2010 VOLVO V70/XC70 parking brake

06 Maintenance and specifications
Wheels and tires
06

253 Changing a wheel
G017464
Location of jack and tools
Spare wheelThe spare wheel (Temporary spare) is only
intended for temporary use. Replace the spare
wheel with a normal wheel as soon as possible.
The car's handling may be altered by the use
of the spare wheel. The correct tire pressure for
the spare wheel is stated in the tire pressure
tables on pages 247 and 247.
WARNING
Current legislation prohibits the use of the
“Temporary Spare” tire other than as a tem-
porary replacement for a punctured tire. It
must be replaced as soon as possible by a
standard tire. Road holding and handling
may be affected with the “Temporary
Spare” in use.
CAUTION
The vehicle must never be driven with more
than one temporary spare wheel.
The spare wheel is located in the spare wheel
well with the rim side down. There are two foam
blocks, one under the spare wheel and one
over/inside. The upper one contains all tools.
The same bolt runs through to secure the spare
wheel and the foam blocks.
Taking out the spare wheel1. Fold the rear edge of the floor mat forward.
2. Open the floor hatch.
3. Undo the retaining bolt.
4. Lift out the foam block with tools.
5. Lift out the spare wheel.
The other two blocks can remain in the wheel
well.
After useThe foam block and spare wheel must be
replaced in the reverse order. Note the arrow
on the upper foam block. It should point for-
ward.
NOTE
If the floor hatch is not completely closed,
the private locking feature (see page 59) will
not function.
Removing the wheel cover
Changing a tire:1. Apply the parking brake.
2.
Put the gear selector in P.

06 Maintenance and specifications
Wheels and tires
06
254
3. Block the wheels that are on the ground
with wooden blocks or large stones.
4. Remove the wheel cover (where applica-
ble) using the lug wrench in the tool
bag.With the vehicle still on the ground,
use the lug wrench to loosen the wheel
nuts 1/2 – 1 turns by exerting downward
pressure.
5. Turn the nuts counterclockwise to loosen.
6. There are two jack attachment points on
each side of the vehicle. Position the jack
correctly in the attachment (see illustration
above) and crank while simultaneously
guiding the base of the jack to the ground.
The base of the jack must be flat on a level,
firm, non-slippery surface. Before raisingthe vehicle, check that the jack is still cor-
rectly positioned in the attachment.
7. Raise the vehicle until the wheel to be
changed is lifted off the ground.
8. Unscrew the wheel nuts completely and
carefully remove the wheel so as not to
damage the threads on the studs.
WARNING
•The jack must correctly engage the jack
attachment.
•Be sure the jack is on a firm, level, non-
slippery surface.
•Never allow any part of your body to be
extended under a vehicle supported by
a jack.
•Use the jack intended for the vehicle
when changing a tire. For any other job,
use stands to support the vehicle.
•Apply the parking brake and put the
gear selector in the Park (P) position.
•Block the wheels standing on the
ground, use rigid wooden blocks or
large stones.
•The jack should be kept well-greased
and clean, and should not be damaged.
•No objects should be placed between
the base of jack and the ground, or
between the jack and the attachment
bar on the vehicle.
Re-installing the wheel1. Clean the contact surfaces on the wheel
and hub.
2. Lift the wheel and place it on the hub.

06 Maintenance and specifications
Wheels and tires
06

257
upper and lower eyelids. Get medical
attention if symptoms occur.
•Inhalation: Move the person to fresh air.
If irritation persists, get medical atten-
tion.
Tire sealing system–temporarily
repairing a flat tire
G014338
Temporarily repairing a flat tire is done in two
stages:
•Stage 1: The hole is sealed by pumping
sealing compound into the tire. The car is
then driven a short distance to distribute
the sealing compound in the tire.
NOTE
Do not remove any foreign objects (nails,
etc.) from the tire before using the sealing
system.
•Stage 2: The tire’s inflation pressure is
checked and adjusted if necessary.
WARNING
•Never leave the tire sealing system
unattended when it is operating.
•Keep the tire sealing system away from
children.
•Be sure the vehicle is parked safely off
the road and away from moving traffic.
•Apply the parking brake.
Stage 1: Sealing the hole1. Open the cover on the tire sealing kit.2. Peel off the speed limit sticker and affix it
to the steering wheel hub where it will be
clearly visible to the driver.
3. Ensure that the on/off switch is in posi-
tion 0 (the 0 side of the switch should be
pressed down).
WARNING
Contact with the sealing compound may
cause skin irritation. If contact occurs, wash
the affected area immediately with soap and
water.
4. Unscrew the orange cover over the bottle
holder and unscrew the cap on the bottle
of sealing compound.
NOTE
Do not break the seal on the bottle. This
occurs automatically when the bottle is
screwed into the holder.
5. Screw the bottle into the bottle holder.

06 Maintenance and specifications
Vehicle care
06
264
CAUTION
•Avoid waxing or polishing plastic or rub-
ber components
•Polishing chromed strips can wear
away or damage the surface
•Polishes containing abrasive sub-
stances should not be used
Automatic car wash
•We do NOT recommend washing your car
in an automatic wash during the first six
months (because the paint will not have
hardened sufficiently).
•An automatic wash is a simple and quick
way to clean your car, but it is worth
remembering that it may not be as thor-
ough as when you yourself go over the car
with sponge and water. Keeping the under-
body clean is most important, especially in
the winter. Some automatic washers do
not have facilities for washing the under-
body.
CAUTION
•Before driving into an automatic car
wash, turn off the optional rain sensor to
avoid damaging the windshield wipers.
•Make sure that side view mirrors, auxil-
iary lamps, etc, are secure, and that any
antenna(s) are retracted or removed.
Otherwise there is risk of the machine
dislodging them.
•Chromed wheels: Clean chrome-
plated wheels using the same deter-
gents used for the body of the vehicle.
Aggressive wheel-cleaning agents can
permanently stain chrome-plated
wheels.
WARNING
•When the vehicle is driven immediately
after being washed, apply the brakes,
including the parking brake, several
times in order to remove any moisture
from the brake linings.
•Engine cleaning agents should not be
used when the engine is warm. This
constitutes a fire risk.
Exterior lightingCondensation may form temporarily on the
inside of the lenses of exterior lights such as
headlights, fog lights, or taillights. This is nor-mal and the lights are designed to withstand
moisture. Normally, condensation will dissi-
pate after the lights have been on for a short
time.
Polishing and waxing
•Normally, polishing is not required during
the first year after delivery, however, wax-
ing may be beneficial.
•Before applying polish or wax the vehicle
must be washed and dried. Tar spots can
be removed with kerosene or tar remover.
Difficult spots may require a fine rubbing
compound.
•After polishing use liquid or paste wax.
•Several commercially available products
contain both polish and wax.
•Waxing alone does not substitute for pol-
ishing a dull surface.
•A wide range of polymer-based waxes can
be purchased today. These waxes are easy
to use and produce a long-lasting, high-
gloss finish that protects the bodywork
against oxidation, road dirt and fading.
•Do not polish or wax your vehicle in direct
sunlight (the surface of the vehicle should
not be warmer than 113 °F (45 °C).

07 Index
07
282
E
ECC.........................................126, 127, 128
Economical driving.................................. 192
Electric parking brake.............................. 114
Electronic Climate Control.......126, 127, 128
air distribution table............................ 130
Interior Air Quality System.................. 128
ventilated seats................................... 126
Emergency brake lights............................. 87
Emergency locking retractor...................... 35
Emergency starting.................................. 105
Emergency towing...........................210, 211
Emission inspection readiness................ 215
Engine
overheating........................................... 74
specifications...................................... 274
starting................................................ 103
switching off....................................... 105
Engine compartment overview................217
Engine oil
checking............................................. 218
low pressure warning light.............. 73, 74
specifications...................................... 276
volumes.............................................. 277Environment............................................... 11
Eyelets for anchoring loads..................... 201
F
Federal Clean Air Act............................... 214
Floor rails................................................. 202
Fluid specifications.................................. 277
Fog lights
front...................................................... 73
front, changing bulbs.......................... 226
front/rear............................................... 87
Four C (active chassis system)................156
Front airbags.............................................. 20
disconnecting passenger’s side air-
bag.................................................. 24, 25
Front fog lights..................................... 73, 87
changing bulbs................................... 226
Front park assist.............................. 180, 182
Front seats...........................................79, 80
heated................................................. 126
Fuel filler cap........................................... 198
Fuel filler door, opening........................... 198
Fuel level warning light.............................. 73Fuel requirements............................ 196, 197
Fuel tank volume.....................................277
Fuses............................... 234, 235, 238, 240G
Gasoline requirements............................. 197
Gas tank volume...................................... 277
Gauges...................................................... 71
Geartronic................................................ 108
Geartronic automatic transmission.......... 108
Generator warning light............................. 74
Glossary of tire terminology..................... 249
Grocery bag holder.................................. 203
Gross vehicle weight...............................249
H
Hazard warning flashers............................ 88
HD digital radio........................................ 136
Headlights
Active Bending Lights........................... 86
changing bulbs...........................223, 224

07 Index
07
284
Low fuel level warning light........................ 73
Low oil pressure warning light................... 74
M
Main instrument panel............................. 122
Maintenance............................................ 214
hoisting the vehicle............................. 215
performed by the owner.....................215
Malfunction indicator light......................... 72
Menu system........................................... 120
overview.............................................. 120
Messages in the instrument panel........... 122
Mirrors
defroster............................................... 97
power door........................................... 96
rearview, auto-dim function.................. 97
retractable............................................. 96
vanity.................................................. 189
Moonroof................................................... 98
Motor oil
checking............................................. 218
specifications...................................... 276
volumes.............................................. 277
N
Net in cargo area..................................... 206
O
Occupant safety........................................ 14
Occupant weight sensor...................... 24, 25
Octane recommendations.......................197
Odometer, trip........................................... 76
Oil
specifications...................................... 276
volumes.............................................. 277
On Call Roadside Assistance.................. 279
Overhead courtesy lighting........................ 89
Overheating, engine................................... 74
Oxygen sensors, heated.......................... 199
P
Paint, touching up.................................... 266
Park assist.......................................180, 182Parking brake
electric, applying/releasing................. 114
warning light......................................... 74
Parking lights............................................. 86
changing bulbs................................... 225
Personal Car Communicator, unique func-
tions........................................................... 55
Polishing.................................................. 264
Power front seat
with keyless drive................................. 80
Power mirrors............................................ 96
defroster............................................... 97
Power moonroof........................................ 98
Power steering
fluid..................................................... 221
speed-dependent............................... 156
Power steering fluid................................. 277
Power tailgate.......................................... 200
Power windows......................................... 94
laminated glass..................................... 95
Pregnancy, using seat belts during........... 18
Private locking........................................... 59
PROPOSITION 65 WARN-
ING..................................... 11, 105, 233, 278