Page 184 of 333

R
if the area is lit by fluorescen tlight (the dis-
play may flicker)
R if ther eisas udden change in temperature,
e.g. when drivin gintoah eatedgarage in
winter
R if the camer alens is dirt yorobstruc ted
R if the rear of your vehicle is damaged. In this
even thave the camera position and setting
checked at aqualified specialist workshop.
Mercedes-Ben zrecom mends that you use
aM ercedes-Benz Ser vice Centre for this
purpose.
Do not use the reversing camera in these
type sofs ituation .You could, otherwise,
injure other sordamage objects and your
vehicle while you are parking.
Activating the reversing camera X
Make sure that the key is in position 2in
the ignition lock.
X Make sure that the "Reversing camera"
function is selected in COMAND APS (see
the separate operating instructions for
COMAND APS).
X Engage reverse gear.
The area behind the vehicle is shown in the
COMAND APS display.
Guide lines in the COMAND APS display
Depending on the date of manufacture of the
vehicle, the guide lines are shown in the
COMAND APS display. G
Risk of accident
Please note that objects not on ground level
may appear to be further away than they
actually are. Thes einclude:
R the bumper of the vehicl eparked behind
R trailer tow bars
R the tail-end of alorry
R slanted posts
The lines are only guides, not accurate meas-
urements of the distance to an obstacle.
Therefore, you should never pass the red line
when approachin ganobstacle. You could oth- erwise cause an accident and injur
eyourself
and others. Guide lines
;and =show the approximate
distance from the rear of the vehicle. Yellow
guide line ;approximately 1. 0mand red
guid eline =approximately 0.2 5m.Blue
line :depicts the width required for the
vehicle. It is used to align the vehicle with the
edge of the carriageway, e.g. the kerb. ATTENTION ASSIST
Important safet yguidelines ATTENTION ASSIST help
syou during long,
monotonous journeys, such as on motorways
and trunk roads. It is active in the 80 km /h
to 180 km/ hrange.
If ATTENTION ASSIST detects fatigue or
increasing lapses in concentration on the part
of the driver, it suggests you take abreak. G
Ris
kofa ccident
ATTENTION ASSIST is only an aid and may
detect your tiredness or lapses in concentra-
tion too late or not at all. It is not asubstitute
for aw ell reste dand attentiv edriver.
Fatigue may cause yo utorecognise hazard-
ous situations to olate ,misjudge asituation
or reac tslower .For this rea son, make sure
you fee lreste dbefore you begin driving and
duri ngyour jour ney. Always tak ebreaks in
good time and regularly ,especiall yduring
long jour neys. Otherwise ,you may fai ltorec- Driving systems
181Driving and parking
BA 207 ECE ÄJ 2010/1a; 1; 2, en-GB
mkalafa Version: 3.0.2.11 2010-01-26T13:03:22+01:00-Seite 181 Z
Page 314 of 333

ist workshop, e.g.
aMercedes-Ben zService
Cent re.V ehicle component smay other-
wise wear mor equickly and the vehicle's
operatin gpermit may be invalidated. Retrofitting of two-way radios and
mobile phones (RF transmitter)
Use th eTechnical Specification
ISO/TS 21609 55
implementation regulation
when retrofitting RF (radi ofrequency) trans-
mitters.
If your vehicle has fittings for two-way radio
equipmen t(e.g. taxis, hire car sorofficial vehi-
cles) ,use the power suppl yoraeria lconnec-
tion sintended for use with the basic wiring.
Be sure to observe the manufacturer's addi-
tional instructions whe ninstalling the fittings.
! Have aftermarket radio frequency trans-
mitting equipment installed at aqualified
specialist workshop. Mercedes -Ben zrec-
ommends that you use aMercedes-Benz
Ser vice Centre for thi spurpose.
The transmission output at the aerial base
must not exceed the maximum values below. Waveband Maximum trans-
mission output
(PEAK)
Short wave (f <
54 MHz) 100 W
4mw
aveband 30 W
2mw
aveband 50 W
Trunked radio/Tetra 35 W
70 cm waveband 35 W
GSM 900/AMPS 10 W
GSM 1800 10 W
UMTS 10 W The following aerial positions may be used if
RF transmitters have been properly installed:
Aerial positions: Coupé
:
Fron troof area 56
; Rear roof area 56
= Rear wing 57
? Boot lid Aerial positions: Cabriolet
:
Rear wing 57 G
Risk of accident
In co rrect retrofit ting of RF transmitters can
cause the vehicl eelectronics to malfunction,
impair the vehicle's operatin gsafety and,
thus, also impair your own safety.
To ensure proper installation, Mercedes-Benz
recommends having this work done at a
Mercedes-Benz Service Centr eoratanother
qualified specialis tworkshop.
55 ISO/TS 2160 9–Technical Specification for Road Vehicles (EMC) guidelines for installation of aftermarket
radio frequenc ytransmitting equipment.
56 Vehicles wit hpanorama sliding sunroof: this area is not permitted.
57 Recommended installation position: on the side which faces the centre of the road. Vehicl
eelectronics
311Technical da ta
BA 207 ECE ÄJ 2010/1a; 1; 2, en-GB
mkalafa Version: 3.0.2.11 2010-01-26T13:03:22+01:00-Seite 311 Z
Page 315 of 333

G
Risk of injury
Imprope rinstallation of RF transmitters can
lead to increase delec tromagnetic radiation in
the vehicle interior. Using an exterior aerial
takes into account current scientifi cdiscus-
sions relating to th epossible health hazards
that may result from electromagnetic fields.
To ensure proper installation, Merc edes-Benz
recommends having this work done at a
Mercedes-Ben zServ iceC entre or at another
qualified specialist workshop.
Deviations with respect to aeria llocations,
output and frequenc iesm ust be approved by
Mercedes-Benz.
There is no restrictio nfor aeria lposi tions in
the outer are aofthe vehicle for these wave-
bands: trunked radio/Tetr a,70 cm wave-
band, GSM 900/AMPS, GSM 1800 and
UMTS.
Legal provisions for fittings must be
obse rved.
RF transmitter switham aximum transmis-
sion outpu tof100 mW (PEAK) ma ybeused
in the vehicl ewithou trestrictions.
! The operatin gpermit may be invalidated
if the instruc tions for installation and use of
RF transmit ters are not observed ,e.g.
approved wavebands ,maximum output
and aerial positions on the vehicle. Vehicle identification plates
Vehicle identification plat
ewith vehi-
cle identification number (VIN) and
paint code number X
Open the right-hand door.
You will see vehicle identification plate :. Vehicle identi
ficatio nplate illustration
: Vehicle identification plate
; Vehicle manufacturer
= EU type approval number
? Vehicle identification number (VIN)
A Maximum permissible gross vehicle
weight
B Permissible towing weight
C Maximum permissible fron taxle load
D Maximu mpermissible rear axle load
E Paint code Vehicle identifica
tion number (VIN)
In addition to being stamped on the vehicle
identification plate, the vehicle identification 312
Vehicle identification platesTechnical data
BA 20
7ECE ÄJ 2010/1a; 1; 2, en-GB
mkalafa Version:3.0.2.11
2010-01-26T13:03:22+01:0
0-Seite 312