2011.5 Citroen DS4 RHD battery

CHECKS PRACTICAL
INFORMATIONTECHNICAL DATA AUDIO AND
TELEMATICS
231Bonnet
232 Running out of fuel (Diesel)
233 Petrol engines
234Diesel engines
235Checking levels
238 Checks
244 Te m p o r a ry puncture repair
kit
249 Changing a wheel
256Changing a bulb
263 Changing a fuse
269 12 V battery
272 Energy economy mode
273Changing a wiper blade
273Very cold climate screen
274 Fitting roof bars
275Towing the vehicle
277 To w i ng a trailer
279Accessories
284 Petrol engines
285 Petrol weights
286 Diesel engines
287 Diesel weights
288Dimensions
289Identifi cation markings
293 Emergency or assistance
295 eMyWay
347 Audio system
012012013013010010011011

45
Monitoring
Warning lampis onCauseAction/Observations
Battery chargefixed. The battery charging circuit has a fault(dir ty or loose terminals, slack or cut
alternator belt, ...).The warnin
g lamp should go off when the engine isstarted.
If it does not go off, contact a CITROËN dealer or aqualified workshop.
Brakingfixed, associated with
the STOP warninglamp. The brakin
g system fluid level has
dropped significantly. You must stop as soon as it is safe to do so.
Top up with brake fluid recommended by CITROËN.
If the problem persists, have the system checked by a
CITROËN dealer or a qualified workshop.

+fixed, associated with
the electric parkin
gbrake malfunctionwarning lamp, if the parking brake isreleased. The brakin
g system has a fault. You must stop as soon as it is safe to do so. Park, switch off the ignition and contact a CITROËN
dealer or a qualified workshop.

+ fixed, associated with
the
STOP and ABSwarning lamps. Th
e electronic brake force distribution (EBFD) system has a fault. You must stop as soon as it is safe to do so.
Have it checked by a CITROËN dealer or a qualified workshop.

47Monitoring
Servicetemporarily,accompanied by amessage. A min
or malfunction has occurredfor which there is no specific warninglamp. Identi
fy the malfunction by reading the message
displayed in the screen, such as, for example:
- the opening of the doors, boot or bonnet,
- the engine oil level,
- the remote control battery,
- the t
yre pressures,
- saturation of the par ticle emission filter on
Diesel vehicles
(see "Checks - § Checks/Particleemissions filter").
For any other malfunctions, contact a CITROËN dealer
or a qualified workshop.
fixed, accompanied
b
y a message and anaudible signal. A ma
jor malfunction has occurred
for which there is no specific warninglamp. Identif
y the malfunction by reading the message
displayed in the screen and contact a CITROËN dealer
or a qualified workshop.
Warning lampis onCauseAction/Observations
Particleemissions filter (Diesel)
fixed, accompanied by an audible signal message on the risk of
blockage of the particle emissions filter.
This indicates that the par ticleemissions filter is star ting to become saturated.
As soon as driving conditions allow, regenerate the filter by driving at a speed of at least 35 mph (60 km/h)until the warning lamp goes off.
fixed, accompanied by an audible signal andand a message that the
par ticle emissions filter additive level is too low. Thi
s indicates the low level of the additive reservoir.Have the reser voir topped up as soon as possible by a
CITROËN dealer or a qualified workshop.

A few seconds after the ignition is switched
on, the distance recorder resumes its normal
operation.
The spanner remains on.
The distance remaining may be weighted by the time factor, depending on the type of driving.
Therefore, the spanner may also comeon if you have exceeded the two year service interval.
Service indicator zero reset

After each ser vice, the ser vice indicator mustbe reset to zero.
The procedure for resetting to zero is as
follows: ) switch off the ignition,)
press and hold the ".../000"
trip distance
recorder zero reset button, ) switch on the ignition; the distance recorder
display begins a countdown,
) when the screen indicates "=/0"and thespanner disappears, release the button.

This operation cannot be carried out while a reminder of the ser vicing information is being displayed.
Following this operation, if you wish todisconnect the battery, lock the vehicleand wait at least five minutes for thezero reset to be registered.


Recalling the service information

You can recall the ser vice information at anytime. )Briefly press the ".../000"
trip distance recorder zero reset button.
The ser vice information is displayed for afew seconds, in the total distance recorder
line or in the type 2 instrument panel central screen.
Service overdue
For a few seconds after the ignition is switched on,
the spanner flashes
to indicate that the servicemust be carried out as soon as possible. Example:
the ser vice is overdue by 180 miles(300 km).
For a few seconds after the ignition is switched on,
the screen indicates:

5. Air conditioning On/Off
)Press this button to switch off
the air conditioning.
Switching the system off could result in
discomfort (humidity, condensation).)Press this button again to return to automatic operation of the air conditioning.
The indicator lamp on the "A/C"button comes on.
6. Air distribution adjustment
)Press one or more buttons to
direct the air flow towards:
- th
e windscreen and side windows (demisting or defrosting),
- the outer and centre air vents,
- th
e footwells.

You can combine the three orientations toobtain the desired air distribution.


7. Air fl ow adjustment
)Turn this control to the left todecrease the air flow or to theright to increase the air flow.

8. Air intake/Air recirculation
)Press this button for recirculation of the interior air. The indicator lamp in the button comes on. The air
flow indicator lamps, between the
two fans, come on progressively in relation to
the value requested.

9. "REST" function: ventilationwith the engine off

Even with the engine is off, you canoperate the ventilation for afew minutes.
Air recirculation enables the passen
ger compartment to be isolated from exterior odours and smoke. )
As soon as possible, press this button
again to permit the intake of outside air andprevent the formation of condensation. The
indicator lamp in the button goes off.
For example, while
you are away from the
vehicle, the passengers can still enjoy some air circulation without having the engine running.
This function is available after switching on the
ignition, as well as after stopping the engine.
The period that the function is available
depends on the state of char
ge of the battery.
You can activate the "REST" function while the
air conditioning control screens are on.

control, you can no longer unlock, lock or
locate your vehicle. )First of all, use the key in the lock to unlock
or lock your vehicle. )Then, reinitialise the remote control.
Fault with the remote
control
Reinitialisation
)Switch off the ignition and remove the ignition key.)Press the closed padlock immediately for a
few seconds.)Turn the key to position 2 (Ignition on).)Switch off the ignition and remove the keyfrom the ignition switch.
The remote control is fully operational again.

Changing the battery

Battery ref.: CR2032/3 volts.
)Unclip the cover using a small screwdriver at the two cutouts.)Lift off the cover. )Remove the flat battery from its location. )Fit the new battery into its location
observing the original direction of fitment. )Clip the cover onto the casing.
If the batter
y is flat, you are
informed by illumination of this
warning lamp, an audible signal
and a message in the screen.

If the problem persists, contact aCITROËN dealer as soon as possible.

Alarm *
- exterior perimeter
The system checks for opening of the vehicle.
The alarm is triggered if anyone tries to open a
door, the boot, the bonnet...


- interior volumetric
The system checks for any variation in the
volume in the passenger compartment.
The alarm is triggered if anyone breaks a
window, enters the passenger compar tment or moves inside the vehicle.

Locking the vehicle with full
alarm system
- tilt
The system checks for any change in theattitude of the vehicle.
The alarm is triggered if the vehicle is lifted,moved or knocked.
Self-protection function
The system checks for the putting out of ser vice of its components.
The alarm is triggered if the battery, the centralcontrol or the siren wiring are put out of service
or damaged.
For all work on the alarm system, contact a CITROËN dealer or a qualified workshop.


Activation
)Switch off the ignition and get out of the vehicle.)Press the locking button on the remote control.
The monitoring system is active: the indicator lamp in the button flashes once per second.
A
fter the locking button on the remote control
is pressed, the exterior perimeter monitoringis activated after a delay of 5 seconds and the
interior volumetric and anti-tilt monitoring after
a delay of 45 seconds.

Deactivation
)Press the unlocking button on the remotecontrol.
The alarm system is deactivated: the indicator
lamp in the button goes off.


If an opening (door, boot...) is not closed fully, the vehicle is not lockedbut the exterior perimeter monitoring will be activated after a delay of 45 seconds at the same time as the interior volumetric and anti-tilt monitoring.

*

According to country.

System allowing the doors to be locked and
unlocked manually in the event of a malfunction
of the central locking system or battery failure.
Emergency control
Locking the driver's door
)Inser t the key in the door lock, then turn it
to the rear.
You can also apply the procedure describedfor the passenger doors.
Unlocking the driver's door
)Inser t the key in the door lock, then turn it
to the front.

Locking the front and rear passenger doors
)
Open the doors.)
On the rear doors, check that the child lock
is not on (see Child Safety).) Remove the black cap, located on the edge of the door, using the key.)
Insert the key in the socket without forcing
it, then without turning it, move the latch sideways towards the inside of the door.) Remove the key and refit the cap.)
Close the doors and check that the vehicle
has locked correctly from the outside.



Unlocking the front and rear passenger doors
)Pull the interior door opening control.