2011.5 Citroen C5 RHD battery
[x] Cancel search: batteryPage 82 of 340
IV
80
ACCESS
Unlocking
)
Press button A
again to unlock
the vehicle.
The red indicator lamp on the button
switches off.
If the vehicle is locked or dead-
locked from the outside, the red in-
dicator lamp fl ashes and button A
is inactive.
)
In this case, use the remote
control or the key to unlock the
vehicle.
Automatic central locking
System which provides full automatic locking or unlocking of the doors and
the boot while driving.
You can activate or deactivate this
function.
Locking
When the speed exceeds 6 mph
(10 km/h), the doors and the boot
lock automatically.
If one of the doors is open, the auto-
matic central locking does not take
place.
If the boot is open, the automatic
central locking of the doors is active.
Unlocking
)
Above 6 mph (10 km/h), press
button A
to unlock the doors and
the boot temporarily.
Activation
)
Press button A
for more than
two seconds.
A confi rmation message appears on
the instrument panel screen, accom-
panied by an audible signal.
Deactivation
)
Press button A
again for more
than two seconds.
A confi rmation message appears on
the instrument panel screen, accom-
panied by an audible signal.
Emergency control
To lock or unlock the doors manu-
ally in the event of a malfunction of
the central locking system or battery
failure.
Locking the driver's door
)
Insert the key in the lock, then
turn it to the rear.
Unlocking the driver's door
)
Insert the key in the lock, then
turn it to the front.
Locking the front and rear
passenger doors
)
On the rear doors, check that the
child lock is not activated.
)
Remove the black cap, located
on the edge of the door, using
the key.
)
Insert the key in the socket with-
out forcing it, then without turn-
ing it, move the latch sideways
towards the inside of the door.
)
Remove the key and refi t the cap.
Unlocking the front and rear
passenger doors
)
Pull the interior door opening
control.
Page 83 of 340
IV
81
ACCESS
BOOT (SALOON)
)
Press upwards on lever 1
and lift
up the boot lid.
With the vehicle stationary, this is
carried out using:
- The remote control.
- The key in a door lock.
- The interior central locking/un-
locking control.
The boot automatically locks when
the vehicle is moving at a speed of
over 6 mph (10 km/h), even if auto-
matic central locking is deactivated.
It is unlocked when a door is opened
or when the central locking button is
pressed (speed lower than 6 mph
(10 km/h)).
Opening
Locking/unlocking
Emergency boot release
System for mechanical unlocking of
the boot in the event of a battery or
central locking malfunction.
Unlocking
)
Fold back the rear seats to gain
access to the lock from inside
the boot.
)
Insert a small screwdriver into
hole A
of the lock to unlock the
tailgate.
)
Push the white part, located in-
side the lock, to the left to unlock
the boot.
Page 86 of 340
IV
84
ACCESS
PANORAMIC SUNROOF
(SALOON)
Sunroof closed
- Press B
to fi rst notch: tilting.
- Press B
to second notch: auto-
matic complete tilting.
- Press A
to fi rst notch: sliding to-
wards rear.
- Press A
to second notch: auto-
matic total sliding towards rear.
Sunroof open
- Press B
to fi rst notch: closure.
- Press B
to second notch: auto-
matic total closure.
Always remove the ignition key
when leaving the vehicle, even if
for a short time.
In the event of anything being
caught by the sunroof closing, you
must reverse the roof movement.
Do this by reversing the position of
the control switch.
When the driver is operating the
sunroof, they must always make
sure that the passengers are not
preventing it from closing properly.
The driver must ensure that pas-
sengers use the sunroof control
correctly.
Pay special attention to where
children are when operating the
sunroof.
The fi tting of a sunroof as an ac-
cessory is prohibited.
Operation
Tilted sunroof
- Press A
to fi rst notch: closure.
- Press A
to second notch: auto-
matic total closure.
Your sun roof is fi tted with a manually-
operated blind.
Anti-pinch
An anti-pinch device stops the sun
roof from closing, whether sliding or
tilting. If it meets an obstacle, it re-
opens.
Reinitialisation
After a battery disconnection or if
there has been a malfunction, you
have to re-initialise the anti-pinch
function.
)
move control B
until the roof is in
the complete tilting position,
)
keep control B
pressed down for
a minimum of 1 second.
During these operations, the anti-
pinch function does not operate
.
Page 87 of 340
IV
85
ACCESS
PANORAMIC SUNROOF
(TOURER)
This comprises a tinted glass pan-
oramic area 1
to improve brightness
and vision in the passenger com-
partment.
It is fi tted with an electric blind 2
to
help maintain a comfortable temper-
ature and reduce noise.
Opening
)
Press control A
.
Pressing to the 1st notch
allows you
to open the blind step by step.
Pressing to the 2nd notch
allows
you to fully open the blind.
The blind stops in the closest pre-
defi ned position (11 positions) as
soon as you release the control.
Closing
)
Press control B
.
Press to the fi rst notch
to close the
blind step by step.
Press to the second notch
to close
the blind completely.
The blind stops at the nearest pre-
set position (11 positions) as soon
as you release the control. After a battery disconnection, or if
there has been a malfunction, you
have to re-initialise the anti-pinch
function:
)
press control B
to the 2nd notch
(fully closed),
)
wait until the blind is fully
closed,
)
press control B
for at least
3 seconds.
If the blind opens randomly during a
closing operation, and straight after
the blind stops:
)
Press control B
until the blind
closes fully.
During these operations, the anti-
pinch function does not operate.
In the event of anything being
caught when the blind is moving,
you must reverse the movement of
the blind. To do so, reverse the po-
sition of the control.
When the driver is operating the
blind, he or she must always make
sure that the passengers are not
preventing it from closing properly.
The driver must ensure that pas-
sengers use the blind correctly.
Pay particular attention to children
when operating the blind .
Anti-pinch
If the blind meets an obstacle whilst
closing, it stops and opens partially
again.
You must re-initialise the anti-pinch
function within 5 seconds of the
blind stopping:
)
press control B
until the blind is
fully closed (closing in steps of a
few centimetres).
SEQUENTIAL ELECTRIC
BLIND
Page 91 of 340
V
89
VISIBILITY
C.
Foglamps selection ring.
The foglamps operate with the side-
lamps and the dipped and main
beam headlamps.
-
1 st turn forwards: rear foglamps on.
- 1 st turn rearwards: rear foglamps off.
- 1st turn forwards: front foglamps on.
- 2nd turn forwards: rear foglamps on.
- 1st turn rearwards: rear foglamps off.
- 2nd turn rearwards: front foglamps
off.
Model with rear foglamps
only
Model with front and rear
foglamps
In good or rainy weather, both day
and night, use of the front foglamps
and the rear foglamps is prohibited.
In these situations, the power of their
beams may dazzle other drivers.
They should only be used in fog or
falling snow.
In these weather conditions, it is
your responsibility to switch on the
foglamps and dipped headlamps
manually as the sunshine sensor
may detect suffi cient light.
Do not forget to switch off the front
and rear foglamps when they are
no longer needed.
Lighting left on
When a front door is opened with
the ignition off and in manual ligh-
ting mode, an audible signal warns
the driver if the vehicle's lighting is
still on.
In this case, switching off the ligh-
ting stops the audible signal.
With the ignition off, if the dipped
headlamps remain on, they will
switch off automatically after thirty
minutes to prevent discharging of
the battery.
Page 105 of 340
VI
103
FITTINGS
BOOT FITTINGS (SALOON)
1.
Battery location for vehicles with
V6 HDi engine.
2.
Boot fl oor (spare wheel storage).
3.
Boot lamp.
4.
Location for 6 CD changer.
Luggage securing rings
)
Use the 4 securing rings on the
boot fl oor to secure your lug-
gage.
For safety reasons in the event of
sharp braking, you are advised to
place heavy objects as far forward
in the boot as possible.
Page 106 of 340
VI
104
FITTINGS
BOOT FITTINGS (TOURER)
1.
Hook
For shopping bags.
2.
Torch
To recharge, return it to its storage
position.
3.
Storage net
or Battery compart-
ment (for vehicles with 3 litre
V6 HDi engine).
This provides access to the battery.
1.
Luggage-cover blind
(see details on following page)
2.
Luggage securing rings
Use the 4 stowing rings provided
on the boot fl oor to secure your
loads.
For safety reasons in the event
of sharp braking, you are ad-
vised to place heavy objects as
far forwards as possible.
3.
Hooks
These allow a cargo net to be
fi tted (see details on following
page).
1.
Boot lamp
2.
12 V accessories socket
(100 W maximum)
Cigarette lighter type 12 volt
socket. It is located on the rear
right-hand trim.
3.
Loading height control
You can change the height of the
vehicle to make loading or un-
loading easier.
4.
Hook
For shopping bags.
5.
Storage net
or closed housing
Location for the 6 CD changer.
Page 133 of 340
IX
!
131
DRIVING
Release
With the ignition on or the engine
running, to release the parking
brake, press on the brake pedal,
push then release
control lever A
.
The full application of the parking
brake is confi rmed by:
- warning lamp P
in the
control lever A
going off,
- display of a message "parking
brake released" in the instru-
ment panel screen.
If you push control lever A
without
pressing the brake pedal, the park-
ing brake will not be released and
the message "Apply foot on brake"
will be displayed on the instrument
panel.
When stationary, with the en-
gine running, do not press the
accelerator pedal unneces-
sarily, as you may release the
parking brake.
Maximum application
If necessary, you can utilise maxi-
mum application
of the parking
brake. It is obtained by means of a
long pull
on control lever A
, until
you see the message "Max applica-
tion of the handbrake" and a beep
is heard.
Maximum application is essential:
- in the case of a vehicle towing
a caravan or a trailer, if the au-
tomatic functions are activated
but you are applying the parking
brake manually,
- when the gradient you are parked
on is variable in its effect (e.g. on
a ferry, in a lorry, during towing).
- in the case of towing, a loaded
vehicle or parking on a gradient,
turn the front wheels towards the
pavement and engage a gear
when you park.
- after a maximum application, the
release time will be longer.
Particular situations
In certain situations (starting the en-
gine...), the parking brake can auto-
matically alter its level of application.
This is normal operation.
To advance your vehicle a few
centimetres without starting the en-
gine, but with the ignition on, press
on the brake pedal and release the
parking brake by pushing
then
releasing
control lever A
.
The full release of the parking brake
is confi rmed by the warning lamp P
in the control lever and the warning
lamp in the instrument panel going
off and the display of a message
"handbrake off" on the instrument
panel screen.
If the parking brake malfunctions
while applied
or if the battery is fl at,
an emergency release is still pos-
sible.
To ensure correct operation of the
parking brake and therefore your
safety, the number of successive
application/release operations is
limited to eight.
If this number is exceeded, you are
warned by the message "Parking
brake faulty" and a warning lamp
fl ashes.
- this warning lamp in the
instrument panel going off,