2011.5 Citroen DS4 RHD ESP

95
Comfort
Automatic tilting in reverse gear
System which provides a view of the ground
during parking manoeuvres in reverse gear.
Programming
) With the engine running, engage reversegear. )
Select and adjust the left-hand and right-
hand mirrors in succession.
The adjustment is stored immediately.
Switching on
) With the engine running, engage reversegear. )
Move control A
to the right or to the left to select the corresponding mirror.
The glass of the mirror selected tilts downwards, in accordance with its programming.

Switching off
)
Exit reverse gear and wait ten seconds.
or ) Return control A
to the central position.
The mirror glass returns to its initial position.
The mirror glass also returns to its initial
position:


- if the speed exceeds 6 mph
(10 km/h),

- if the engine is switched off.

109Access

This system allows automatic simultaneous locking of the doors and boot as soon as the speed of the vehicle exceeds 6 mph (10 km/h).

Anti-intrusion security


Operation
Activation/Deactivation
You can activate or deactivate this function permanently.
)
With the ignition on, press this buttonuntil an audible signal star ts and a corresponding message is displayed. If one of the doors or the boot is open,
the automatic central lockin
g does not takeplace.
This is signalled by the sound of the locks rebounding, accompanied byillumination of this warning lamp in the
instrument panel, an audible signal
and the displa
y of an aler t message.
Carrying long and voluminousobjects If you want to drive with the boot open, you should press the central locking button to lock the the doors. Other wise,
every time the speed of the vehicle exceeds 6 mph (10 km/h), the lockswill rebound and the alerts mentioned above will appear.


In the event of a serious impact with deployment of an airbag, the vehicle's doors unlock automatically to allow theexit of occupants and access for the security services.
Pressin
g the central locking button unlocks
the vehicle.
Above 6 mph (10 km/h), this locking is
temporary. The state o
f the system stays in memory when
switchin
g off the ignition.

Visibility
Model without AUTO lighting

Model with AUTO li
ghting


Manual controls

The lighting is controlled directly by the driver
by means of the ring A and the stalk B.
Sidelamps (luminous signature).
Automatic illumination of headlamps.
B
. Stalk for switching headlamps: pull the stalk
towards
you to switch the lighting between
dipped and main beam headlamps.
In the lamps off and sidelamps modes, the
driver can switch on the main beam headlamps
temporaril
y ("headlamp flash") by maintaining a
pull on the stalk. A
.Main lighting mode selection ring: turn it
to position the symbol required facing themark.
Lamps o
ff.
Sidelamps.
Dipped headlamps or main beam
headlamps.

Displays

Illumination of the corresponding indicator
lamp in the instrument panel confirms that the
li
ghting selected is on. Da
ytime lighting, compulsory in cer tain countries, which comes on automatically when
the engine is star ted making the vehicle more
visible to other users.

Thi
s function is assured:


- in countries where it is imposed byregulations,
by illumination of the dipped beam headlamps associated with illumination of
the sidelamps and number plate lamps;
this function cannot be deactivated.

- for other countries where it is provided,
by illumination of dedicated lamps associated with illumination of the
sidelamps and number plate lamps; this
function can be activated or deactivated viathe vehicle configuration menu.

The instruments and controls
(multifunctionscreen, air conditioning control panel, ...)are not illuminated, except in night mode with
manual or automatic illumination of headlamps.
Daytime running lamps

The lighting control must be in position "0"
or "AUTO"
(day mode).

127Visibility

Switching off the lighting when switching off the ignition

When the ignition is switched off, allof the lamps switch off immediately, except for the dipped beam headlamps if automatic guide-me-home lighting is activated.
Temporarily keeping the dipped beamheadlamps on after the vehicle's ignition has been switched off makes the driver's exit easier when the light is poor.
Switching on
)
With the ignition off, "flash" the headlamps using the lighting stalk.)
A further "headlamp flash" switches thefunction off.

Switching off
The manual guide-me-home lighting switches
o
ff automatically after a set time.
Manual guide-me-home
lighting

Switching on the lightingwhen switching on the ignition
To reactivate the lighting control stalk, turnthe ring Ato position A"0"
- lighting off, then to the position of your choice.
If the lighting is switched on manually after switching off the ignition, there is an audible signal when a front door is opened to warn the driver that they have forgotten to switchoff the vehicle's lighting, with the ignition off.
They switch off automatically after a periodwhich depends on the state of charge of thebattery (entry to energy economy mode).
Parking lamps
Side markers for the vehicle by illumination of
the sidelamps on the traffic side only.) Within one minute of switching off the
ignition, operate the lighting control stalk up
or down dependin
g on the traffic side(for example: when parking on the left;
lighting control stalk upwards; the right hand sidelamps are on).
This is confirmed by an audible signal and
illumination of the corresponding direction
indicator warning lamp in the instrument panel.
To switch o
ff the parking lamps, return the
lighting control stalk to the central position.

Cornering lighting
With dipped or main beams, this function makes use of the beam from a front foglamp to
illuminate the inside of a bend, when the vehicle
speed is below 25 mph (approximately 40 km/h)(urban driving, winding road, intersections,
parking manouevres...).

Switching on
with cornering lighting
without cornering lighting


Switching off

The system does not operate:


- below a cer tain angle of rotation of thesteering wheel,

- above 25 mph (40 km/h),

- when reverse gear is engaged.
The s
ystem is activated by default.

Programming
The system is activated or deactivated in the vehicleconfiguration menu. Thi
s function starts:


- when the corresponding direction indicator is switched on,
or

- from a cer tain angle of rotation of the steering wheel.

1.Front courtesy lamp
2.Front map reading lamps3.Rear courtesy lamp4.Rear map reading lamps











Courtesy lamps
In this position, the cour tesy lamp comes on gradually:


Front and rear courtesy lamps



- when the vehicle is unlocked,

- when the key is removed from the ignition,

- on opening a door,

- when the remote control locking button is used to locate your vehicle.
It switches off
gradually:


- when the vehicle is locked,

- when the ignition is switched on,

- 30 seconds after the last door is closed.
Permanently o
ff.
Permanent li
ghting.
In permanent lighting mode, the lighting time varies according to thecircumstances:



- with the ignition off, approximately ten minutes,

- in energy economy mode,approximately thirty seconds,

- with the engine running, unlimited.
When the cour tesy lamp is in the"permanent lighting" position, the rear courtesy lamp also comes on, except if it is in the "permanently off" position.To s w i t c h off the rear cour tesy lamp, put it in the the "permanently off" position.


Front and rear map reading
lamps
)
With the ignition on, press the corresponding switch.

Take care not to put anything in contact with the courtesy lamps.

Ty r e u n d e r - i nfl ation detection
System which automatically and continuously checks the pressure of the tyres while driving.Sensors fitted in each valve trigger a warning
in the event of problem (speed above 12 mph(20 km/h)).

Puncture

The tyre under-inflation detectionsystem is an aid to driving which doesnot replace the need for the driver to bevigilant or to drive responsibly.


Under-infl ated tyre
This warning lamp is displayed on the
instrument panel and/or a message appears
in the screen, accompanied by an audible
si
gnal, to identify the wheel concerned.
The STOPwarning lamp comes on and/or this warning lamp is displayed on
the instrument panel, accompanied by
an audible signal and a message in the
screen identifying the wheel concerned.
)Stop as soon as it is safe to do so, avoiding any sudden movement of the steering
wheel and the brakes.)Repair or change the damaged wheel(punctured or very deflated tyre), and have
the tyre pressure checked as soon as possible.
) Check the tyre pressures as soon as possible.
This check must be carried out when the tyres
are cold.

177Safety
Emergency braking assistance
System which, in an emergency, enables you
to obtain the optimum braking pressure more
quickly, thus reducing the stopping distance.

Activation

It is triggered by the speed at which the brake pedal is pressed.
The effect of this is a reduction in theresistance of the pedal and an increase in
braking efficiency.
When braking in an emergency, press firmly without releasing the pressure.

















Trajectory control systems (ESP)
Anti-slip regulation (ASR)
and electronic stability
control (ESC)
The anti-slip regulation (also known as traction control) optimises traction to prevent skidding
of the wheels, by acting on the brakes of the
driving wheels and on the engine.The electronic stability control acts on the
brake of one or more wheels and on the engine
to keep the vehicle on the trajectory required
by the driver, within the limits of the laws of physics.
Activation
These systems are activated automaticallyeach time the vehicle is started.
They come into operation in the event of a gripor trajectory problem.
This is indicated b
y flashing of this
warning lamp in the instrument panel.

Intelligent traction control
s
ystem ("Snow motion")
Your vehicle has a system to help driving on snow: intelligent traction control.
This system detects situations of difficult surface adhesion that could make it difficult to
move off or make progress on deep fresh snowor compacted snow.
In these situations, the intelligent tractioncontrol limits the amount of wheel slip to
provide the best traction and trajectory control
for your vehicle.
The use of snow tyres is strongly recommended on surfaces offering low levels of adhesion.