47Monitoring
Servicetemporarily,accompanied by amessage. A min
or malfunction has occurredfor which there is no specific warninglamp. Identi
fy the malfunction by reading the message
displayed in the screen, such as, for example:
- the opening of the doors, boot or bonnet,
- the engine oil level,
- the remote control battery,
- the t
yre pressures,
- saturation of the par ticle emission filter on
Diesel vehicles
(see "Checks - § Checks/Particleemissions filter").
For any other malfunctions, contact a CITROËN dealer
or a qualified workshop.
fixed, accompanied
b
y a message and anaudible signal. A ma
jor malfunction has occurred
for which there is no specific warninglamp. Identif
y the malfunction by reading the message
displayed in the screen and contact a CITROËN dealer
or a qualified workshop.
Warning lampis onCauseAction/Observations
Particleemissions filter (Diesel)
fixed, accompanied by an audible signal message on the risk of
blockage of the particle emissions filter.
This indicates that the par ticleemissions filter is star ting to become saturated.
As soon as driving conditions allow, regenerate the filter by driving at a speed of at least 35 mph (60 km/h)until the warning lamp goes off.
fixed, accompanied by an audible signal andand a message that the
par ticle emissions filter additive level is too low. Thi
s indicates the low level of the additive reservoir.Have the reser voir topped up as soon as possible by a
CITROËN dealer or a qualified workshop.
Warning lampis onCauseAction/Observations
Anti-lock BrakingSystem (ABS) fixed. The anti-lock braking system has a fault. The vehicle retains conventional braking.
Drive carefully at reduced speed and contact aCITROËN dealer or a qualified workshop without delay.
Dynamic stabilitycontrol
(ESP/ASR)
flashing. The ESP/ASR regulation is active. The system optimises traction and improves the
directional stability of the vehicle.
fixed. Unless it has been deactivated (button
pressed and its indicator lamp on),
the ESP/ASR or hill start assist
system has a fault. Have it checked b
y a CITROËN dealer or a qualified
workshop.
Engine
autodiagnosissystem
flashing. The engine management system has
a fault. Risk of destruction of the catal
ytic converter.
Have it checked b
y a CITROËN dealer or a qualified
workshop.
fixed. The emission control system has a fault. The warning lamp should go off when the engine is started.
If it does not go off, contact a CITROËN dealer or qualified
workshop without delay.
Low fuel levelfixed, accompanied by and audible signal anda message.Wh
en it first comes on there remainsapproximately 6 litresof fuel in the
tank.
At this point, you begin to use the fuel reserve.Re
fuel as soon as possible to avoid running out of fuel.Until sufficient fuel is added, this warning lamp willcome on every time the ignition is switched on,
accompanied by an audible signal and a message.
This audible signal and message are repeated with
increasing frequency as the fuel level drops towards "0".Fuel tank capacity: approximately 60 litres.Never continue to drive until you run out of fuel,
as this could damage the emission control and
injection systems.
A few seconds after the ignition is switched
on, the distance recorder resumes its normal
operation.
The spanner remains on.
The distance remaining may be weighted by the time factor, depending on the type of driving.
Therefore, the spanner may also comeon if you have exceeded the two year service interval.
Service indicator zero reset
After each ser vice, the ser vice indicator mustbe reset to zero.
The procedure for resetting to zero is as
follows: ) switch off the ignition, )
press and hold the ".../000"
trip distance
recorder zero reset button, ) switch on the ignition; the distance recorder
display begins a countdown,
) when the screen indicates "=/0"and thespanner disappears, release the button.
This operation cannot be carried out while a reminder of the ser vicing information is being displayed.
Following this operation, if you wish todisconnect the battery, lock the vehicleand wait at least five minutes for thezero reset to be registered.
Recalling the service information
You can recall the ser vice information at anytime. )Briefly press the ".../000"
trip distance recorder zero reset button.
The ser vice information is displayed for afew seconds, in the total distance recorder
line or in the type 2 instrument panel central screen.
Service overdue
For a few seconds after the ignition is switched on,
the spanner flashes
to indicate that the servicemust be carried out as soon as possible. Example:
the ser vice is overdue by 180 miles(300 km).
For a few seconds after the ignition is switched on,
the screen indicates:
The total and trip distances are displayed for
thirty seconds when the ignition is switchedoff, when the driver's door is opened and when
the vehicle is locked or unlocked.
Distance recorders
Total distance recorder
Trip distance recorder
Measures a distance travelled since it wasreset to zero by the driver.
)
With the ignition on, press and hold this
button until zeros appear.
Measures the total distance travelled bythe vehicle since its first registration.
Defi ne the vehicle parameters
- "Driving assistance":
●
"Parkin
g brake automatic" (Automaticelectric parking brake; see the "Driving"section),
●
"Rear wipe in reverse gear" (Rear
wiper coupled to reverse gear; see the
"Visibility" section),
●
"Speeds memorised" (Memorisingspeeds; see the "Driving" section).
- "Vehicle lighting" (see the "Visibility" section):
●
"Directional headlamps" (Main/additional
directional lighting),
●
"Daytime lights" (Daytime running
lamps).
- "Interior lighting" (see the "Visibility" section:
●
"Follow-me-home headlamps"
(Automatic operation of headlamps after switching off the ignition),
●
"Welcome lighting" (Exterior and interior
welcome lighting). For example: settin
g of the duration of the
"follow-me-home" li
ghting )Press the " " or "
" buttons, to select the
"Define the vehicle parameters" menu,
then the "OK " button.
)Press the "
" or "
" buttons to select
the "Interior lighting" line, then the "OK"button; then follow the same procedure to select the "Follow-me-homeheadlamps" line. This menu allows
you to activate or deactivate
the following equipment, classified in different categories:
- "Access to the vehicle" (see the "Access"
section):
●
"Plip action" (Selective unlocking of the
driver's door
),
●
"Unlocking boot only" (Selectiveunlocking of the boot).
"Personalisation-
configuration" menu
This menu gives access to the followingfunctions:
- "Define the vehicle parameters",
- "Choice of language",
- "Display configuration",
- "Choice of sounds".