Page 4 of 167
8
Familiarisation
INTERIOR
Instruments and controls
1. Fusebox.
2. Programmable heating.
3. Cruise control switch.
4. MODE, configuration and
personalisation/lighting rheostat/
headlamp beam height adjustment/anti-
tilt protection.
5. Lighting and direction indicator control
stalk.
6. Instrument panel with screen.
7. Wiper/screenwash/trip computer control
stalk.
8. Ignition switch.
9. Driver's airbag/horn.
Page 13 of 167
4321
FAMILIARISATION
17
Familiarisation
Cruise control
The state of the cruise control system is
given on the instrument panel by a warning
lamp located in the rev counter.
44 Hill start assist
This system, linked with the ESP, makes hill
starts easier and is activated in the following
conditions:
- the vehicle must be stationary, with the engine running,
- the gradient of the road must be steeper than 5 %.
38 Pneumatic suspension
This equipment allows you to alter the rear
height of the load floor to make loading or
unloading easier.
Press the up control switch; release to stop
the movement. Each press increases by one
level: +1 to +3.
Press the down control switch; release to
stop the movement. Each press decreases
by one level: -1 to -3.
Driving with the load floor too high or too
low may damage components under the
body.
79
Function deactivated.
Function selected.
DRIVING SAFELY
Page 29 of 167
Instruments and controls
3 2
Warning
lamp is indicates Solution - action
Direction
i n d i c a t o r s f l a s h i n g w i t h
buzzer. a c h a n g e o f d i r e c t i o n u s i n g t h e
l i g h t i n g s t a l k , t o t h e l e f t o f t h e
s t e e r i n g w h e e l . T o t h e R i g h t : p r e s s t h e s t a l k u p w a r d s .
T o t h e L e f t : p r e s s t h e s t a l k d o w n w a r d s .
F r o n t f o g l a m p s on. that the button on the centre
c o n s o l e h a s b e e n p r e s s e d . Manual selection.
T h e f o g l a m p s o n l y o p e r a t e i f t h e s i d e l a m p s o r d i p p e
d
b e a m h e a d l a m p s a r e o n .
R e a r f o g l a m p s on. that the button on the centre
c o n s o l e h a s b e e n p r e s s e d . M a n u a l s e l e c t i o n . T h e f o g l a m p s o n l y o p e r a t e i f t h e
s i d e l a m p s o r d i p p e d b e a m h e a d l a m p s a r e o n . W h e n
v i s i b i l i t y i s n o r m a l , p l e a s e s w i t c h t h e f o g l a m p s o f f .
C r u i s e c o n t r o l on. that the cruise control has been
s e l e c t e d . Manual selection.
R e f e r t o t h e " S t e e r i n g m o u n t e d c o n t r o l s " s e c t i o n o f
c h a p t e r 3 .
F a u l t y b u l b o n a c c o m p a n i e d
by a message
on the screen. that one or more bulbs have
b l o w n . H a v e t h e b u l b c h a n g e d .
R e f e r t o t h e " C h a n g i n g a b u l b " s e c t i o n o f c h a p t e r 8
o r
c o n t a c t a P E U G E O T d e a l e r .
Rear parking
sensors on.
f a i l u r e o f t h e s y s t e m . T h e a u d i b l e a s s i s t a n c e i s n o l o n g e r a c t i v e .
H a v e t h e s y s t e m c h e c k e d b y a P E U G E O T d e a l e r
w i t h o u t d e l a y .
Page 42 of 167
Steering mounted controls
CRUISE CONTROL
"This is the speed at which the driver wishes to
travel".
T h i s a i d t o d r i v i n g i n f r e e - fl o w i n g t r a f fi c c o n d i t i o n s
enables the vehicle to maintain a constant
speed programmed by the driver, except when a
considerable load is carried on a steep gradient.
In order to be programmed or activated,
the vehicle speed must be greater than
approximately 25 mph (40 km/h), with at least
4th gear engaged.
Function selected.
Function deactivated.
If your vehicle is fitted with cruise control,
this is displayed on the instrument panel by
an indicator located in the rev counter.
Page 43 of 167
45
3
EASE OF USE AND COMFORT
Steering wheel controls
Selecting the function - ON
When the selection is
set to ON , this switches
the function on.
If your vehicle is fitted with this screen, a
message confirms the action.
Programming a speed
Accelerate to the required speed, with 4th or
5th gear engaged.
Move the control upwards (+), for
approximately one second, to store this
speed.
Release the pressure on the accelerator
pedal, the vehicle will maintain this speed.
Switching off/deactivating the function
Press the brake or clutch pedal or place
the dial in the OFF position, the indicator is
switched off.
If the ESP or ASR comes into operation,
the cruise control function is deactivated
temporarily.
- increase the speed in steps, by means of brief presses, or continuously by
pressing and holding the control
upwards (+ sign),
Temporary exceeding ofthe speed
When the cruise control is active, it is still
possible to exceed the programmed speed
by pressing the accelerator pedal
(to overtake another vehicle for example).
- decrease the speed continuously by pressing and holding the control
downwards (- sign).
Restore - RES
To restore the vehicle's
programmed speed (for example
after pressing the brake or clutch
pedal), gradually return to the chosen speed
and press RES .
The indicator comes on, the cruise control
function is restored.
Changing the programmed speed while the cruise control is in operation
You can:
Page 44 of 167
46
Steering mounted controls
Good practice
When changing the programmed reference
speed by pressing and holding the control,
take care as the speed may increase or
decrease rapidly.
Do not use the cruise control on slippery
roads or in heavy traffic.
On a steep gradient, the cruise control will
not be able to prevent the vehicle from
exceeding the programmed speed.
The cruise control cannot, in any
circumstances, replace the need to comply
with speed limits nor can it replace the need
for vigilance and responsibility on the part
of driver.
It is advisable to leave your feet near the
pedals.
To prevent the mat from becoming caught
under the pedals:
- ensure that the mat is positioned correctly,
- never fit one mat on top of another.
Cancelling the programmed speed
When the vehicle stops, after the ignition is
switched off, the system no longer stores
any speed.
Operating fault
In the event of a malfunction, the function is
switched off and the indicator switches off.
Contact a PEUGEOT dealer to have the
system checked.
Page 103 of 167
5
SAFETY
Driving safety
FIXED SPEED LIMITER
If your vehicle is fitted with this function,
the speed of your vehicle can be limited
to a fixed speed of approximately 55 mph
(90 km/h) or 60 mph (100 km/h). This
maximum speed cannot be changed.
A label in the passenger compartment
indicates this maximum speed.
T h e fi x e d s p e e d l i m i t e r i s n o t a f u n c t i o n o f
the cruise control type. It cannot be activated
or deactivated by the driver while driving.
When a malfunction of the ESP
system occurs, this warning lamp
comes on, accompanied by an
audible signal and confirmed by a
message on the screen.
Contact a PEUGEOT dealer to have the
system checked.
Good practice
The ASR/ESP systems offer increased
safety during normal driving, but should not
incite the driver to take risks or to drive at
high speed.
The operation of these systems is ensured
if the recommendations of the manufacturer
regarding the wheels (tyres and rims),
the braking components, the electronic
components and the fitting and repair
procedures within the PEUGEOT network
are observed.
After an impact, have these systems
checked by a PEUGEOT dealer.
Page 104 of 167
5
SAFETY
Driving safety
FIXED SPEED LIMITER
If your vehicle is fitted with this function,
the speed of your vehicle can be limited
to a fixed speed of approximately 55 mph
(90 km/h) or 60 mph (100 km/h). This
maximum speed cannot be changed.
A label in the passenger compartment
indicates this maximum speed.
T h e fi x e d s p e e d l i m i t e r i s n o t a f u n c t i o n o f
the cruise control type. It cannot be activated
or deactivated by the driver while driving.
When a malfunction of the ESP
system occurs, this warning lamp
comes on, accompanied by an
audible signal and confirmed by a
message on the screen.
Contact a PEUGEOT dealer to have the
system checked.
Good practice
The ASR/ESP systems offer increased
safety during normal driving, but should not
incite the driver to take risks or to drive at
high speed.
The operation of these systems is ensured
if the recommendations of the manufacturer
regarding the wheels (tyres and rims),
the braking components, the electronic
components and the fitting and repair
procedures within the PEUGEOT network
are observed.
After an impact, have these systems
checked by a PEUGEOT dealer.
