2010 Peugeot Boxer instrument panel
[x] Cancel search: instrument panelPage 4 of 167
8
Familiarisation
INTERIOR
Instruments and controls
1. Fusebox.
2. Programmable heating.
3. Cruise control switch.
4. MODE, configuration and
personalisation/lighting rheostat/
headlamp beam height adjustment/
anti-tilt protection.
5. Lighting and direction indicator control
stalk.
6. Instrument panel with screen.
7. Wiper/screenwash/trip computer control
stalk.
8. Ignition switch.
9. Driver ’s airbag/horn.
Page 11 of 167
4221
FAMILIARISATION
15
Familiarisation
Reversing camera
The camera comes on when you engage
reverse gear and remains active up to
approximately 9 mph (15 km/h). It is
deactivated above 11 mph (18 km/h).
77
Instrument panel
A. Speedometer.
B. Instrument panel screen.
C. Rev counter.
26 Warning lamps
With the ignition on, the orange and red
warning lamps come on.
With the engine running, these warning
lamps should switch off.
If warning lamps remain on, refer to the
chapter concerned.
27
MONITORING
Buttons
Brightness adjustment.
Screen
Press the button and place the screen in the
required position.
Back-lighting adjustment.
ON/OFF provides views of the rear
without engaging reverse gear.
Page 12 of 167
542
16
Familiarisation
Two front rings, located between the seat
back and the seat cushion are used to
secure an ISOFIX child seat. Isofix mountings
114
PASSENGER SAFETY
To deactivate the front passenger airbag,
refer to the "MODE" section of chapter 4,
then on the "Passenger airbag" menu,
select OFF.
The airbag warning lamp on the instrument
panel stays on while the airbag is
deactivated.
73 This prevents opening of the sliding side
door from the inside.
Child lock
23
Page 13 of 167
4321
FAMILIARISATION
17
Familiarisation
Cruise control
The state of the cruise control system is
given on the instrument panel by a warning
lamp located in the rev counter.
44 Hill start assist
This system, linked with the ESP, makes hill
starts easier and is activated in the following
conditions:
- the vehicle must be stationary, with the engine running,
- the gradient of the road must be steeper than 5 %.
38 Pneumatic suspension
This equipment allows you to alter the rear
height of the load floor to make loading or
unloading easier.
Press the up control switch; release to stop
the movement. Each press increases by one
level: +1 to +3.
Press the down control switch; release to
stop the movement. Each press decreases
by one level: -1 to -3.
Driving with the load floor too high or too
low may damage components under the
body.
79
Function deactivated.
Function selected.
DRIVING SAFELY
Page 23 of 167
2 6
Instruments and controls
INSTRUMENT PANEL
1. D i s t a n c e r e c o r d e r i n m i l e s / k i l o m e t r e s .
2. Screen.
3. D i a l s a n d g a u g e s .
4. Rev counter.
INSTRUMENTS AND CONTROLS
Instrument panel screen 1
- T i m e ,
- M i l e s / K i l o m e t r e s t r a v e l l e d ,
- R a n g e ,
- F u e l c o n s u m p t i o n ,
- A v e r a g e s p e e d ,
- H e a d l a m p b e a m h e i g h t ,
- P r o g r a m m a b l e o v e r s p e e d w a r n i n g v i a
M O D E ,
- S e r v i c e i n d i c a t o r .
Instrument panel screen 2
- T i m e ,
- D a t e ,
- A m b i e n t t e m p e r a t u r e ,
- M i l e s / K i l o m e t r e s t r a v e l l e d ,
- R a n g e ,
- F u e l c o n s u m p t i o n ,
- A v e r a g e s p e e d ,
- H e a d l a m p b e a m h e i g h t ,
- P r o g r a m m a b l e o v e r s p e e d w a r n i n g v i a M O D E ,
- S e r v i c e i n d i c a t o r ,
- W a r n i n g m e s s a g e s d i s p l a y e d i n t h e t o p s e c t i o n ,
- R a d i o ( f r e q u e n c y o f t h e c u r r e n t s t a t i o n ) .
Page 32 of 167
3 5
2
READY TO SET OFF
Instruments and controls
SERVICE INDICATOR
F o r a f e w s e c o n d s a f t e r t h e i g n i t i o n i s
s w i t c h e d o n , t h e s p a n n e r s y m b o l i s i n g t h e
s e r v i c e i n d i c a t o r c o m e s o n : t h e s c r e e n
i n f o r m s y o u w h e n t h e n e x t s e r v i c e i s d u e ,
i n a c c o r d a n c e w i t h t h e m a n u f a c t u r e r ' s
s e r v i c i n g s c h e d u l e i n d i c a t e d i n t h e s e r v i c i n g
b o o k l e t . T h i s i n f o r m a t i o n i s d e t e r m i n e d i n
r e l a t i o n t o t h e d i s t a n c e t r a v e l l e d s i n c e t h e
previous service.
LIGHTING RHEOSTAT
T h e r h e o s t a t i s a c t i v e w h e n t h e l i g h t i n g i s o n .
A f t e r a f e w s e c o n d s , t h e d i s p l a y r e t u r n s t o
i t s u s u a l f u n c t i o n s .
U s e t h e s e c o n t r o l s t o a d j u s t t h e
b r i g h t n e s s o f t h e i n s t r u m e n t p a n e l .
There are 8 levels.
A long press returns you to the main menu.
R e f e r t o " M o d e " s e c t i o n o f c h a p t e r 4 .
Deterioration of the engine oil (100 and 120 bhp engines)
T h e " O i l L i f e " f u n c t i o n d e t e r m i n e s t h e
s e r v i c e i n t e r v a l , b e t w e e n 2 0 , 0 0 0 m i l e s
( 3 0 , 0 0 0 k m ) a n d 3 0 , 0 0 0 m i l e s ( 4 5 , 0 0 0 k m ) ,
d e p e n d i n g o n t h e w e a r o f t h e e n g i n e o i l .
T h e e n g i n e c o n t r o l u n i t t e s t s t h e d e g r e e o f
w e a r o f t h e e n g i n e o i l . R e f e r t o t h e l i s t o f c h e c k s i n t h e
s e r v i c i n g b o o k l e t w h i c h w a s g i v e n t o
y o u o n h a n d o v e r o f t h e v e h i c l e .
Reminder of servicing information
A t a n y t i m e , t o a c c e s s t h e s e r v i c e i n d i c a t o r ,
p r e s s b r i e f l y o n t h e M O D E b u t t o n .
U s e t h e u p / d o w n a r r o w s t o s e e t h e
s c h e d u l i n g a n d e n g i n e o i l w e a r i n f o r m a t i o n .
P r e s s i n g t h e M O D E b u t t o n a g a i n a l l o w s y o u
t o r e t u r n t o t h e v a r i o u s d i s p l a y m e n u s .
Menu... Choose...
Allows you
to...
12
Service Service
( M i l e s / k m
b e f o r e o i l
c h a n g e ) Display the
d i s t a n c e
remaining
b e f o r e t h e
n e x t o i l
change.
Oil Display the
oil level.
Resetting to zero
T h e s t o p p i n g o f t h e p e r m a n e n t f l a s h i n g o f
t h e i n d i c a t o r i s c a r r i e d o u t b y a n a u t h o r i s e d
r e p a i r e r w i t h a d i a g n o s t i c t o o l .
I n t h i s c a s e , y o u r v e h i c l e m u s t b e s e r v i c e d
a s s o o n a s p o s s i b l e ( w i t h i n a p p r o x i m a t e l y
6 0 0 m i l e s / 1 0 0 0 k m ) .
T h e f u n c t i o n m u s t b e r e s e t t o z e r o e v e r y
t i m e t h e e n g i n e o i l i s c h a n g e d .
Y o u a r e w a r n e d b y t h e f l a s h i n g o f
t h e e n g i n e o i l p r e s s u r e w a r n i n g
l a m p a n d a m e s s a g e o n t h e
instrument panel every time you
s t a r t t h e e n g i n e , i f y o u r v e h i c l e i s f i t t e d w i t h
t h i s f u n c t i o n .
Page 39 of 167
41
3
EASE OF USE AND COMFORT
Steering mounted controls
AUTOMATIC ILLUMINATION OF HEADLAMPS
If your vehicle is fitted with this function, the
sidelamps and dipped beam headlamps are
switched on automatically if the light is poor.
In fog or snow, the sunshine sensor may
detect sufficient light. Therefore, the lamps
will not be switched on automatically. If
necessary, you must switch on the dipped
beam headlamps manually.
They are switched off when the light returns
to a sufficient level.
Activation
Turn the ring to this position.
The lamps are switched off
automatically when the ignition is
switched off.
Do not cover the sunshine sensor at
the top centre of the windscreen.
GUIDE ME HOME LIGHTING
Ignition off or key in the STOP position.
Within 2 minutes after switching off
the engine, position the ignition key in
the STOP position or remove it.
Pull the lighting stalk towards the steering
wheel. The indicator lamp comes on
on the instrument panel.
Each action on the lighting stalk,
pulled towards the steering
wheel, prolongs the guide me home
lighting by 30 seconds up to approximately
3 minutes. When this time has elapsed,
the lamps are switched off automatically.
Deactivate this control by keeping the stalk
pulled towards the steering wheel for more
than 2 seconds.
If your vehicle is fitted with this function:
when you leave your vehicle, the sidelamps
and dipped beam headlamps remain on for
the selected duration (when leaving a car
park for example).
To set the sensitivity of the sensor,
refer to "Mode" in chapter 4.
Page 40 of 167
42
Steering mounted controls
HEADLAMP BEAM
You are advised to adjust the height of
the headlamp beams in accordance with
the load in your vehicle.
This function works in the dipped and main
beam headlamps position. Press these controls, located
on the dashboard, several times
in succession to adjust the
headlamps.
An indicator lamp on the screen
indicates the adjustment position
selected (0, 1, 2, 3).
SIDE/PARKING LAMPS
This system enables you to leave the
sidelamps on when parked; with the
ignition off, key in the STOP position or key
removed.
Move the ring on the lighting stalk to
position O then to sidelamps, dipped or main
beam headlamps.
The warning
lamp
on the
instrument panel comes on.
The sidelamps will remain on
while you are parked.
Leaving the lighting on for long periods
may significantly reduce the charge of your
vehicle's battery.