Removing the key from the ignition switch
locks the steering. If you do this while the
vehicle is in motion, you can lose control
of the vehicle.
Only remove the key from the ignition
switch when parked.
