2010 MITSUBISHI OUTLANDER XL seats

2-28 Seat and restraint systems
2Making a cargo area
N00405500091
NOTE

When the seatback of a front seat is reclined, return it to
the upright position before driving.
WA R N I N G
!

Never adjust the seats to make a cargo area when
the vehicle is in motion or on a slope. The seats could
move more than necessary or move suddenly and
cause a serious accident.


After folding up a seat or returning a seat back to its
normal position, make sure that the seat is firmly
secured. If the seat is not secured, it could move and
cause a serious accident.


Do not allow anyone to ride in the cargo area while
the vehicle is in motion. People who are not properly
seated and restrained can be seriously injured or
killed in an accident.


The front passenger seat is equipped with weight
sensors. Depending on the weight detected, the front
passenger airbag is disabled or enabled. When fold-
ing the second row seats forward for increased cargo
capacity, the front passenger seat and seat back
must be adjusted to assure they are not contacting
the second row seat. In the event the front seat or
seatback is allowed to contact the folded second row
seat, proper operation of the front passenger airbag
system may be affected.
CAUTION
!

In the cargo area, do not load the luggage higher
than the top of the seats and make sure that the lug-
gage is firmly secured. Restricted rear vision or fly-
ing objects entering the passenger compartment
during sudden braking could result in a serious acci-
dent.


Seats should always be folded up and put back into
the normal position by an adult. Seat adjustments
by a child could lead to an unexpected accident.


When adjusting the seats, be careful not to catch
your hand or leg. Personal injury could result.
BK0115300US.book 28 ページ ２００９年７月１６日　木曜日　午前９時１３分

Seat and restraint systems
2-29
2
Folding the second row seats
N00405700107
The second row seat can be folded to create an additional cargo
area or to permit access to the third row seat on vehicles with a
third row seat.NOTE

You can separately fold the right and left side of the sec-
ond row seat.


When folding down the seatback, the seat belt buckles can
be stowed in the slits on the seat to avoid leaving marks on
the seat.
“Storing the second row and third row seat belts” on page
2-44.
To fold up the seat1. Lower the head restraints to the lowest position.
Refer to “Head restraints” on page 2-25.2. Operate the lever (A) or lock release strap (B) on the sec-
ond row seats to fold down the seatbacks.
Operating the leverOperating the lock release strap
BK0115300US.book 29 ページ ２００９年７月１６日　木曜日　午前９時１３分

Seat and restraint systems
2-31
2
To put the seat back in its normal position1. While supporting the seat with your hand, pull the lock
release strap (A) on the backside of the seat cushion and
keep it pulled as you lower the seat flat.


To reduce the risk of serious or fatal injury, do not
allow the front passenger seat or seatback to remain
in contact with the folded second row seat. The front
passenger seat is equipped with weight sensors.
Depending on the weight detected, the front passen-
ger airbag is disabled or enabled.
When folding the second row seats forward for
increased cargo capacity, the front passenger seat
and seatback must be adjusted to assure they are not
contacting the second row seat. In the event the
front seat or seatback is allowed to contact the
folded second row seat, proper operation of the front
passenger airbag system may be affected.


Never let persons or cargo sit on top of the folded
seat. Doing so could damage the seat.WA R N I N G
!
BK0115300US.book 31 ページ ２００９年７月１６日　木曜日　午前９時１３分

2-32 Seat and restraint systems
2
2. Push down on the entire seat until it locks into place with
a click.NOTE

You can load luggage with the seatback folded down.
CAUTION
!

For vehicles equipped with a third row seat, be care-
ful not to catch the feet of any passengers sitting in
the third row seat, when returning the second row
seats to their original position.
BK0115300US.book 32 ページ ２００９年７月１６日　木曜日　午前９時１３分

2-34 Seat and restraint systems
2Making a flat seat
N00404800143
The entire interior of the vehicle may be used for sleeping
accommodations by removing the head restraints and fully
reclining all the seats when the vehicle is stopped.
WA R N I N G
!

Never drive with passengers or cargo on the flat
seat. This is extremely dangerous and can cause
severe or fatal injury or death in an accident or if
heavy braking is required.CAUTION
!

Adjust the seats only when the vehicle is stopped in a
safe place.


Seat should be adjusted only by adults to avoid acci-
dents.


When sliding the seats, be careful not to catch your
hand or leg.


Do not walk around on top of the seats after they
have been laid flat because the footing is uneven. It
is safest to move about on your hands and knees.


To ensure the seats are locked securely, attempt to
move them back and forth.


Do not jump on or drop heavy objects on the seat-
backs.


To raise the seatback, firmly place your hand on the
seatback, pull the seatback lock knob up, and raise
the seatback slowly. (Refer to “To adjust the seat-
back” on page 2-8 and page 2-13.) Do not let chil-
dren adjust the seatback.CAUTION
!
BK0115300US.book 34 ページ ２００９年７月１６日　木曜日　午前９時１３分

Seat and restraint systems
2-35
2
1. Remove the head restraints from the front seats and raise
the arm rest on the second row seats.
For vehicles with a cargo area cover, remove the cover.
(Refer to “Head restraints” on page 2-25, “Arm rest” on
page 2-11 and “Cargo area over” on page 3-291.)2. Slide the second row seats back as far as possible (vehi-
cles with second row seat slide function).
(Refer to “To adjust the seat forward or backward” on
page 2-13.)
BK0115300US.book 35 ページ ２００９年７月１６日　木曜日　午前９時１３分

2-36 Seat and restraint systems
2
3. Slide the front seats fully forward, then recline their seat-
backs backward to achieve a flat surface.
(Refer to “To adjust the seat forward or backward” on
page 2-7 and “To adjust the seatback” on page 2-8.)4. Recline the seatbacks of the second row seats.
(Refer to “To adjust the seatback” on page 2-13.)
BK0115300US.book 36 ページ ２００９年７月１６日　木曜日　午前９時１３分

Seat and restraint systems
2-37
2
5. The flat seat configuration is now complete.
To return the seats to the normal position, reverse the
above procedure.
Seat belts
N00406000426
Seat belts are installed in your vehicle to help reduce the risk of
injury to the driver and passenger in the event of an accident.
Always use the provided seat belts.
Carefully review the following information for proper seat belt
usage.
WA R N I N G
!

To help reduce the risk of injury or death in an acci-
dent, seat belts and child restraints must always be
used. Refer to “Child restraints” on page 2-49 for
additional information.


Never use one seat belt for more than one person.


Never carry more people in your vehicle than there
are seat belts.


Always adjust the seat belt for a snug fit.


Always place the shoulder belt over your shoulder
and across your chest. Never put it behind you or
under your arm.


Always wear the lap belt as low as possible across
your hips, not around your waist.


Never modify or alter the seat belts in your vehicle.


To reduce the risk to the driver of serious injury or
death during deployment of the driver’s airbag,
always properly wear the seat belt and adjust the
driver’s seat as far back as possible while maintain-
ing a position that still enables you to fully apply the
pedals, easily control the steering wheel, and safely
operate the vehicle.
BK0115300US.book 37 ページ ２００９年７月１６日　木曜日　午前９時１３分