XPlace cover 1 onto the high-voltage
battery carefully.
XPush holder 2 onto pin 3.XTurn locks 4 counterclockwise by 90°.
The cover is locked.
Removing/installing jump start
contact cover
XRemove the high-voltage battery cover, see
(Y page 27).
Removing
XDisengage tabs :.XRemove cover ;.XStore cover 2 in the trunk for example.
Installing
XPosition cover ;.XPress down on cover ; until tabs 1
engage.
XInstall the high-voltage battery cover.! The cover must be positioned and
installed properly. Otherwise moisture
and/or dirt may impair fuse operation.
XClose the hood.
Charging the batteries
Charging the 12-volt battery
GWarning!
Never charge a battery while still installed in
the vehicle unless the accessory battery
charge unit approved by Mercedes-Benz is
being used. Gases may escape during
charging and could cause an explosion that
may result in personal injury, paint damage or
corrosion.
An accessory battery charge unit specially
adapted for Mercedes-Benz vehicles and
tested and approved by Mercedes-Benz is
available. It permits the charging of the
battery in its installed position. Contact an
authorized Mercedes-Benz Center for
information and availability.
Charge battery in accordance with the
separate instructions for the accessory
battery charger.
XRemove the high-voltage battery cover
(Y page 27).
XRemove the jump start terminal cover
(Y page 28).
XFollow the instructions in the separate
operating instructions of the charge unit.
28Practical hints221_ZA; 1; 21, en-USd2ureepe,Version: 2.11.8.12009-05-13T13:56:31+02:00 - Seite 28
