2010 SKODA OCTAVIA display

Introduction1
IntroductionThis supplement replaces the Owner's manual OCTAVIA Edition 05.10 referred to in
the following as the Owner's manual.
The information given in this supplement takes preference over the information in the
Owner's manual.
Special equipment is marked with the symbol *.
We wish you a good journey
Škoda Auto a.s.Safelock
Note
When activating the Safelock function after you lock the vehicle, the message CHECK
SAFELOCK will appear in the display of the inst rument cluster. In vehicles equipped
with a MAXIDOT info display*, the message Check deadlock! Owner's manual!
(Observe SAFE locking! Car documentation!) appears. Windscreen wipersThe washing nozzles of the windscreen washer system are heated during engine
running and when the outdoor temperature is less than +10 °C * .
Seat heaters*Fig. 1 Dash panel: Regulator for front seat heating front/rear– Press the button
  fig. 1 - right to activate and regulate the heating for the
left/right rear seat.
If you regulate the rear seat heating at full power - level 3, this will automatically switch
back to level 2 after 10 minutes (2 wa rning lights in the switch light up).
“START - STOP”*The “START-STOP” system helps you to save fuel while at the same time reducing
harmful exhaust emissions and CO
2 emissions.
The function is automatically activated ea ch time the ignition is switched on.
Fig. 2 Dash panel: START-STOP System
button
s1ec.5.book Page 1 Friday, September 24, 2010 10:46 AM

“START - STOP”*
2
In the start-stop mode, the engine automatica lly switches to the vehicle's idle phase,
e.g. when stopped at traffic lights.
Information regarding the current state of th e “START-STOP” system is indicated in the
display of the instrument cluster.Automatic engine shut down (stop phase)– Stop the vehicle (where nece ssary, apply the handbrake).
– Take the vehicle out of gear.
– Take your foot off the clutch.Automatic engine restart (start phase).– Push down on the clutch.Switching the “START-STOP” system on and offYou can switch the “START STOP” system on/off by pressing the button page 1, fig. 2 .
When start-stop mode is deactivated, the warning light in the button lights up.
If the vehicle is in the stop phase when ma nually switching off the system, the engine
starts immediately.
The “START-STOP” system is very complex. Some of the procedures are hard to check
without servicing. The general conditions for the proper functioning of the “START-
STOP” system are listed in the following overview.
Conditions for the automatic engine shut down (stop phase) Conditions for an automatic restart (start phase)
Conditions for an automatic restart without driver interventionThe gearshift lever is in Neutral.The clutch pedal is not pressed!The driver has fastened the seat belt.The driver's door is closed.The bonnet is closed.The vehicle is at
a standstill.The factory-fitted towing device is no t electrically connected to a trailer.
The minimum engine temperature is reached.The charge state of the vehicle battery is sufficient.The vehicle is not on a slope or on a downhill section.The engine speed is less than 1200 1/min.The temperature of the vehicle battery is not too low or too high.The pressure in the brake system is sufficient.The difference between the outdoor- and the set temperature in the interior is not
too great.The vehicle speed since the last time the engine was switched off was greater than 3
km/h.The particulate filter* is not be ing cleaned, see Owner's manual.The front wheels are not turned excessively (t he steering angle is less than 3/4 of a
steering wheel revolution).The clutch is pressed.The max./min. temperature is set.The Defrost function for the windscreen is switched on.A high blower stage has been selected.The “START STOP” button is pressed.The vehicle moves at a speed of more than 3 km/h.The difference between the outdoor- and the set temperature in the interior is too
great.The vehicle's battery is not sufficiently charged.Insufficient pressure in the brake system.
s1ec.5.book Page 2 Friday, September 24, 2010 10:46 AM

Charging the vehicle battery3
Messages in the instrument cluster display (valid for vehicles without MAXIDOT
info display*)
WARNING
•
The brake servo unit and power steerin g only operate if the engine is
running.
•
Never let the vehicle roll wi th the engine switched off.Caution
If the “START-STOP” system is used at very high outside temperatures over a very long
period of time, the vehicle battery can be damaged.
Note
•
Changes to the outdoor temperature can ha ve an effect on the internal tempera-
ture of the vehicle battery even after severa l hours. If the vehicle remains outdoors for
a long time in minus temperatures or in dire ct sunlight, it can take several hours until
the internal temperature of the vehicle battery reaches a suitable temperature for
proper operation of the “START STOP” system.
•
In some instances it may be necessary to start the engine manually with the igni-
tion key (e.g. when the seat belt is not inserted or the driver's door is opened for more
than 30 seconds). Follow the messages in the display of the instrument cluster.
•
If the air conditioning Climatronic* is running in automatic mode, under certain
conditions, the engine may no t switch off automatically.
Charging the vehicle battery
Caution
On vehicles with the “START/STOP” system, the negative cable of the charger must not
be connected directly to the negative pole of the vehicle battery, but only to the engine
earth fig. 3 .Jump-starting on vehicles with the “START-STOP” systemOn vehicles with the “START/STOP” system, the negative cable of the charger must not
be connected directly to the negative pole of the vehicle battery, but only to the engine
earth fig. 3 .Climatic*Using the systemThe set temperature will not be maintained automatically.
ERROR START STOP
Error in the START-STOP system
START STOP NOT POSSIBLE
Automatic engine shut down is not possi-
ble
START STOP ACTIVE
Automatic engine shut down (stop
phase)
SWITCH OFF IGNITION
Switch off the ignition
START MANUALLY
Start the engine manually
Fig. 3 Jump-starting on vehicles with
the START-STOP system
s1ec.5.book Page 3 Friday, September 24, 2010 10:46 AM