
Range selector key SETUP
10
Delete stored stations 
– Press the function key   and confirm the following safety interrogation in order  to delete all radio stations stored in the memory list.Setup Telephone*Call up the  Setup Telephone  menu by pressing the range selector key   and the 
range selector key  .Entering the voice mailbox number– If you want to enter the voice mailbox  number (this number depends on the type 
of the mobile phone network) in a mobile phone, press the function key  . The entry of the voice mailbox number is intended for 
listening to the messages left on a mobile phone.Updating telephone book in the unit– Press on the function key   to update all entries in the unit, the 
telephone book of the mobile phone or th e SIM card entered since the last connec-
tion. This procedure can take a few minutes.
– Confirm the following safety interrogatio n. The “old” data in the telephone book 
can still be selected at the unit  while the data is being updated.Delete call lists– Press on the function key  .
– If you confirm the following safety interrogation by pressing  , the stored call  numbers of all calls made  and calls accepted in the unit will be deleted.Deactivating the telephone module– After pressing the function key   the mobile phone 
deregisters from the network  (this function is only available for the universal tele-
phone preinstallation GSM III).Factory settings– Sets the telephone preinstallation to the basic setting.
Note
The selection possibilities of the mobile phone set-up depend on the relevant type of 
the universal telephone preinstallation.Setup traffic programmePress the range selector key   and then the range selector key  .
Switching the traffic announcements on or off 
A tick in the check box 
 =
 indicates that the traffic pr ogramme function is already 
switched on.
Dynamic route 
Opens a pop-up window where it is consider ed if the TMC traffic reports, received 
during the route calculation, are to be entered.
Setup DisplayPress the button   in the  RADIO mode and then the function keys   and 
.Brightness– Press the function key   and select the desired setting for brightness  (5°stages) in a pop-up window.
– A light sensor, which is located in the top ri ght corner of the front panel, is used for 
the automatic correction of the brightness  depending on the light conditions in the 
vehicle.Day/night– Press on the function key   and sele ct a setting in the pop-up window.
– Press the function key   if switching the headlights on and off should also  change the map display from night to day design.
– Press on the function key   or   to manually determine the night and day  design of the map display.
Delete presetsAll
PHONE
SETUP
Enter voice mailbox number
Load telephone bookDelete call lists
Delete
Deactivate the telephone module
TMC
SETUP
Traffic announcements (TP)
 ˜Dynamic routeSETUP
System
Screen
BrightnessDay/Night
Automatic
Day
Night
s34g.6.book  Page 10  Thursday, January 14, 2010  8:48 AM 

Range selector key NAV (Navigation)23
Range selector key NAV (Navigation)OverviewSafety information regarding the use of the navigation systemThe route is recalculated each time if you ignore driving recommendations or change 
the route. This process takes only a few seconds. Driving recommendations can only 
then be re-transmitted.
Incomplete navigation data
The navigation system cannot receive any data from GPS satellites if you drive for 
longer periods under thick forest canopy or  when your vehicle is in a garage, under-
pass or tunnel. In this case, the navigation system orientates itself solely with the help 
of the vehicle sensors.
In regions not at all or only partially digitalised and stored as such on the navigation 
CD, the navigation system will try to provide guidance to the destination. Please note 
that under these circumstance s the guidance to the destination may not be completely 
correct if, for example, one-way streets and  road categories (motorway, country road 
etc.) are not at all or only partially  included in the navigation data used.
WARNING
•
Always concentrate fully on your drivin g. Inattention by the driver can lead 
to accidents and injuries.
•
Do not allow yourself to be distracted or loose your concentration, pay 
attention to the traffic situation and do not carry out settings or use the radio 
navigation system.
•
Only use the radio navigation system if road, weather and traffic situations 
permit this and you are not distracted.
•
The various volume settings must be  selected in such a way that audible 
signals from the outside, such as e.g. a  Martins horn from police cars and fire 
brigade, can be heard at all times.
WARNING
•
Please observe the legal requirements  for road traffic when following the 
driving recommendations provided by your radio navigation system.
•
The driving recommendations provided may vary from current situations, 
e.g. due to road works or out of date  navigation data. In such a case, always 
observe the traffic regulations and ignore the driving recommendations.
•
Traffic signs and traffic regulations always have priority over the driving 
recommendations provided by the navigation system.
•
Route guidance is subject to consta nt changes despite the information 
about one-way streets, pedestrian zone s etc. stored on the navigation CD. 
Information on traffic lights, stop and right of way signs, parking and stopping 
restrictions as well as lane constrictions and speed restrictions is not included 
in the radio navigation system.
•
Adjust your speed to suit weather, road  and traffic conditions. Do not allow, 
for example, the radio navigation system  to make you drive faster in fog - risk 
of accident!
GeneralYou can continue to listen to the radio  or play CDs during the route guidance 
When entering an address (city, street), on ly those letters or symbols which make up a 
logical entry will be presented. A list of poss ible names will be shown. Do not forget to 
enter the blank space in names made up of more than one word, such as High 
Wycombe.
The route will be recalculated if you leave or disregard the route that was originally 
calculated. This process  takes only a few seconds.
The last voice response can be repeated by  pressing the button or the menu control 
button  . The volume of a navigation reco mmendation can be changed whilst it is 
being made.
The GPS satellites will not be able to reach  the aerial once you are in a tunnel or under-
ground garage. The unit will orientate itself via the wheel sensors.
A10
s34g.6.book  Page 23  Thursday, January 14, 2010  8:48 AM