2011.5 Peugeot 207 CC ignition
[x] Cancel search: ignitionPage 7 of 224
ii
5
FAMILIARISATION
OPENING
Remote control key
A.
Unfolding/Folding the key.
B.
Unlocking the vehicle.
C.
Unlocking and partially opening the
boot.
65
Also...
D.
Normal locking
or
Deadlocking the vehicle.
Fuel tank
1.
Opening the fuel fi ller fl ap.
2.
Opening and hooking the fuel fi ller
cap.
Capacity of the tank: approximately
50 litres (petrol) or 48 litres (Diesel).
77
Boot
From outside
From inside
1.
Unlocking the vehicle or unlocking
the boot.
2.
Opening the tailgate.
1.
Key in the ignition switch.
2.
Unlocking using the manual cen-
tralised control or the door opening
control.
76
On Diesel vehicles, the fuel fi ller
neck incorporates a misfuel preven-
tion device which prevents fi lling
with petrol.
79
Page 8 of 224
! !
i
6
FAMILIARISATION
OPENING
Retractable roof
When washing your vehicle:
- lock the vehicle,
- avoid spraying the upper part
of the windows,
- keep the end of the high-pres-
sure nozzle at least 1 metre
from the windows and door
seals.
After washing the vehicle or fol-
lowing rain, wait until the roof has
dried before opening it. The roof is operated under the
sole responsibility of the driver.
During operation of the roof, to
avoid the risk of injury, ensure
that no one is in the vicinity of the
moving parts.
You are strongly advised not to
operate the roof in strong winds. It is preferable to operate the roof
with the engine running.
The roof can be operated at
speeds below 6 mph (10 km/h).
It is only possible to carry out the
operation twice with the engine off,
to prevent discharging of the bat-
tery.
Preliminary conditions
)
Switch on the ignition.
)
Ensure that:
- the vehicle is not in energy econo-
my mode (refer to the correspond-
ing section),
- the battery voltage is suffi cient
(switching on of the indicator lamp
on the roof control),
- the roof fuse is in good condition (re-
fer to the corresponding section),
- the electric windows are initialised
(refer to the corresponding section),
- the ambient temperature is above
-15 °C.
Precautions to be taken before
operating the roof
)
Park the vehicle on level ground.
)
Check that no object could hinder
the operation of the roof:
- nothing should be placed on the
moving rear shelf 1
or on the net 2
,
- if luggage is being carried in the
boot, it must not raise the net,
)
Ensure that the net 2
is secure.
)
Close the boot correctly.
Maintenance
Carry out a complete roof opera-
tion at least once a month to keep
it in good working order.
Page 9 of 224
i
!
!
7
FAMILIARISATION
OPENING
Operating the retractable roof
Opening the roof
)
Pull this control until the roof
is fully open.
Closing the roof
)
Press this control until the
roof is fully closed.
If you continue to pull or press this
button after the end of the operation,
the four windows close.
Do not release the roof control during
a roof operation.
However, in the event of danger, re-
lease the control, the roof stops; then,
when the danger is no longer present,
complete the required operation.
If the operation has not been com-
pleted, you will be warned by an au-
dible signal and a message on the
multifunction screen. These will be
repeated when the vehicle reaches a
number of speed thresholds.
Changing to "cabriolet"
confi guration:
- the four windows lower,
- the boot opens,
- the roof folds into the boot,
- the boot closes.
The electric window controls and
the control for the four windows
are deactivated during roof opera-
tions.
The roof electronic control unit
may stop the current operation
as a precaution (example: door
movement and roof operation in
quick succession). In this case,
release the control then activate
it again to complete the required
operation.
Operating fault
If a malfunction of the roof occurs,
apply the parking brake, switch
off the ignition, restart the engine,
then start the required operation
again.
If the problem persists, contact a
PEUGEOT dealer.
Changing to "coupé" confi guration:
- the four windows lower,
- the boot opens,
- The roof opens out and locks auto-
matically,
- the boot closes. The end of the operation is confi rmed
by an audible signal and a message on
the multifunction screen.
The end of the operation is confi rmed
by an audible signal and a message on
the multifunction screen.
Page 11 of 224
9
FAMILIARISATION
INSTRUMENTS AND CONTROLS
1.
Audio equipment steering mounted
control.
2.
Steering lock and ignition.
3.
Wipers/screenwash/trip computer
control stalk.
4.
Instrument panel.
5.
Driver’s airbag.
Horn.
6.
Dynamic stability control
(ESP/ASR) button.
Central locking button.
Alarm button.
7.
Gear lever.
8.
Parking brake.
9.
Retractable roof control.
Control for the four windows.
10.
Door mirror controls.
Electric window controls.
11 .
Headlamp height adjustment.
12.
Door window demist/defrost vent.
13.
Side adjustable air vent.
14.
Windscreen demist/defrost vent.
Page 17 of 224
15
FAMILIARISATION
MONITORING
Instrument panel
Switch panel
A.
With the ignition on, the fuel gauge
needle should rise.
B.
With the engine running, the associ-
ated low level warning lamp should
switch off.
C.
With the ignition on, the oil level in-
dicator should display "OIL OK"
for
a few seconds.
If the levels are not correct, top up the
level which is low.
20
Lighting of the indicator lamp indicates
the status of the corresponding function.
A.
Deactivation of the ESP/ASR system.
97
B.
Central locking.
74
C.
Deactivation of the interior volumetric
protection alarm.
69
1.
With the ignition on, the orange and
red warning lamps come on.
2.
With the engine running, these
warning lamps should switch off.
If a warning lamp remains on, refer to
the page concerned.
21
Warning lamps
Page 18 of 224
!
16
FAMILIARISATION
Front passenger’s airbag
Ignition switch
1.
Open the glove box.
2.
Insert the key.
3.
Select position:
"ON"
(activation), with front passen-
ger or "forwards facing" child seat,
"OFF"
(deactivation), with "rear facing" child seat.
4.
Remove the key keeping the switch
in the new position.
102
1.
Stop
position.
2.
Ignition
position.
3.
Starting
position.
67
A.
Front left seat belt not fastened or
unfastened warning lamp lit in red.
B.
Front right seat belt not fastened or
unfastened warning lamp lit in red.
98
Front seat belts
A heavy object (key fob...), attached
to the key and weighing down on
its shaft in the ignition switch, could
cause a malfunction.
PASSENGER SAFETY STARTING
Page 22 of 224
1INSTRUMENTS and CONTROLS
20
PETROL - DIESEL, MANUAL OR AUTOMATIC GEARBOX,
INSTRUMENT PANELS
Panel which groups together the vehicle operation dials and indicator lamps.
5.
Screen.
6.
Display zero reset button.
Resets the selected function to
zero (trip distance recorder or
service indicator).
7.
Instrument panel lighting button.
Adjusts the brightness of the
lighting of the instruments and
controls.
8.
Automatic gearbox.
Indicates the programme selected
and the gear engaged.
Dials
1.
Rev counter.
Indicates the speed of rotation of
the engine (x 1 000 rpm).
2.
Fuel gauge.
Indicates the quantity of fuel
remaining in the tank.
3.
Coolant temperature.
Indicates the temperature of the
engine coolant (°Celsius).
4.
Speedometer.
Indicates the current speed of the
moving vehicle (mph or km/h).
A.
Speed limiter
or
Cruise control.
(mph or km/h)
B.
Trip distance recorder.
(miles or km/h)
C.
Service indicator.
(miles or km/h) then,
Engine oil level indicator.
then
Distance recorder.
(km or miles)
These three functions are displayed
in succession when the ignition is
switched on.
For more information, refer to the section
which corresponds to the function and to
the display associated with it.
Screen
Page 23 of 224
1
!
INSTRUMENTS and CONTROLS
21
Indicator and warning lamps
Visual indicators informing the driver that a system is in operation (operation or
deactivation indicator lamps) or of the occurrence of a fault (warning lamp).
When the ignition is switched on
Certain warning lamps come on for a few seconds when the vehicle's ignition is
switched on.
When the engine is started, these same warning lamps should go off.
If they remain on, before moving off, refer to the information on the warning lamp concerned.
Associated warnings
The illumination of certain warning lamps may be accompanied by an audible sig-
nal and a message in the multifunction screen. The warning lamps may come on
continuously (fi xed) or fl ash.
Certain warning lamps may come
on in two different modes. Only by
relating the type of illumination to
the operating status of the vehicle
can it be ascertained whether the
situation is normal or whether a
fault has occurred.
Operation indicator lamps
If one of the following indicator lamps comes on, this confi rms that the corresponding
system has come into operation.
Warning lamp
is on
Cause
Action/Observations
Left-hand
direction
indicato
r
fl ashing with
buzzer. The lighting stalk is pushed
down.
Right-hand
direction
indicator
fl ashing with
buzzer. The lighting stalk is pushed
up.
Dipped beam
headlamps
fi xed. The lighting stalk is in the
"Dipped beam headlamps"
position.
Main beam
headlamps
fi xed. The lighting stalk is pulled
towards you. Pull the stalk to return to dipped beam
headlamps.