2010 VOLVO XC60 ECU

06 Maintenance and specifications
Wheels and tires
06

271
WARNING
The bottle is equipped with a catch to keep
it securely in place and help prevent sealing
compound leakage. Once in place, the bot-
tle cannot be unscrewed. This must be done
by a trained and qualified Volvo service
technician.
6. Remove the valve cap from the tire’s infla-
tion valve and screw the tire sealing sys-
tem’s hose connector onto the valve as
tightly as possible by hand.
7. Connect the electrical wire to the nearest
12-volt socket in the vehicle.
8. Start the vehicle’s engine.
WARNING
The vehicle´s engine should be running
when the tire sealing system is used to avoid
battery drain. Therefore, be sure the vehicle
is parked in a well ventilated place, or out-
doors, before using the system.
9. Start the tire sealing system’s compressor
by pressing the on/off switch to position I.
WARNING
•Never stand next to the tire being inflated
when the compressor is in operation.
•If cracks, bubbles, etc. form on the tire,
switch off the compressor immediately.
•If there is visible damage to the sidewall
or the rim, the tire cannot be repaired.
The vehicle should not be driven if this
occurs. Contact a towing service or
Volvo On Call Roadside Assistance if
applicable.
NOTE
The air pressure gauge will temporarily
show an increase in pressure to approxi-
mately 88 psi (6 bar) while the sealing com-
pound is being pumped into the tire. The
pressure should return to a normal level
after approximately 30 seconds.
10. Within seven minutes, inflate the tire to
between 22—44 psi (1.8—3.0 bar). Switch
off the compressor briefly to get a clear
reading from the pressure gauge.
CAUTION
The compressor should not be used for
more than 10 minutes at a time to avoid
overheating.
WARNING
If the pressure remains below 22 psi
(1.8 bar) after approximately seven minutes,
turn off the compressor. In this case, the
hole is too large to be sealed and the vehicle
should not be driven.
11. Switch off the compressor and disconnect
the electrical wire from the 12-volt socket.
12. Unscrew the hose from the tire’s inflation
valve and reinstall the valve cap.
13. Immediately drive the vehicle for approxi-
mately 2 miles (3 km) at a maximum speed
of 50 mph (80 km/h) to distribute the seal-
ing compound in the tire.

06 Maintenance and specifications
Vehicle care
06

277
CAUTION
•Avoid waxing or polishing plastic or rub-
ber components
•Polishing chromed strips can wear
away or damage the surface
•Polishes containing abrasive sub-
stances should not be used
Automatic car wash
•We do NOT recommend washing your car
in an automatic wash during the first six
months (because the paint will not have
hardened sufficiently).
•An automatic wash is a simple and quick
way to clean your car, but it is worth
remembering that it may not be as thor-
ough as when you yourself go over the car
with sponge and water. Keeping the under-
body clean is most important, especially in
the winter. Some automatic washers do
not have facilities for washing the under-
body.
CAUTION
•Before driving into an automatic car
wash, turn off the optional rain sensor to
avoid damaging the windshield wipers.
•Make sure that side view mirrors, auxil-
iary lamps, etc, are secure, and that any
antenna(s) are retracted or removed.
Otherwise there is risk of the machine
dislodging them.
•Chromed wheels: Clean chrome-
plated wheels using the same deter-
gents used for the body of the vehicle.
Aggressive wheel-cleaning agents can
permanently stain chrome-plated
wheels.
WARNING
•When the vehicle is driven immediately
after being washed, apply the brakes,
including the parking brake, several
times in order to remove any moisture
from the brake linings.
•Engine cleaning agents should not be
used when the engine is warm. This
constitutes a fire risk.
Exterior lightingCondensation may form temporarily on the
inside of the lenses of exterior lights such as
headlights, fog lights, or taillights. This is nor-mal and the lights are designed to withstand
moisture. Normally, condensation will dissi-
pate after the lights have been on for a short
time.
Polishing and waxing
•Normally, polishing is not required during
the first year after delivery, however, wax-
ing may be beneficial.
•Before applying polish or wax the vehicle
must be washed and dried. Tar spots can
be removed with kerosene or tar remover.
Difficult spots may require a fine rubbing
compound.
•After polishing use liquid or paste wax.
•Several commercially available products
contain both polish and wax.
•Waxing alone does not substitute for pol-
ishing a dull surface.
•A wide range of polymer-based waxes can
be purchased today. These waxes are easy
to use and produce a long-lasting, high-
gloss finish that protects the bodywork
against oxidation, road dirt and fading.
•Do not polish or wax your vehicle in direct
sunlight (the surface of the vehicle should
not be warmer than 113 °F (45 °C).

07 Index
07
297
Rear seats
center head restraint............................. 85
folding................................................... 84
heated................................................. 129
Rearview mirror
auto-dim function............................... 100
compass............................................. 155
Rear window defroster............................100
Recalls, child restraints.............................. 46
Refrigerant............................................... 288
Refueling..........................................208, 209
fuel filler cap....................................... 210
fuel filler door...................................... 210
fuel tank volume.................................288
Registering child restraints........................ 46
Remote key................................................ 54
approach lighting.................................. 56
immobilizer.....................................54, 55
key blade........................................ 54, 59
key memory.......................................... 54
locking the vehicle................................ 56
Personal Car Communicator..........56, 57
replacing the battery............................. 59
unlocking the vehicle............................ 56
Remote key/PCC
common functions................................ 56Reporting safety defects............................ 15
Roadside Assistance............................... 290
Rollover Protection System (ROPS).......... 33
Roll Stability Control (RSC)........................ 33
Roof loads............................................... 214
S
Safety, occupant........................................ 14
Safety defects, reporting........................... 15
Seat belt
reminder................................................ 17
Seat belts
Automatic locking retractor/Emergency
locking retractor.................................... 36
buckling................................................ 16
maintenance......................................... 16
pretensioners........................................ 16
reminder................................................ 16
reminder warning light.......................... 76
securing child restraint sys-
tems.......................................... 39, 41, 43
unbuckling............................................ 16
use during pregnancy........................... 18
using.....................................................16Seats, front.......................................... 81, 82
Side door mirrors....................................... 99
Side impact airbags................................... 28
Side marker lights, changing bulbs......... 237
Sirius satellite radio.................................. 141
Snow chains............................................ 264
Snow tires................................................ 264
Sound settings, audio system................. 134
Spare tire................................................. 265
Speed-dependent steering...................... 158
Spin control............................................. 156
SRS............................................................ 19
Stability system....................................... 156
indicator light........................................ 75
Starting the engine..................................106
with keyless drive............................... 106
Starting the vehicle
after a crash (crash mode)....................34
Start inhibitor (immobilizer)..................54, 55
Steel grid in cargo area............................ 215
Steering wheel
adjusting............................................... 87
horn....................................................... 87
keypad.................................. 87, 122, 133