2010 PEUGEOT 107 DAG towing

4
52
ACCESS
BOOT FITTINGS
2. Spare wheel/Additional storage compartments
Located under the carpet and a plas-
tic cover, this contains the tools for
wheel changing and towing.
There are two shelf storage options:
- either behind the rear seats,
- or fl at in the boot.
1. Rear parcel shelf
To remove the shelf:
- unhook the shelf from its fi xing
A ,
- pull upwards on each side to de- tach it from its fi xings,
- raise then tilt the shelf slightly to remove it. In order to obtain additional
space, the spare wheel can
be removed temporarily
(boot tray available as an ac-
cessory).

9
72
PRACTICAL INFORMATION
Parking the vehicle

 As far as possible, immobilise the
vehicle on level, stable, non-slip-
pery ground.

 Apply the parking brake, switch off
the ignition and engage fi rst gear
or reverse for the manual gear-
box, position N for the "2 Tronic"
gearbox. Tools
The following tools are installed in a
carrier, located in the centre of the
spare wheel:

1. Wheelbrace

2. Jack with handle

3. Removable towing eye
Access to the spare wheel and
the jack in the boot

 Remove the carpet then the plastic
cover using the handle. Tyre pressures
These are indicated on the label po-
sitioned on the inner pillar of the left
door, see "Identifi cation".
CHANGING A WHEEL

 If necessary, chock the wheel di-
agonally opposite the wheel to be
changed.

 It is imperative that you ensure that
the occupants get out of the vehi-
cle and wait in a safe location.

9
84
PRACTICAL INFORMATION
TOWING THE VEHICLE

Your vehicle can only be towed at
the front.
Lifting (2 wheels only on
the road)

Never use the radiator crossmember.
Towing with fours wheels on the road
must be carried out at very low speed
over a very short distance (in accor-
dance with the legislation in force).
Without lifting (4 wheels on
the road)
The removable towing eye is stored
in the spare wheel, under the boot
carpet.

 press the lower part of the cover
in order to take hold of the upper
part,

 pull the cover to unclip it,

 screw in the towing eye fully. Place the gear lever in posi-
tion
N for the "2 Tronic" gear-
box.
FITTING ROOF BARS
Please refer to national legis-
lation in order to comply with
the regulations concerning the
transportation of objects which
are longer than the vehicle.
Vehicles fitted with a manual
gearbox
In the case of vehicles fi tted with a
manual gearbox, the gear lever must
be in the neutral position.
Failure to observe this special condi-
tion may result in damage to certain
braking components and the ab-
sence of braking assistance the next
time the engine is started.
When fi tting transverse roof bars,
use the accessories recommended
by PEUGEOT and follow the manu-
facturer's fi tting instructions.
For more information, contact a PEUGEOT
dealer or a qualifi ed workshop.

Maximum weight authorised on
the bars, for a loading height not
exceeding 40 cm (except bicycle
carrier): 50 kg.

If the height exceeds 40 cm, adapt
the speed of the vehicle to the pro-
fi le of the road to avoid damaging
the roof bars.
General recommendations
Observe the legislation in
force in your country.
Ensure that the weight of the tow-
ing vehicle is higher than that of the
towed vehicle.
The driver must stay at the wheel of
the towed vehicle.
Driving on motorways and fast roads
is prohibited when towing.
When towing a vehicle with all four
wheels on the ground, always use an
approved towing bar; rope and straps are prohibited.
When towing a vehicle with the en-
gine off, there is no longer any power
assistance for braking or steering.
In the following cases, you must al-
ways call on a professional recovery
service:
- vehicle broken down on a motor- way or fast road,
- when it is not possible to put the gearbox into neutral, unlock the
steering, or release the parking
brake,
- towing with only two wheels on the ground,
- where there is no approved towing bar available...
In all other cases, your vehicle must
be transported on a trailer.