2010 Peugeot 407 boot
[x] Cancel search: bootPage 72 of 249
4ACCESS
65
ALARM
For all work on the alarm system, contact
a PEUGEOT dealer.
- Exterior perimeter
The system checks for opening of the
vehicle.
The alarm is triggered if anyone tries
to open a door, the boot, the bonnet...
- Interior volumetric
The system checks for any variation in the
volume in the passenger compartment.
The alarm is triggered if anyone breaks
a window, enters the passenger com-
partment or moves inside the vehicle.
Self-protection function
The system checks for the
putting out of service of its
components.
The alarm is triggered if the battery, the
central control or the wires of the siren
are put out of service or damaged. Locking the vehicle with full
alarm system
Activation
Switch off the ignition and get out
of the vehicle.
Press the locking button on the re-
mote control.
The monitoring system is active: the
i n d i c a t o r l a m p o n t h e b u t t o n fl a s h e s
once per second.
After the locking button on the remote
control is pressed, the exterior perime-
ter monitoring is activated after a delay
of 5 seconds and the interior volumetric
after a delay of 45 seconds.
If an opening (door, boot...) is not
closed fully, the vehicle is not locked
but the exterior perimeter monitor-
ing will be activated after a delay of
45 seconds at the same time as the
interior volumetric monitoring.
System which protects and provides a
deterrent against theft and break-ins.
It provides the following types of moni-
toring.
Deactivation
Press the unlocking button on the
remote control.
The alarm system is deactivated: the in-
dicator lamp on the button switches off.
Locking the vehicle with
exterior perimeter monitoring
only
Deactivate the interior volumetric pro-
tection to avoid unwanted triggering of
the alarm in certain cases such as:
- leaving a pet in the vehicle,
- leaving a window partially open,
- washing your vehicle,
- changing a wheel,
- having your vehicle towed,
- transport by sea.
Deactivation of the interior
volumetric monitoring
Switch off the ignition.
Within ten seconds, press the but-
ton until the indicator lamp is lit
continuously.
Get out of the vehicle.
Press the locking button on the re-
mote control immediately.
The exterior perimeter monitoring alone
is activated: the indicator lamp on the
b u t t o n fl a s h e s o n c e p e r s e c o n d .
To be effective, this deactivation must
be carried out each time the ignition is
switched off.
Page 73 of 249
4ACCESS
66
Reactivation of the interior
volumetric monitoring
Press the unlocking button on the
remote control to deactivate the
exterior perimeter monitoring.
Press the locking button on the
remote control to activate all the
monitoring functions.
The indicator lamp on the button again
fl a s h e s o n c e p e r s e c o n d . Triggering of the alarm
This is indicated by sounding of the
s i r e n a n d fl a s h i n g o f t h e d i r e c t i o n i n d i -
cators for thirty seconds.
The monitoring functions remain ac-
tive until the alarm has been triggered
eleven times in succession.
When the vehicle is unlocked using
t h e r e m o t e c o n t r o l , r a p i d fl a s h i n g o f
the indicator lamp on the button in-
forms you that the alarm was triggered
during your absence. When the igni-
t i o n i s s w i t c h e d o n , t h i s fl a s h i n g s t o p s
immediately.
Failure of the remote control
To deactivate the monitoring functions:
Unlock the vehicle using the key in
the driver's door lock.
Open the door; the alarm is trig-
gered.
Switch on the ignition; the alarm
stops. The indicator lamp on the
button switches off. Locking the vehicle without
activating the alarm
Lock or deadlock the vehicle using
the key in the driver's door lock.
Malfunction
W h e n t h e i g n i t i o n i s s w i t c h e d o n , fi x e d
lighting of the indicator lamp on the
button indicates a malfunction of the
system.
Have it checked by a PEUGEOT dealer.
* According to country.
Automatic activation *
2 minutes after the last door or the
boot is closed, the system is activated
automatically.
To avoid triggering the alarm on
e n t e r i n g t h e v e h i c l e , fi r s t p r e s s t h e
unlocking button on the remote
control.
Page 75 of 249
4ACCESS
68
BOOT (SALOON) TAILGATE AND REAR SCREEN (407SW) Partial opening of the rear screen
Opening the tailgate and rear
screen
The tailgate and rear screen cannot
be opened at the same time.
With the rear screen closed, to open
the tailgate , operate the handle A ,
then lift the tailgate.
With the tailgate closed, to open the
rear screen , operate the handle B ,
then lift the rear screen.
The boot lighting is controlled by open-
ing the tailgate or the rear screen.
If the permanent locking of the
boot is activated, opening is
only possible by pressing the
remote control button.
Notes: the tailgate and rear
screen lock automatically when
driving at 6 mph (10 km/h) and
unlock when one of the doors
is opened.
When the rear wiper is in a wiping
position, the rear screen cannot be
opened until the end of the cycle.
Close the rear screen using the wiper
arm or by pressing the centre of the
glass.
To open the boot, press the push button
and raise the tailgate.
The locking or unlocking of the tailgate
and rear screen is simultaneous with
that of the doors. With the tailgate closed, to partially
open the
rear screen , press and hold
the unlocking button C on the remote
control.
Page 76 of 249
4ACCESS
68
BOOT (SALOON) TAILGATE AND REAR SCREEN (407SW) Partial opening of the rear screen
Opening the tailgate and rear
screen
The tailgate and rear screen cannot
be opened at the same time.
With the rear screen closed, to open
the tailgate , operate the handle A ,
then lift the tailgate.
With the tailgate closed, to open the
rear screen , operate the handle B ,
then lift the rear screen.
The boot lighting is controlled by open-
ing the tailgate or the rear screen.
If the permanent locking of the
boot is activated, opening is
only possible by pressing the
remote control button.
Notes: the tailgate and rear
screen lock automatically when
driving at 6 mph (10 km/h) and
unlock when one of the doors
is opened.
When the rear wiper is in a wiping
position, the rear screen cannot be
opened until the end of the cycle.
Close the rear screen using the wiper
arm or by pressing the centre of the
glass.
To open the boot, press the push button
and raise the tailgate.
The locking or unlocking of the tailgate
and rear screen is simultaneous with
that of the doors. With the tailgate closed, to partially
open the
rear screen , press and hold
the unlocking button C on the remote
control.
Page 77 of 249
4ACCESS
69
"Rear screen open" warning
When the engine is running , if the
rear screen is not fully closed, you are
warned by a message on the multi-
function screen.
When the vehicle is moving (speed
greater than 6 mph (10 km/h)), if the
rear screen is not fully closed, you are
warned by an audible signal, a mes-
sage on the multifunction screen and
lighting of the service warning lamp. Tailgate release
This enables the tailgate to be un-
locked in the event of a central locking
fault.
- Fold back the rear seats to gain
access to the lock from inside the
boot.
- Insert a small screwdriver into hole A
of the lock to unlock the tailgate.
Page 92 of 249
5
80
REAR COURTESY LAMP (SALOON) REAR READING LAMPS (407 SW) Sill illumination
T h e s i l l l i g h t i n g i s a t t h e b o t t o m o f e a c h
door panel.
T h e l a m p s c o m e o n a u t o m a t i c a l l y
when a door is opened and switch off
a u t o m a t i c a l l y w h e n a l l o f t h e d o o r s a r e
closed.
Boot light
The boot light is located in the right-
h a n d b o o t t r i m .
I t c o m e s o n a u t o m a t i c a l l y w h e n t h e
boot is opened and switches off auto-
m a t i c a l l y w h e n t h e b o o t i s c l o s e d .
1. Courtesy lamp
2. Map reading lamps
With the key in the ignition on or start-
ing position, operate the relevant
switch.
T h e r e a r c o u r t e s y l a m p c o m e s o n
w h e n t h e i g n i t i o n k e y i s r e m o v e d , o n
unlocking the vehicle or on opening
one of the doors.
It gradually goes off after the ignition
has been switched on or the vehicle
is locked.
Pressing switch 1 turns on the rear
c o u r t e s y l a m p .
T h e c o u r t e s y l a m p c a n b e d e a c t i v a t e d
by pressing switch 1 with the door open.
T h e m a p r e a d i n g l a m p s a r e n o t a f f e c t e d
b y t h i s a n d m a y b e s w i t c h e d o n .
T o r e - a c t i v a t e t h e l a m p s , p r e s s t h e
switch, with the door open. With the key in the ignition on or start-
ing position, press the corresponding
switch.
T h e r e a r r e a d i n g l a m p s c o m e o n w h e n
t h e k e y i s r e m o v e d f r o m t h e i g n i t i o n
and when the vehicle is unlocked.
They switch off gradually when the ig-
nition is switched on or when the ve-
hicle is locked.
Pressing switch 1 switches on the
r e a r r e a d i n g l a m p c o n c e r n e d f o r
t e n m i n u t e s .
Page 95 of 249
6FITTINGS
83
BOOT FITTINGS (407 SW)
3. Load space cover
T o r e m o v e :
U n c l i p t h e f r o n t e n d s a n d r e m o v e
t h e l o a d s p a c e c o v e r .
T o i n s t a l l :
P o s i t i o n t h e f r o n t e n d s o f t h e l o a d
s p a c e c o v e r o n i t s s u p p o r t a n d
p r e s s l i g h t l y t o p u t i t i n p l a c e .
1. 12V accessories socket (100 W
max) and boot lamp
T h i s i s a c i g a r l i g h t e r t y p e 1 2 v o l t s o c k -
e t . I t i s i n s t a l l e d o n t h e r e a r l e f t t r i m
a n d i s s u p p l i e d f r o m t h e i g n i t i o n o n
p o s i t i o n .
T h e b o o t l a m p i s c o n t r o l l e d b y o p e n i n g
t h e t a i l g a t e o r r e a r s c r e e n .
4. Stowing rings
T h e r e a r e f o u r s t o w i n g r i n g s o n t h e
b o o t fl o o r t o w h i c h t h e l u g g a g e r e t a i n -
i n g n e t c a n b e a t t a c h e d .
2. Storage boxes
T h e r e a r e t w o s i d e s t o r a g e b o x e s
w h i c h c a n c o n t a i n :
- o n t h e l e f t : a c a n o f o i l , a fi r s t a i d
k i t , a p u n c t u r e r e p a i r a e r o s o l ,
- o n t h e r i g h t ( e x c e p t w h e n a J B L H i - F i s y s t e m i s fi t t e d ) : a b o x o f b u l b s ,
a w a r n i n g t r i a n g l e ( s u p p o r t p r o v i -
d e d f o r t h i s p u r p o s e ) , t h e l u g g a g e
r e t a i n i n g n e t .
Page 128 of 249
1010PRACTICAL INFORMATION
113
CHANGING A WHEEL
Tools available
The following tools are located in
the holder in the centre of the spare
wheel:
1. Wheelbrace.
For removal of the wheel trim and removal of the wheel securing
bolts.
2. Jack with integral handle.
For raising the vehicle.
3. Removable towing eye.
See corresponding section.
4. Bolt cover tool.
For removal of the bolt protectors (covers) on alloy wheels. Removal
For vehicles with steel wheels, de-
tach the trim using the wheelbrace 1
pulling at the valve passage hole.
For vehicles with alloy wheels, re-
move the covers using tool 4 .
Loosen the wheel bolts.
Take the jack from the tool kit.
Place the jack 2 in one of the four
locations underneath the vehicle
(the nearest one to the wheel to be
changed).
Extend the jack 2 until its base is in
contact with the ground.
Unscrew the bolts and remove the
wheel.
Access to the spare wheel and
the jack in the boot
L i f t t h e fl o o r u s i n g t h e g r i p . S e c u r e
the grip behind the boot seal. Never go underneath a ve-
hicle which is supported only
by a jack.
Park the vehicle on level, stable
and non-slippery ground.
Apply the parking brake, switch off
t h e i g n i t i o n a n d e n g a g e fi r s t o r r e -
verse gear (position P for the auto-
matic gearbox).