Page 17 of 224
15
FAMILIARISATION
  MONITORING 
   
Instrument panel    
Switch panel 
 
 
 
A. 
  With the ignition on, the fuel gauge 
needle should rise. 
   
B. 
  With the engine running, the associ-
ated low level warning lamp should 
switch off. 
   
C. 
  With the ignition on, the oil level in-
dicator should display  "OIL OK" 
 for 
a few seconds.  
  If the levels are not correct, top up the 
level which is low. 
   
 
  
 20  
   Lighting of the indicator lamp indicates 
the status of the corresponding function. 
   
 
A. 
  Deactivation of the ESP/ASR system.  
  
 
 
 97  
   
B. 
 Central locking.  
  
 74  
   
C. 
  Deactivation of the interior volumetric 
protection alarm.  
  
 
 
 69  
 
     
 
1. 
  With the ignition on, the orange and 
red warning lamps come on. 
   
2. 
 With the engine running, these 
warning lamps should switch off.  
  If a warning lamp remains on, refer to 
the page concerned. 
   
 
  
 21  
 
 
 
Warning lamps  
     
        
        Page 21 of 224

19
   
Limit the causes of excess 
consumption 
   
Spread loads throughout the vehicle; 
place the heaviest items in the bottom 
of the boot, as close as possible to the 
rear seats. 
  Limit the loads carried in the vehicle 
and reduce wind resistance (roof bars, 
roof rack, bicycle carrier, trailer...). Use 
a roof box in preference. 
  Remove roof bars and roof racks after 
use.  
   
At the end of winter, remove snow 
tyres and refi t your summer tyres.  
 
 
 
Observe the recommendations 
on maintenance 
   
Check the tyre pressures regularly, 
when cold, referring to the label in the 
door aperture, driver’s side. 
  Carry out this check in particular: 
   
 
-   before a long journey, 
   
-   at each change of season, 
   
-   after a long period out of use.  
  Don’t forget the spare wheel and the 
tyres on any trailer or caravan.  
   
Have your vehicle serviced regularly 
(engine oil, oil fi lter,  air fi lter...)  and  ob-
serve the schedule of operations rec-
ommended by the manufacturer.  
 
    
When refuelling, do not continue after 
the 3 rd  cut-off of the nozzle to avoid 
any overfl ow.  
   
At the wheel of your new vehicle, 
it is only after the fi rst 1 800 miles 
(3 000 kilometres) that you will see the 
fuel consumption settle down to a con-
sistent average.  
  
     
        
        Page 22 of 224

1INSTRUMENTS and CONTROLS
20
PETROL - DIESEL, MANUAL OR AUTOMATIC GEARBOX,
INSTRUMENT PANELS 
  Panel which groups together the vehicle operation dials and indicator lamps. 
   
5. 
  Screen. 
 
   
6. 
  Display zero reset button. 
 
 
  Resets the selected function to 
zero (trip distance recorder or 
service indicator). 
   
7. 
  Instrument panel lighting button. 
 
 
  Adjusts the brightness of the 
lighting of the instruments and 
controls. 
   
8. 
  Automatic gearbox. 
 
 
  Indicates the programme selected 
and the gear engaged.  
 
 
Dials 
 
 
 
1. 
  Rev counter. 
 
 
  Indicates the speed of rotation of 
the engine (x 1 000 rpm). 
   
2. 
  Fuel gauge. 
 
 
  Indicates the quantity of fuel 
remaining in the tank. 
   
3. 
  Coolant temperature. 
 
 
  Indicates the temperature of the 
engine coolant (°Celsius). 
   
4. 
  Speedometer. 
 
 
  Indicates the current speed of the 
moving vehicle (mph or km/h).    
 
A. 
  Speed limiter 
 
 
 or  
  Cruise control. 
 
 
  (mph or km/h) 
   
B. 
  Trip distance recorder. 
 
 
  (miles or km/h) 
   
C. 
  Service indicator. 
 
 
  (miles or km/h) then,  
  Engine oil level indicator. 
 
 
   
 then  
  Distance recorder. 
 
 
  (km or miles)  
  These three functions are displayed 
in succession when the ignition is 
switched on.  
  For more information, refer to the section 
which corresponds to the function and to 
the display associated with it.  
     
Screen  
     
        
        Page 26 of 224

1
!
INSTRUMENTS and CONTROLS
24
   
 
 
 
 
 
 
 
 
 
Warning lamps 
 
When the engine is running or the vehicle is 
being driven, the illumination of one of the fol-
lowing warning lamps indicates a fault which 
requires action on the part of the driver.   Any fault resulting in the illumination of a warning lamp must be investigated 
further by reading the associated message in the multifunction screen. 
  If you encounter any problems, do not hesitate to contact a PEUGEOT dealer 
or a qualifi ed workshop.  
 
   
 
Warning lamp 
 
   
 
is on 
 
   
 
Cause 
 
   
 
Action/Observations 
 
 
   
 
STOP 
 
 
 
 
fi xed, alone or 
associated with 
another warning lamp, 
accompanied by an 
audible signal and a 
message on the screen.   
Illumination of the warning 
lamp is associated with a 
serious braking system or 
engine coolant temperature 
problem.   Stop as soon as it is safe to do so as the engine 
may cut out when driving. 
  Park, switch off the ignition and call a PEUGEOT 
dealer or a qualifi ed workshop. 
   
 
Service 
 
    
temporarily.    Minor problems have 
occurred for which there is 
no specifi c warning lamp.   Identify the problem by reading the message 
shown in the screen, such as, for example: 
   
 
-   the engine oil level, 
   
-   the screenwash level, 
   
-   the remote control battery, 
   
-  
saturation of the particle emission fi lter on Diesel 
vehicles (see "Checks - § particle emissions fi lter").  
 
For any other faults, contact a PEUGEOT dealer 
or a qualifi ed workshop. 
   
fi xed.    Major problems have 
occurred for which there is 
no specifi c warning lamp.   Identify the problem by reading the message 
shown in the screen and contact a PEUGEOT 
dealer or a qualifi ed workshop. 
   
 
Braking 
 
    
fi xed, associated 
with the STOP 
warning lamp.    The braking system fl uid 
level is too low.   You must stop as soon as it is safe to do so.   Top 
up with brake fl uid recommended by PEUGEOT.  
  If the problem persists, have the system checked 
by a PEUGEOT dealer or a qualifi ed workshop. 
   
+     
fi xed, associated 
with the STOP and 
ABS warning lamp.    The electronic brake force 
distribution (EBFD) system 
has a fault.   You must stop as soon as it is safe to do so. 
  Have it checked by a PEUGEOT or a qualifi ed 
workshop.  
     
        
        Page 28 of 224

1INSTRUMENTS and CONTROLS
26
   
 
Warning lamp 
 
   
 
is on 
 
   
 
Cause 
 
   
 
Action/Observations 
 
 
   
 
Maximum 
coolant 
temperature 
 
    
fi xed red.    The temperature of the 
cooling system is too high.   Stop as soon as it is safe to do so. 
  Wait until the engine has cooled down before 
topping up the level, if necessary. 
  If the problem persists, contact a PEUGEOT 
dealer or qualifi ed workshop. 
   
 
Engine oil 
pressure 
 
    
fi xed.    There is a fault with the 
engine lubrication system.   You must stop as soon it is safe to do so. 
  Park, switch off the ignition and contact a 
PEUGEOT dealer or a qualifi ed workshop. 
 
 
 
  
 
 
Battery 
charge 
 
*  
    
fi xed.    The battery charging circuit 
has a fault (dirty or loose 
terminals, slack or cut 
alternator belt, ...).   The warning lamp should go off when the engine 
is started. 
  If it does not go off, contact a PEUGEOT dealer 
or a qualifi ed workshop. 
   
 
Door(s) 
open 
 
    
fi xed if the 
speed is 
below 6 mph 
(10 km/h).  
  A door, the boot or the rear 
screen is still open.   Close the door or boot.     
fi xed and 
accompanied 
by an audible 
signal if the 
speed is 
above 6 mph 
(10 km/h).  
   
*  
 According to destination country.   
     
        
        Page 32 of 224

1
i
INSTRUMENTS and CONTROLS
30
  The level shown will only be correct 
if the vehicle is on level ground and 
the engine has been off for more 
than 30 minutes. 
   
 
 
 
 
 
 
 
 
 
 
 
 
 
 
Engine oil level indicator 
 
System which informs the driver whether 
the engine oil level is correct or not. 
  This information is indicated for a few 
seconds when the ignition is switched 
on, after the service information.    
Oil level correct  
   
Oil level low    
Oil level indicator fault 
   
Dipstick 
  This is indicated by the fl ashing  of 
  "OIL" 
, linked with the service warning 
lamp, accompanied by an audible sig-
nal and a message in the multifunction 
screen. 
  If the low oil level is confi rmed by a 
check using the dipstick, the level must 
be topped up to prevent damage to the 
engine.    This is indicated by the fl ashing  of 
  "OIL--" 
. Contact a PEUGEOT dealer or 
a qualifi ed workshop.  
  Refer to the "Checks" section to locate 
the dipstick and the oil fi ller cap on your 
engine. 
  There are 2 marks on the 
dipstick: 
   
 
-   A 
 = max; never exceed 
this level (risk of dam-
age to the engine), 
   
-   B 
 = min; top up the lev-
el via the oil fi ller  cap, 
using the grade of oil 
suited to your engine.  
 
  
     
        
        Page 80 of 224

3
DIESEL
ACCESS
78
   
 
 
 
 
 
 
 
 
 
Quality of the fuel used for 
petrol engines    
 
 
 
 
 
 
 
 
 
 
Quality of the fuel used for 
Diesel engines 
   
The petrol engines are perfectly com-
patible with E10 or E24 type petrol 
  biofuels (containing 10 % or 24 % etha-
nol), conforming to European standards 
EN 228 and EN 15376. 
  E85 type fuels (containing up to 85 % 
ethanol) are reserved exclusively for ve-
hicles marketed for the use of this type 
of fuel (BioFlex vehicles). The quality of 
the ethanol must comply with European 
standard EN 15293. 
  For Brazil only, special vehicles are 
marketed to run on fuels containing up 
to 100 % ethanol (E100 type).  
    
The Diesel engines are perfectly com-
patible with biofuels which conform to 
current and future European standards 
(Diesel fuel which complies with stand-
ard EN 590 mixed with a biofuel which 
complies with standard EN 14214) 
available at the pumps (containing up 
to 7 % Fatty Acid Methyl Ester). 
  The B30 biofuel can be used in cer-
tain Diesel engines; however, this use 
is subject to strict application of the 
special servicing conditions. Contact a 
PEUGEOT dealer or a qualifi ed  work-
shop. 
  The use of any other type of (bio)fuel 
(vegetable or animal oils, pure or diluted, 
domestic fuel...) is strictly prohibited 
(risk of damage to the engine and fuel 
system).  
  
     
        
        Page 120 of 224
8CHECKS
118
PETROL ENGINES 
  The caps and covers provide access for checking the levels of the various fl uids and to replace certain components. 
   
 
1. 
 Coolant reservoir. 
   
2. 
 Passenger compartment fi lter. 
   
3. 
  Screenwash and headlamp wash 
reservoir.    
4. 
 Air fi lter. 
   
5. 
 Brake fl uid reservoir. 
   
6. 
 Fusebox.    
7. 
 Battery. 
   
8. 
  Engine oil dipstick. 
   
9. 
 Engine oil fi ller cap.