2011 Acura TSX tow

227
Maintenance
Continued
Maintenance Minder™
Maintenance Service ItemsCODE Maintenance Main Items
A Replace engine oilt
*1
B Replace engine oilt
*1 and oil filter
Inspect front and rear brakes t
Check parking brake adjustment t
Inspect tie rod ends, steering gear box, and boots t
Inspect suspension components t
Inspect driveshaft boots t
Inspect brake hoses and lines (Including ABS) t
*OTQFDU
BMM
nVJE
MFWFMT
BOE
DPOEJUJPO
PG
nVJET t
Inspect exhaust system t
#
Inspect fuel lines and connections t
#
CODE Maintenance Sub Items
1 Rotate tirest
2 Replace air cleaner elementt
*2
Replace dust and pollen filter t
*3
Inspect drive belt t
33FQMBDF
USBOTNJTTJPO
nVJE t
*4
4 Replace spark plugst
Replace timing belt and inspect water pump t
*5
Inspect valve clearance t
5 Replace engine coolantt
*4: If you drive regularly in mountainous areas or tow a trailer, replace the transmission fluid at 60,000
miles (100,000 km), then every 30,000 miles (48,000 km). (automatic transmission models only)
*5: If you drive regularly in very high temperatures (over 110 °F, 43 °C ), in very low temperatures (under
-20 °F, -29 °C), or tow a trailer, replace every 60,000 miles/100,000 km. (6-cylinder models only)
#: See information on maintenance and emissions warranty. *1: Change the engine oil according to the Maintenance Minder, or annually, whichever comes first.
*2: If you drive primarily in dusty conditions, replace the air cleaner element every 15,000 miles (24,000
km).
*3: If you drive primarily in urban areas that have high concentrations of soot in the air from industry and
from diesel-powered vehicles, replace the dust and pollen filter every 15,000 miles (24,000 km).
Maintenance Service Items
Independent of the Maintenance Minder tinformation, replace the brake fluid every 3 years.
Inspect idle speed every 160,000 miles (256,000 tkm).
Adjust the valves during services A, B, 1, 2, or 3 tonly if they are noisy. Maintenance Minder
Message System Message
Indicator
Main Items
Sub Items

Maintenance Under the Hood
Opening the Hood
231
Continued
Maintenance
Opening the Hood
1. Park the vehicle on a level surface, and set
the parking brake.
2. Pull the hood release handle under the
lower left corner of the dashboard.

The hood will pop up slightly.
3. Push up the hood latch lever in the center
of the hood to release the lock mechanism,
and open the hood.
4-cylinder models 4. Remove the support rod from the clamp
using the grip. Mount the support rod in
the hood.
When closing, remove the support rod, and
stow it in the clamp, then gently lower the
hood. Remove your hand at a height of
approximately 12 inches (30 cm) and let the
hood close.
Opening the Hood NOTICE Do not open the hood when the wiper arms are
raised.
The hood will strike the wipers, and may damage
either the hood or the wipers.
When closing the hood, check that the hood is
securely latched.
If the hood latch lever moves stiffly, or if you can
open the hood without lifting the lever, the latch
mechanism should be cleaned and lubricated.
Grip
ClipSupport Rod
Hood Release Handle
Pull
Lever

Maintenance Under the Hood
Oil Check
235
Continued
Maintenance
Oil CheckWe recommend that you check the engine oil level every time you refuel.

Park the vehicle on level ground.
Wait approximately three minutes after turning the engine off before you check
the oil.
4-cylinder models 1. Remove the dipstick (orange handle). 6-cylinder models 1. Remove the dipstick (orange loop). All models 2. Wipe the dipstick with a clean cloth or
paper towel.
3. Insert the dipstick back all the way into its
hole.
Oil Check
If it is near or below the lower mark, slowly add oil
being careful not to overfill.
6-cylinder models 4-cylinder models

247
Replacing Light Bulbs
Continued
Maintenance
When replacing, use the following bulbs.
High beam headlight: 60W (HB3)
Low beam headlight: 55W (H1 for halogen bulb Type)
35W (D2S for high voltage discharge type)
High Beam Headlight
6-cylinder models 1. Remove all the engine compartment
covers.
Engine Compartment Covers

P. 2 3 3
Passenger side
All models 2. Remove the engine coolant reservoir.
Headlight Bulbs NOTICE Halogen bulbs get very hot when lit.
Oil, perspiration, or a scratch on the glass can cause
the bulb to overheat and shatter.
The headlight aim is set by the factory, and typically
does not need to be adjusted. However, if you
regularly carry heavy items in the trunk or tow a
trailer, have the aiming readjusted at a dealer or by
a qualified technician.
The HB3 and H1 types are halogen bulbs.
When replacing a bulb, handle it by its base, and
protect the glass from contact with your skin or
hard objects. If you touch the glass, clean it with
denatured alcohol and a clean cloth.
Headlight Bulbs
Engine Coolant
ReservoirEngine Coolant
Reservoir
6-cylinder models 4-cylinder models

Battery
268Maintenance
Checking the Battery
Check the battery condition monthly. Look
at the test indicator window and check the
terminals for corrosion.
If your vehicle's battery is disconnected or goes dead:
The audio system is disabled. t
Entering the audio security code

P.14 0
The clock resets. t
Setting the Clock

P. 8 8
The navigation system is disabled. A PIN code will be required. t
Refer to the navigation system manual

Charging the BatteryDisconnect both battery cables to prevent damaging your vehicle's electrical
system. Always disconnect the negative (-) cable first, and reconnect it last.
BatteryWARNING: Battery post, terminals, and
related accessories contain lead and lead
compounds.
Wash your hands after handling.The test indicator's color information is on the
battery.
When you find corrosion, clean the battery terminals
by applying a baking powder and water solution.
Rinse the terminals with water. Cloth/towel dry
the battery. Coat the terminals with grease to help
prevent future corrosion.
WARNING
The battery gives off explosive hydrogen
gas during normal operation.
A spark or flame can cause the battery
to explode with enough force to kill or
seriously hurt you.
Wear protective clothing and a face
shield, or have a skilled technician do any
battery maintenance.
Test Indicator Window

Handling the Unexpected
This chapter explains how to handle unexpected troubles.
To o l s ..................................................... 276
Types of Tools .....................................276
If a Tire Goes Flat ................................ 277
Changing a Flat Tire ........................... 277
Engine Does Not Start
Checking the Engine .......................... 283
Jump Starting ..................................... 284
Shift Lever Does Not Move ............... 287
Overheating ........................................ 288
How to Handle Overheating .............. 288Indicator, Coming On/Blinking
If the Low Oil Pressure Indicator
Comes On ........................................ 290
If the Charging System Indicator
Comes On ........................................ 290
If the Malfunction Indicator Lamp
Comes On or Blinks .......................... 291
If the Brake System Indicator
Comes On ........................................ 292
If the EPS Indicator Comes On ........... 292
If the Low Tire Pressure/ TPMS Indicator
Comes On or Blinks .......................... 293Fuses
Fuse Locations ................................... 294
Inspecting and Changing Fuses .......... 297
Emergency Towing ............................. 298
When You Cannot Unlock the Fuel
Fill Door ............................................. 299
When You Cannot Open the
Trunk .................................................. 300
275

283
Engine Does Not Start
Handling the Unexpected
Checking the EngineIf the engine does not start, turn the ignition switch to START III
and check the
starter.
Checking the Engine
If you must start the vehicle immediately, use an
assisting vehicle to jump start it.
Jump Starting


P. 2 8 4

Starter condition Checklist
Starter doesn't turn or turns
over slowly.
The battery may be dead. Check
each of the items on the right and
respond accordingly.Check brightness of the interior light.
Turn on interior lights and check brightness.
If the interior lights are dim or do not come on at all t
 Battery Inspection and Maintenance P. 2 6 8
If the interior lights come on normally t
Fuse Inspection and Replacement
P. 2 9 4
The starter turns over normally
but the engine doesn't start.
There may be a problem with the
fuse. Check each of the items on
the right and respond accordingly.Review the engine start procedure.
Follow its instructions, and try to start the engine again.
Starting the Engine P.1 9 1
Check the immobilizer system indicator.
When the immobilizer system indicator is blinking, the engine cannot be started.
 Immobilizer System P. 9 8
Check the fuel level.
There should be enough fuel in the tank.
Fuel Gauge P. 7 5
Check the fuse.
Check all fuses, or have the vehicle checked by a dealer.
 Inspecting and Changing Fuses P. 2 9 7
If the problem continues:
 Emergency Towing P. 2 9 8

Emergency Towing
298Handling the Unexpected
Call a professional towing service if you need to tow your vehicle.
Flat bed equipment
The operator loads your vehicle on the back of a truck.
This is the best way to transport your vehicle. Wheel lift equipment
The tow truck uses two pivoting arms that go under the front tires and lift them
off the ground. The rear tires remain on the ground. This is an acceptable way
to tow your vehicle.
Emergency Towing NOTICE Trying to lift or tow your vehicle by the bumpers
will cause serious damage. The bumpers are not
designed to support the vehicle's weight. NOTICE Improper towing such as towing behind a
motorhome or other motor vehicle can damage the
transmission.
Never tow your vehicle with just a rope or chain.
It is very dangerous, since ropes or chains may shift
from side to side or break.