2011.5 Citroen DS4 RHD light

93Comfort
These have one position for use (up) and a stowed position (down).
They can also be removed.
To remove a head restraint: )release the backrest using control 1,)tilt the backrest 2 slightly forwards, )pull the head restraint upwards to the stop, )then, press the lug A
.

Rear head restraints

Never drive with the head restraints removed; they must be in place and correctly adjusted.









Steering wheel adjustment
)When stationary, pull the control lever toyrelease the adjustment mechanism.)
Adjust the height and reach to suit your
driving position. ) Push the control lever to lock the
adjustment mechanism.
As a safety precaution, theseoperations should only be carried out
while the vehicle is stationary.

Rear view mirror
Adjustable mirror providing a central rear ward view.
Equipped with an anti-dazzle system, which darkens the mirror glass: this reduces the nuisance to
the driver caused by the headlamps from following vehicles, low sun...
Manual day/night model
Adjustment
)Adjust the mirror so that the glass is
directed correctly in the "day" position.
Day/night position
)Pull the lever to change to the "night"anti-dazzle position. )Push the lever to change to the normal"day" position. B
y means of a sensor, which measures thelight from the rear of the vehicle, this system
automatically and progressively changes between the day and night uses.
Automatic day/night model
In order to ensure optimum visibility during your manoeuvres, the mirror lightens automatically when reversegear is engaged.


As a safety measure, the mirrors should be adjusted to reduce the "blind spot".

101Access
Unlocking using the key
)Turn the key for wards in the driver's door lock to unlock the vehicle completely.

Selective unlocking of the boot
)
Press the central button on theremote control to unlock the boot. The doors remain locked.
If selective unlockin
g of the boot is deactivated, pressing this button also unlocks the doors.
Programming the unlocking
The complete or selective boot
unlocking parameter is set via the
vehicle configuration menu.
Selective unlocking of the boot is
activated by default.
Each unlockin
g is confirmed by rapid flashingof the direction indicators for approximatelytwo seconds.
According to the version of your vehicle, the door mirrors unfold at the same time.
In low light, unlocking also brings on the
welcome li
ghting, both interior and exterior (see "Visibility").
Don't forget to lock the boot again by pressing the closed padlock button.

Locking the vehicle
Normal locking using the remote
control
Normal locking using the key
)Turn the key towards the rear in the driver's door lock to lock the vehicle.
) Press the closed padlock to lockthe vehicle.If one of the doors or the boot is still open, the central locking does nottake place; the vehicle locks itself then unlocks straight away, identifiable by the sound of the locks rebounding. When the vehicle is locked, if it isunlocked inadvertently, it will lock itself again automatically after thir ty secondsunless a door or the boot is opened.

The folding and unfolding of the door mirrors using the remote control can bedeactivated by a CITROËN dealer or a qualified workshop.

Lockin
g is confirmed by fixed lighting of
the direction indicators for approximately
two seconds.
According to version, the door mirrors fold at
the same time.
In low light, locking also brings on of
the guide-me-home lighting (see "Visibility").

103Access


Closing the windows using the
remote contro
l
)Press and hold down the closed padlock until the desired position
is obtained. The windows stop when you release the button.

When closing the windows using the remote control you must ensure that nothing prevents them from closingcorrectly.
If you want to leave the windowspartly open, you must deactivate thevolumetric alarm monitoring.

Deadlocking using the remote
control

Deadlockin
g using the key
)Turn the key to the rear in the driver’s door
lock to lock the vehicle completely. )Turn the key to the rear again within fiveseconds to deadlock the vehicle.In low light, deadlocking also brings on the
guide-me-home lighting (see "Visibility").) Press the closed padlock to lockthe vehicle completely.)
Press the closed padlock again
within five seconds to deadlock
the vehicle.




Deadlockin
g is confirmed by fixed lighting
of the direction indicators for approximatelytwo seconds.
According to version, the door mirrors fold at
the same time.
Deadlocking renders the exterior and interior door controls inoperative. It also deactivates the central lockingcontrol button. Therefore, never leave anyone inside the vehicle when it is deadlocked.

) Press the closed padlock on the remote control.
This will switch on the cour tesy lamps and the direction indicators will flash for a few seconds.
Locating your vehicle
This function allows you to identify
your vehicle from a distance,particularly in poor light. Your vehicle must be locked.
Anti-theft protection

Electronic engine immobiliser
The key contains an electronic chip which has
a special code. When the ignition is switched
on, this code must be recognised in order for star ting to be possible.
This electronic engine immobiliser locks theengine management system a few minutes
after the ignition is switched off and prevents starting of the engine by anyone who does nothave the key.
In the event o
f a fault, you are
informed by illumination of this
warning lamp, an audible signal
and a messa
ge in the screen.
In this case, your vehicle will not start; contact
a CITROËN dealer as soon as possible.
Folding the key
)First press this button to fold the key.
If you do not press the button when folding the key, there is a risk of damage to the mechanism.

Keep safely the label attached to the keys given to you on acquisition of the vehicle.

Lighting controls System for selection and control of the various front and rear lamps providing the vehicle's lighting.
The various front and rear lamps of the vehicle
are designed to adapt the driver's visibility progressively according to the climaticconditions:
- sidelamps, to be seen,
- dipped beam headlamps to see without
dazzling other drivers,
- main beam headlamps to see clearly when
the road is clear.

Main lighting
Other lamps are provided to meet the requirements of particular driving conditions:


- rear foglamps,

- front foglamps with cornering lighting,

- directional headlamps for improved
visibility when cornering,

- da
ytime running lamps to be more visible
during the day,

- guide-me-home and welcome lighting tofacilitate access to the vehicle,

- parking lamps as vehicle position markers.

Additional lighting

The setting of some functions can be adjusted:


- daytime running lamps,

- automatic illumination of headlamps,

- guide-me-home lighting,

- welcome lighting,

- directional lighting.

Programming

In some weather conditions (e.g. low temperature or humidity), the presence of misting on the internal sur face of theglass of the headlamps and rear lamps
is normal; it disappears after the lamps have been on for a few minutes.

Visibility
Model without AUTO lighting

Model with AUTO li
ghting


Manual controls

The lighting is controlled directly by the driver
by means of the ring A and the stalk B.
Sidelamps (luminous signature).
Automatic illumination of headlamps.
B
. Stalk for switching headlamps: pull the stalk
towards
you to switch the lighting between
dipped and main beam headlamps.
In the lamps off and sidelamps modes, the
driver can switch on the main beam headlamps
temporaril
y ("headlamp flash") by maintaining a
pull on the stalk. A
.Main lighting mode selection ring: turn it
to position the symbol required facing themark.
Lamps o
ff.
Sidelamps.
Dipped headlamps or main beam
headlamps.

Displays

Illumination of the corresponding indicator
lamp in the instrument panel confirms that the
li
ghting selected is on. Da
ytime lighting, compulsory in cer tain countries, which comes on automatically when
the engine is star ted making the vehicle more
visible to other users.

Thi
s function is assured:


- in countries where it is imposed byregulations,
by illumination of the dipped beam headlamps associated with illumination of
the sidelamps and number plate lamps;
this function cannot be deactivated.

- for other countries where it is provided,
by illumination of dedicated lamps associated with illumination of the
sidelamps and number plate lamps; this
function can be activated or deactivated viathe vehicle configuration menu.

The instruments and controls
(multifunctionscreen, air conditioning control panel, ...)are not illuminated, except in night mode with
manual or automatic illumination of headlamps.
Daytime running lamps

The lighting control must be in position "0"
or "AUTO"
(day mode).