2010 PEUGEOT 508 heating

64
!
Comfort
Head restraint height and angle adjustment
 To lower the head restraint, press the lug A and, going beyond the stiff point, guide the head restraint downwards, then release the button at the desired position.  To raise the head restraint, guide it upwards to the desired position.  To adjust the angle of the head restraint, tilt its lower par t for wards or rear wards.  To remove the head restraint, press the two lugs B and pull the head restraint upwards.  To put the head restraint back in place,
engage the head restraint stems in the openings keeping them in line with the seat back. Check that it has engaged by pulling it upwards.
The head restraint is fitted with a locking mechanism which prevents it from lowering; this is a safety device in case of impact. The adjustment is correct when the upper edge of the head restraint is level with the top of the head. Never drive with the head restraints
removed; they must be in place and adjusted correctly.
Heated seats control
With the engine running, the front seats can be heated separately.  Use the adjustment dial, placed on the centre console, to switch on and select the level of heating required: 0: Off. 1: Low. 2: Medium. 3: High.

80
Comfort
Heating and Ventilation
The air circulating in the passenger compartment is filtered and originates either from the outside via the grille located at the base of the windscreen or from the inside in air recirculation mode.
Controls
The incoming air follows various routes depending on the controls selected by the driver, the front passenger and rear passengers, according to the level of equipment. The temperature control enables you to obtain the level of comfor t required by mixing the air of the various circuits. The air distribution control enables you to select the air vents used in the passenger compar tment by the combined use of the
associated buttons. The air flow control enables you to increase or reduce the speed of the ventilation fan. These controls are grouped together on control panel A on the centre console.
1. Windscreen demisting/defrosting vents. 2. Front side window demisting/defrosting vents. 3. Side adjustable air vents. 4. Central adjustable air vents.
5. Air outlets to the front footwells. 6. Adjustable air vents for the rear passengers. 7. Air outlets to the rear footwells.
Air distribution
System which creates and maintains good conditions of comfor t and visibility in the vehicle's passenger compar tment.

385
i
i
i
Comfort
On entering the vehicle, if the interior temperature is much colder or warmer than the comfor t value, there is no need to change the value displayed in order to obtain the comfor t required. The system corrects the difference in temperature automatically and as quickly as possible.
4. Automatic visibility programme
For maximum cooling or heating of the passenger compar tment, it is possible to exceed the minimum value 14 or the maximum value 28.  Turn control 2 or 3 to the left until "LO" is displayed or to the right until "HI" is displayed.
See "Front demisting-defrosting".
 Press this button to equalise the comfor t value on the passenger's side with that on the driver's side (mono-zone). The indicator lamp on the button comes on.
If you wish, you can change one of settings provided by the system. The other functions will still be controlled automatically.  Pressing the "AUTO" button returns the system to completely automatic operation.
Manual operation
5. Mono-zone/Dual-zone
The air conditioning is designed to operate effectively in all seasons, with the windows closed.
6. Air conditioning On/Off
It allows you: - in summer, to lower the temperature, - in winter, above 3 °C, to improve demisting per formance.
7. Maximum air conditioning
If you want to temporarily refresh the air in the passenger compar tment, press this button and "LO" is displayed. To return to the previous settings, press the button again.
With Stop & Star t, when demisting has been activated, the STOP mode is not available.
Switching on Press the "A /C" button, the associated
green indicator lamp comes on. The air conditioning does not operate when the air flow control is set to off.
Switching off Press the "A /C" button again, the associated green indicator lamp goes off. Switching off the air conditioning may result in some discomfor t (humidity, misting).

88
i
i
i
Comfort
5. Automatic visibility programme
6. Mono-zone/Quad-zone
7. Air conditioning On/Off
Manual operation
If you wish, you can change one of settings provided by the system. The other functions will still be controlled automatically. Press one of the Soft /Auto/Fast buttons to return to fully automatic operation.
On entering the vehicle, if the interior temperature is much colder or warmer than the comfor t value, there is no need to change the value displayed in order to obtain the comfor t required. The system corrects the difference in temperature automatically and as quickly as possible.
See "Front demisting-defrosting".
Press this button to apply the driver's comfort setting value to the front and rear passengers (mono-zone). The indicator lamp on the button comes on.
The air conditioning is designed to operate effectively in all seasons, with the windows closed. It allows you:
- in summer, to lower the temperature, - in winter, above 3 °C, to improve demisting per formance.
Switching on Press the "A /C" button, the associated green indicator lamp comes on. The air conditioning does not operate when the air flow control is set to off.
Switching off
 Press the "A /C" button again, the associated green indicator lamp goes off. Switching off the air conditioning may result in some discomfor t (humidity, misting).
For maximum cooling or heating of the passenger compar tment, it is possible to exceed the minimum value 14 or the maximum value 28.  Turn the dial 3 or 4 to the left until "LO" is displayed or to the right until "HI" is displayed.
With Stop & Star t, when demisting has been activated, the STOP mode is not available.

393
i
Comfort
Programmable heating
mode
This is an additional and separate system which heats the engine hot water circuit to improve defrosting and to preheat the passenger compar tment.
This indicator lamp comes on if the system is programmed in preheating mode.
Use the left hand steering mounted thumbwheel to navigate through the menus.
Programming
 In the "Main menu", select "Pre-heating/Pre-ventilation",
 Select "Activation" and if necessary for programming, "Parameters",
 Select "Heating" to preheat the engine or passenger compar tment or "Ventilation" to ventilate the passenger compar tment,
 Select: - immediate to start the heating ("OK" once), - the first clock to programme/store a star ting time, - the second clock to programme/store another star ting time.
Programmable Heating/Ventilation
Programmable Ventilation
mode
This mode allows ventilation of the passenger compar tment to improve the temperature experienced on entering the vehicle in summer.
Using these two clocks and according to season you can, for example, select one or the other star ting time. A message in the instrument panel screen confirms your choice.