III
!
61
COMFORT
Changing the battery
The remote control is supplied by a
6 V-28L battery, which is supplied.
Information on the display indicates
when it is time to replace this battery.
Unclip the casing then replace the
battery.
The remote control must then be
reinitialised, see below.
Always switch off the program-
mable heating while fi lling with
fuel to avoid any risk of fi re or
explosion.
To avoid any risk of poisoning and
asphyxiation, the programmable
heating must not be used, even
for short periods, in an enclosed
space such as a garage or work-
shop which is not equipped with an
exhaust gas extraction system.
Do not park the vehicle on an
infl ammable surface (dry grass,
dead leaves, paper…), there is a
risk of fi re.
The programmable heating system
is supplied by the vehicle's fuel tank.
Before use, ensure that the quantity
of fuel remaining is suffi cient. If the
fuel tank is at the reserve, we strong-
ly advise that you do not programme
the heating.
Do not discard the used
batteries, take them to an
approved collection point.
Reinitialising the remote control
If the vehicle's battery is disconnected
or the remote control's battery is re-
placed, the remote control must be
reinitialised.
After switching on the power, press
button 4
(OFF) for 1 second within
the next 5 seconds. If the operation
has taken place correctly the mes-
sage "OK"
is displayed on the remote
control screen.
If a problem occurs, the message
"FAIL"
appears. Repeat the operation.
In addition, your programmable
heating can be used to pre-heat
your vehicle's passenger com-
partment.
The interior volumetric protection
alarm movement sensor may be
disturbed by the fl ow of air from
the programmable heating when
it is in operation.
To avoid any unexpected trigger-
ing of the alarm during use of the
programmable heating, it is ad-
visable to deactivate the interior
volumetric protection.
IV
80
ACCESS
Unlocking
)
Press button A
again to unlock
the vehicle.
The red indicator lamp on the button
switches off.
If the vehicle is locked or dead-
locked from the outside, the red in-
dicator lamp fl ashes and button A
is inactive.
)
In this case, use the remote
control or the key to unlock the
vehicle.
Automatic central locking
System which provides full automatic locking or unlocking of the doors and
the boot while driving.
You can activate or deactivate this
function.
Locking
When the speed exceeds 6 mph
(10 km/h), the doors and the boot
lock automatically.
If one of the doors is open, the auto-
matic central locking does not take
place.
If the boot is open, the automatic
central locking of the doors is active.
Unlocking
)
Above 6 mph (10 km/h), press
button A
to unlock the doors and
the boot temporarily.
Activation
)
Press button A
for more than
two seconds.
A confi rmation message appears on
the instrument panel screen, accom-
panied by an audible signal.
Deactivation
)
Press button A
again for more
than two seconds.
A confi rmation message appears on
the instrument panel screen, accom-
panied by an audible signal.
Emergency control
To lock or unlock the doors manu-
ally in the event of a malfunction of
the central locking system or battery
failure.
Locking the driver's door
)
Insert the key in the lock, then
turn it to the rear.
Unlocking the driver's door
)
Insert the key in the lock, then
turn it to the front.
Locking the front and rear
passenger doors
)
On the rear doors, check that the
child lock is not activated.
)
Remove the black cap, located
on the edge of the door, using
the key.
)
Insert the key in the socket with-
out forcing it, then without turn-
ing it, move the latch sideways
towards the inside of the door.
)
Remove the key and refi t the cap.
Unlocking the front and rear
passenger doors
)
Pull the interior door opening
control.
