Page 34 of 167
3 7
2
READY TO SET OFF
Starting and stopping
STARTING AND STOPPING
MAR p o s i t i o n : r u n n i n g .
C e r t a i n a c c e s s o r i e s c a n b e u s e d .
AVV p o s i t i o n : s t a r t e r .
T h e s t a r t e r i s o p e r a t e d .
STOP p o s i t i o n : s t e e r i n g l o c k .
T h e i g n i t i o n i s o f f .
Good practice when starting
Engine immobiliser warning
lamp
I f t h i s c o m e s o n , u s e a n o t h e r k e y
a n d h a v e t h e f a u l t y k e y c h e c k e d
b y a P E U G E O T d e a l e r .
Diesel pre-heating warning
lamp
Turn the key to the MAR position.
I n c o l d w e a t h e r , w a i t f o r t h i s
w a r n i n g l a m p t o s w i t c h o f f t h e n o p e r a t e t h e
s t a r t e r ( AVV p o s i t i o n ) u n t i l t h e e n g i n e s t a r t s .
I f t h e t e m p e r a t u r e i s h i g h e n o u g h , t h e
w a r n i n g l a m p c o m e s o n f o r l e s s t h a n o n e
s e c o n d , y o u c a n s t a r t w i t h o u t w a i t i n g . Door or bonnet open warning
lamp
I f t h i s c o m e s o n , a d o o r o r t h e b o n n e t
i s n o t c l o s e d c o r r e c t l y , c h e c k !
Good practice when stopping
Minimise engine and gearbox wear
W h e n s w i t c h i n g o f f t h e i g n i t i o n , l e t t h e
e n g i n e t o i d l e f o r a f e w s e c o n d s t o a l l o w t h e
t u r b o c h a r g e r t o s l o w d o w n .
D o n o t p r e s s t h e a c c e l e r a t o r w h e n s w i t c h i n g
o f f t h e i g n i t i o n .
T h e r e i s n o n e e d t o e n g a g e a g e a r a f t e r
parking the vehicle.
In low temperatures
I n m o u n t a i n o u s a n d / o r c o l d a r e a s , i t i s
a d v i s a b l e t o u s e a " w i n t e r " t y p e f u e l s u i t e d
t o l o w o r m i n u s t e m p e r a t u r e s .
Page 126 of 167
124
Opening the bonnet
On the inside
This operation must only be carried out with
the vehicle stationary and the driver ’s door
open.
Pull the release lever on the side of the
dashboard towards you.
On the outside
Push the safety catch lever located above
the grille to the right and raise the bonnet.
To close
Lower the bonnet and release it at the end of
its travel. Check that the bonnet has latched.
OPENING THE BONNET
Bonnet stay
Unclip the stay and tilt it to insert it in the
first notch, then the second.
Before closing the bonnet, put the stay back
in its housing. If the bonnet is not closed
correctly, this warning lamp
comes on on the instrument
panel.
Page 130 of 167
Checks
CHECKS
Air filter and passenger compartment filter
A clogged passenger compartment filter
may reduce the performance of the
air conditioning system and generate
undesirable odours. The replacement
intervals for these components are indicated
in the servicing booklet.
Depending on the environment (dusty
atmosphere...) and the use of the vehicle
(urban driving...), change them twice as
often if necessary, refer to the "Under the
bonnet" section of chapter 7.
Manual gearbox
Have the level checked in accordance with
the manufacturer's servicing schedule. To check the main levels and certain
components, in accordance with the
manufacturer's servicing schedule, refer to
the pages of the servicing booklet which
correspond to your vehicle's engine.
Only use products recommended by
PEUGEOT or products of equivalent quality
and specification.
In order to optimise the operation of units as
important as the braking system, PEUGEOT
selects and offers specific products.
In order to avoid damaging the electrical
units, high pressure washing to clean the
engine compartment is strictly prohibited.
Parking brake
Where the parking brake travel is too great
or there is a reduction in the performance
of the system, the parking brake should be
adjusted, even between services.
Have the system checked by a PEUGEOT
dealer.
Bleeding the water contained in the Diesel filter
If this warning lamp comes on,
bleed the filter, otherwise bleed
regularly each time the engine oil
is changed.
To drain the water out, unscrew the bleed
screw or the water in Diesel sensor, located
at the base of the filter. Leave open until
all of the water has been drained out. Then
tighten the bleed screw or the water sensor.
HDi engines use advanced technology. All
work requires a special qualification which is
guaranteed by a PEUGEOT dealer.
Battery
At the start of winter, have your battery
checked by a PEUGEOT dealer.
Brake pads
Brake pad wear depends on the style of
driving, in particular for vehicles which are
used in town, over short distances. It may
be necessary to check the thickness of the
pads, even between services.
Unless there is a leak on the system, a drop
in the brake fluid level indicates that the
brake pads are worn.
Brake disc/drum wear status
For any information relating to checking
the brake disc/drum wear status, contact a
PEUGEOT dealer.
Oil filter
Change the filter regularly, in accordance
with the servicing schedule.
Page 139 of 167
138
Changing a bulb
TYPES OF BULB
Various types of bulb are installed on your
vehicle. To remove them:
CHANGING A BULB
Type A Entirely glass bulb: pull gently
as it is fitted by pressure.
Type B Bayonet bulb: press on the bulb
then turn it anticlockwise.
Type C Cylindrical bulb: move aside the
contacts.
Type D - E Halogen bulb: release the
retaining spring from its
housing.
FRONT LAMPS
Open the bonnet. To access the bulbs, reach
behind the headlamp unit.
Carry out the operations in reverse order to
refit each bulb.
