2010 MITSUBISHI GRANDIS child seat

Suitability for various seating positions
E00406800799
6 - person seat Mass group Seating position
Front passenger
Rear outboard Intermediate Outboard
Activated airbag
Deactivated airbag*
1 Left side Right side
0 - Up to 10 kg (0-9 months) XXUU U
0+ - Up to 13 kg (0-2 years) XL*2
U, L*2
U, L*2
U, L*2
I - 9 to 18 kg (9 months - 4 years) L*3
L*3
U, L*3
U, L*3
U, L*3
II & III - 15 to 36 kg (4-12 years) L*4
L*4
U, L*4
U, L*4
U, L*4 *
1
: With front passenger’s airbag deactivated by means of front passenger’s airbag ON-OFF switch.
Key of letters to be inserted in the table above: l U- Suitable for “universal” category restraints approved for use in this mass group.
l UF- Suitable for forward-facing “universal” category restraints approved for use in this mass group.
l L- Suitable for particular child restraints (

MITSUBISHI MOTORS genuine parts).
l B- Built-in restraint approved for this mass group.
l X- Seat position not suitable for children in this mass group.
L (Genuine part information) Genuine parts No. ECE No.
* 2
MZ312807 E1-04301146
* 3 MZ312745
E1-04301136
MZ313045 E1-04301133
* 4
MZ312808 E1-04301148Seat and seat belts
2-24
2
Presented by http://mmc-manuals.ru/ \251

NOTE
l The suitability table above applies to retention of child restraints using seat belts.
l When MITSUBISHI MOTORS
genuine part No. MZ313045 is used on the intermediate outboard seat, it can also be retained by means of ISOFIX child
restraint mountings.
l There is no applicable MITSUBISHI MOTORS Genuine Parts to the Mass Group “0- Up to 10 kg (0-9 months)”.

MITSUBISHI MOTORS Europe B.V. reserves the right to changes without any prior announcement.
For further information, please contact your MITSUBISHI MOTORS Authorized Service Point.
7 - person seat Mass group Seating position
Front passenger
Rear outboard Intermediate Outboard
Intermediate Cen-
tre Activated airbag
Deactivated airbag*
1 Left side Right side
0 - Up to 10 kg
(0-9 months) X XUUU X
0+ - Up to 13 kg (0-2 years) XL*2
U, L*2
U, L*2
U, L*2
L*2
I - 9 to 18 kg (9 months - 4 years) L*
3
L*3
U, L*3
U, L*3
U, L*3
L*3
II & III - 15 to 36 kg (4-12 years) L*4
L*4
U, L*4
U, L*4
U, L*4
X*
1
: With front passenger’s airbag deactivated by means of front passenger’s airbag
ON-OFF switch.
Key of letters to be inserted in the table above: l U- Suitable for “universal” category restraints approved for use in this mass group.
l UF- Suitable for forward-facing “universal” category restraints approved for use in this mass group.
l L- Suitable for particular child restraints (

MITSUBISHI MOTORS genuine parts).
l B- Built-in restraint approved for this mass group.
l X- Seat position not suitable for children in this mass group. Seat and seat belts
2-25 2
Presented by http://mmc-manuals.ru/ \251

L (Genuine part information)
Genuine parts No. ECE No.
* 2
MZ312807 E1-04301146
* 3 MZ312745
E1-04301136
MZ313045 E1-04301133
* 4
MZ312808 E1-04301148NOTE
l The suitability table above applies to retention of child restraints using seat belts.
l When MITSUBISHI MOTORS
genuine part No. MZ313045 is used on the intermediate outboard seat, it can also be retained by means of ISOFIX child
restraint mountings.
l There is no applicable MITSUBISHI MOTORS Genuine Parts to the Mass Group “0- Up to 10 kg (0-9 months)”.

MITSUBISHI MOTORS Europe B.V. reserves the right to changes without any prior announcement.
For further information, please contact your MITSUBISHI MOTORS Authorized Service Point. Seat and seat belts
2-26
2
Presented by http://mmc-manuals.ru/ \251

Installing a child restraint system to
the lower anchorage (ISOFIX child re-
straint mountings)
E00408900042
Your
vehicle’s second seat is fitted with lower an-
chorages for attaching a child restraint system with
ISOFIX mountings.
6-person seat
7-person seat Child restraint system with ISOFIX
mountings
E00409000532
The child restraint system is designed only for
seats

that incorporate lower anchorages. Retain the
child restraint system using the lower anchorages.
It is not necessary to retain the child restraint sys-
tem using the vehicle’s seat belts. Only a
MITSUBISHI MOTORS genuine child restraint
system can be used.
Genuine parts No.: MZ313045
ECE No.: E1-04301133
A: Child restraint system connectors
WARNING
l If
a child restraint system other than a
MITSUBISHI MOTORS genuine one is
used, it may not be properly retained and
the child could be seriously injured as a
result. Use only a MITSUBISHI
MOTORS genuine child restraint system. To install WARNING
l If
there is any foreign material in or
around the connectors, remove it before
installing the child restraint system. Also,
make sure the seat belt is away from, not
looped through or otherwise interfering
with, the child restraint system. If foreign
matter is not removed and/or the seat
belt interferes with the child restraint sys-
tem, the child restraint system will not be
secured properly and could move for-
ward in the event of sudden braking or a
collision, seriously injuring the child and
possibly other vehicle occupants.
l Use the top tether strap when fitting a
child restraint system with ISOFIX
mountings.
Otherwise, the child could be seriously in-
jured in the event of hard braking or a col-
lision.
l When the vehicle is moving do not adjust
the seat where the child restraint system
is installed.
1. Slide
the second seats to the fully backward position. (Refer to “To adjust forward or back-
ward” on page 2-07.) Seat and seat belts
2-27 2
Presented by http://mmc-manuals.ru/ \251

2. Open the gap a little between the seat cush-
ion (A) and the seatback (B) with your hand
to locate the lower anchorages (C). 3. Push
the child restraint system’s connectors
into the lower anchorages (C) in accordance
with the instructions provided by the child re-
straint system’s manufacturer.
4. Remove the head restraint from the location in which you wish to install a child restraint. 5. Latch
the tether strap hook (D) of the child
seat to the tether anchorage (E) and tighten
the top tether strap hook so it is securely fas-
tened. 6. Push
and pull the child restraint system in all
directions to be sure it is firmly secured.
To remove
Remove the child restraint in accordance with the
instructions provided by the child restraint sys-
tem’s manufacturer. Installing a child restraint system to a
3-point type seat belt (with emergency
locking mechanism)
E00408700545
Third seat Second seat Front passenger seat Installation:
1. Fasten
the seat belt to secure the child re-
straint system. Make sure you hear a “click”
when you insert the latch plate in the buckle.
2. Remove all slack by using the locking clip.
3. Push and pull the child restraint in all direc- tions to be sure it is secure. WARNING
l For
some types of child restraint, the lock-
ing clip (A) should be used to help avoid
personal injury during a collision or sud-
den manoeuvre.
It must be fitted and used in accordance
with the child restraint manufacturer’s in-
structions.
The locking clip must be removed when
the child restraint is removed. Seat and seat belts
2-28
2
Presented by http://mmc-manuals.ru/ \251

The SRS is NOT a substitute for the seat belts; for
maximum
protection in all types of crashes and ac-
cidents, seat belts should ALWAYS be worn by ev-
eryone who drives or rides in this vehicle. (With in-
fants and small children in child restraints and old-
er children buckled in the rear seat.) WARNING
l IT
IS VERY IMPORTANT TO AL-
WAYS PROPERLY WEAR YOUR
SEAT BELT, EVEN WITH AN AIRBAG: • Seat belts help keep the driver and pas-senger properly positioned, which re-
duces injury risk in all collisions, and
reduces the risk of serious or fatal in-
juries when the airbags inflate.
During sudden braking just before a
collision, an unrestrained or improper-
ly restrained driver or passenger can
move forward into direct contact with
or within close proximity to the airbag
which may then deploy during the col-
lision.
The initial stage of airbag inflation is
the most forceful which could cause se-
rious or fatal injuries if the occupant
contacts it at this stage.
• Seat belts reduce the risk of injury in roll-overs, rear impact collisions, and
in lower-speed frontal collisions, be-
cause driver’s and passenger’s air-
bags are not designed to inflate in
those situations.
• Seat belts reduce the risk of being thrown from your vehicle in a colli-
sion or roll-over. WARNING
l IT
IS VERY IMPORTANT TO BE PROP-
ERLY SEATED.
A driver or front passenger too close to
the steering wheel or instrument panel
during airbag deployment can be killed
or seriously injured.
Airbags inflate very fast, and with great
force.
If the driver and front passenger are not
properly seated and restrained, the air-
bags may not protect you properly, and
could cause serious or fatal injuries when
it inflates. • Before driving, adjust the driver’sseat as far back as possible while still
maintaining complete control of the ve-
hicle.
• Before driving, adjust the front passen- ger seat as far back as possible.
• Make sure all vehicle occupants are al- ways properly restrained using the
available seat belts.
• With seat belts properly fastened, the driver and passenger should sit well
back and upright without leaning
against the window or door.
l Do not sit on the edge of the seat, or lean
head or chest close to the steering wheel
or instrument panel.
Do not put feet or legs on or against the
instrument panel. WARNING
l Place all infants and small children in the
rear seat and properly restrained using
an appropriate child restraint system.
The rear seat is the safest place for in-
fants and children. WARNING
l Infants
and small children should never
be unrestrained, stand up against the in-
strument panel or be held in your arms
or on your lap. They could be seriously in-
jured or killed in a collision, including
when the airbag inflates. They should be
properly seated in the rear seat in an ap-
propriate child restraint system. See the
“Child restraint” section in this owner’s
manual. Seat and seat belts
2-30
2
Presented by http://mmc-manuals.ru/ \251

WARNING
l A REARWARD FACING CHILD RE-
STRAINT must NOT be used in the front
passenger seat if the front passenger’s air-
bag has not been deactivated. The force
of an inflating airbag could kill or cause
serious injuries to the child. A rearward
facing child restraint should be used in
the rear seat.
Front passenger’s airbag ON NOTE
l If

you have a rearward facing child restraint
system that cannot be fitted to any seat other
than the front passenger seat, be sure to turn
OFF the front passenger’s airbag ON-OFF
switch before using it. (Refer to “To turn an
airbag off” on page 2-33.)
Front passenger’s air bag OFF WARNING
l A
FORWARD FACING CHILD RE-
STRAINT should be used in the rear seat
whenever possible; if it must be used in
the front passenger seat, adjust the seat
to the most rearward position. Failure to
do so could kill or cause serious injuries
to the child. WARNING
l Older
children should be seated in the
rear seat, properly wearing the seat belt,
with an appropriate booster seat if needed.
Caution for installing the child re-
straint on vehicles with a front passen-
ger airbag
The

label shown here is attached on vehicles with a
front passenger airbag. Seat and seat belts
2-31 2
Presented by http://mmc-manuals.ru/ \251

WARNING
l Extreme Hazard!
Do
not use a rearward facing child re-
straint on a seat protected by an airbag in
front of it! How the Supplemental Restraint Sys-
tem works
E00407300935
The SRS includes the following components: 1. Airbag module (Driver)
2. Front

passenger’s airbag OFF indication lamp
3. Airbag module (Passenger)
4. Front impact sensors
5. Driver’s seat position sensor
6. Airbag control unit
7. Front passenger’s airbag ON-OFF switch 8. Side airbag modules
9.

Curtain airbag modules
10. Side impact sensors
The

airbags will operate only when the ignition
switch is in the “ON” or “START” position.

When the impact sensors detect an impact of suffi-
cient frontal or side force, an automated circuit ig-
nites materials in the inflator to generate gas and in-
flate the airbags.
The airbags deployment produces a sudden, loud
noise, and releases some smoke and powder, but
these conditions are not injurious, and do not indi-
cate a fire in the vehicle. People with respiratory
problems may feel some temporary irritation from
chemicals used to produce the deployment; open
the windows after airbag deployment, if safe to do
so.
The airbags deflate very rapidly after deployment,
so there is little danger of obscured vision.
The time required from the sensors detecting an im-
pact to deflation of the airbags after deployment is
shorter than a blink of an eye. CAUTION
l
Airbags
inflate at an extremely rapid
speed. In certain situations, contact with
inflating airbags can result in abrasions,
light cuts, bruises, and the like.
Driver’s seat position sensor E00409900166
In order to detect the fore-aft position of the driv-
er’s

seat, the driver’s seat position sensor is attach-
ed to the seat rail.
In the event of a problem in the driver’s seat posi-
tion sensor, the SRS warning lamp comes on. Seat and seat belts
2-32
2
Presented by http://mmc-manuals.ru/ \251