2010 MERCEDES-BENZ E-CLASS CABRIOLET set clock

X
To open/close: turn thumbwheel :
clockwis eoranti-clockwise.
Setting the rear-compartment air vents Setting the centre vents in the rear com-
partment
:
Rear-compartment air vent thumbwheel
; Rear-compartment air vent, right
= Rear control panel for THERMOTRONIC
luxury 3-zone automati cclimate control
? Rear-compartment air vent ,left
X To open/close: turnthumbwheel :up or
down.
Setting th eAIRSCARF vents G
Risk of injury
Very hot air can flow out of the AIRSCARF
vents in the head restraint swhen AIRSCARF
is in operation .This can cause burns on unpro-
tec teds kin near the AIRSCARF vents. Lower
the heating output in goo dtime, when neces-
sary. You can adjust the blower output of AIR-
SCARF vents
:using the AIRSCARF button
(Y page 98). Operating climate control systems
131Climatecontrol
BA 20 7ECE ÄJ 2010 /1a;1;2,e n-GB
mkalafa Version: 3.0.2.11 2010-01-26T13:03:22+01:00-Seite 131 Z

On vehicle
swith Intelligent Light System the
headlamps can be conver tedint he on-board
compute r(Ypage 206).
Switching over dipped-beam headlamps
on vehicles with halogen headlamps :
Protec tive cap
; Switchover lever
X Turn protectiv ecap : anti-clockwise and
remove it.
X Push switchover lever ;down.
X Insert protective cap :and turn it clock-
wise.
When you are driving back on the same side
of the road as the country where the vehicle
is registered, have the headlamps changed
back to asymmetrical dippe dbeam as soon
as possibl eafter crossing th eborder. Driving systems
Cruise control
Import ants afety notes Cruise control maintain
saconstant road
speed for you. It brakes automatically in order
to avoid exceeding the set speed. On long and
steep downhil lgradients ,especially if the
vehicle is laden or towing atrailer, yo umust
shift to alower gear in good tim eorselect
shift range 1,2or 3on vehicles with auto-
matic transmission. By doing so, you will
mak euse of the brakin geffect of th eengine,
which relieves the load on the brake system and prevents the brakes from overheating
and wearing too quickly. G
Risk of accident
Do not change down for additional engine
braking on aslippery road surface. This could
cause the drive wheels to lose their grip and
the vehicle could skid.
Use cruise control only if road and traffic con-
ditions make it appropriate to maintain a
steady speed for aprolonged period. Yo ucan
store any road spee dabove 30 km/h. G
Risk of accident
Cruise control cannot take account of road
and traffic conditions.
Always pay atten tion to traffic conditions
even when cruise control is activated.
Cruise control is only an aid designed to assist
driving. You are responsible for the vehicle's
speed and for brakin gingood time. G
Risk of accident
Do not use cruise control:
R in road and traffic condition swhich do not
allow you to maintain aconstant speed (e.g.
heavy traffic or winding roads). You could
otherwise cause an accident.
R on slippery roads. Brakin goraccelerating
coul dcause the drive wheels to lose trac-
tion and the vehicle could then skid.
R when there is poor visibility, e.g. due to fog,
heavy rain or snow
Cruise control lever You can operate cruise control and variable
SPEEDTRONIC with the cruise control lever.
The LIM indicator lamp on the cruise control
lever indicates which system you have selec-
ted:
R
LIM indicator lamp off: cruise control is
selected.
R LIM indicator lamp on: variableSPEED-
TRONI Cisselected. 158
Driving systemsDriving and parking
BA 20
7ECE ÄJ 2010/1a; 1; 2, en-GB
mkalafa Version: 3.0.2.11
2010-01-26T13:03:22+01:00
-Seite 158

!
You can connect consumer swithapower
ratin gofupto2 40Wtot he permanent
power supply and up to 18 0Wto the power
supp lythat is switched on via the ignition
lock.
You must not charge atrailer battery using
th ep ower supply.
The trailer's permanen tpower supply is
switched off in the even toflow vehicle supply
voltage and after six hour satthe latest.
You can obtai nfurther information about
installing the trailer electrics from aqualified
specialist workshop, e.g. aMercedes-Benz
Ser vice Centre.
X To switch the connected power supply
on or off: turn the key in the ignitio nlock
to position 2or 0respec tively. Bulb failur
eindicator for LEDs
i If LE Dlamps are fitted in the trailer, an
error message may appear in the multi-
function display –even if there is no fault –
if th ecorrespondin gLED chain's current
draw drops below 50 milliamperes (mA).
To ensure reliabl eoperation of the bulb failure
indic ator,am inimum current of 50 mA must
be guaranteed by the manufacturer of each
LED chain in the trailer lighting. Trailer with 7-pin connector
General information If you
rtrailer ha sa7-pin connector, you can
connect it to the 13-pin socket on the ball
coupling using an adapter or, if necessary, an
adapter cable. Both of thes ecan be obtained
at aq ualified specialist workshop, e.g. at a
Mercedes-Benz Service Centre. Fittin
gthe adapter X
Open th esocke tcover.
X Insert the connector with lug :into
groove ;on the socket and tur nthe con-
nector clockwi seto the stop.
X Make the cover engage.
X If you are using an adapter cable, secure
the cabl etothe trailer with cable ties.
! Make sur ethat ther eissufficient cable
pla ysot hat the cable cannot become
detached when cornering. 190
Trailer towingDriving and parking
BA 20
7ECE ÄJ 2010/1a; 1; 2, en-GB
mkalafa Version: 3.0.2.11 2010-01-26T13:03:22+01:00-Seite 190

X
Press :or9 to select the Limit
spee d(winter tyres): function.
Th ec urren tsetting is displayed.
X Press the abutton to confirm.
X Press :or9 to set permanent
SPEEDTRONI Cinincrements of ten
(240 km/h to160 km/h). Permanent
SPEEDTRONIC is deactivated with the Off
setting.
X Pres sthe a button to stor ethe entry.
Activating/deactiva ting th eautomatic
lockin gfeature
If you select the Automaticd oor locks:
function, th evehicle is centrally locked above
as peed of around 15 km/h.
i Further information on the automatic
locki ngfeature (Y page71).
X Press the =or; button on the stee r-
ing wheel to select the Settingsmenu.
X Press the :or9 buttontos elect the
Vehicle submenu.
X Press the abutton to confirm.
X Press the :or9 button to select the
Automa ticd oor locks: function.
Yo uw ill see the selected setting: onor
off.
X Press the abutton to save the setting.
Activating/deactiva ting th eacoustic
locking confirmation
If you switch on the AcousticLock feed‐
back: function, an acousti csignal sounds
when you lock or unlock the vehicle. When
unlocking, the signal sounds once. When
locking, it sounds three times.
X Press the =or; button on the steer-
ing wheel to select the Settingsmenu.
X Press the :or9 buttontos elect the
Vehicle submenu.
X Press the abutton to confirm. X
Press the :or9 button to select the
Acoust icLock feedback: function.
Yo uw ill see the selected setting: Activa‐
ted orDeacti vated.
X Press the abuttontos ave the setting.
Activating/deactivating the radar sensor
system
i You must deactivat ethe radar sensor sys-
tem in cer tain countries and near radio
telescope facilities. Fur ther information
(Y page 32 4).
Ve hicles with anavigation system: the radar
senso rsystem is deactivated automatically if
you are close to radio teles cope facilities.
The followin gsystems are switched off when
the radar sensor syste misdeactiva ted:
R DIST RONIC PLUS (Y page 160)
R BA SP LUS (Y page 56)
R PRE-SAFE ®
Brake (Y page 59)
R Blind Spo tAssist (Y page 18 4)
X Press the =or; button on the steer-
ing wheel to select the Settingsmenu.
X Press the :or9 buttontos elect the
Vehicle submenu.
X Press the abutton to confirm.
X Press the 9or: button to select
Rada rsensor (See Owner's Man.).
Yo uw ill see the selected setting: onor
off.
X Press the abutton to save the setting.
Convenience Activating/deactiva
ting th eEASY-
ENTRY/EXIT feature
You can use the Easy Entry/Exit function
to activate or deactivate the easy-entry/exit
feature (Y page 100). G
Ris
kofi njury
The steering wheel moves when the EASY-
ENTRY/EXIT feature is active. There is arisk
of occupant sbecoming trapped. Before acti- 208
Menus and submenusOn-board computer and displays
BA 20
7ECE ÄJ 2010 /1a;1;2,e n-GB
mkalafa Version: 3.0.2.11 2010-01-26T13:03:22+01:00-Seite 208

as when con
necting the do norb atter yin
the jump-starting procedure
(Y page 289). Reconnecting th
ebattery
! Always connect the battery in the order
described below. Never swap the terminal
clamps. Yo umay otherwise damage the
vehicle elect ronics.
X Switch off all ele ctrical consumers, e.g.
radio, blower, etc.
X Connect the positiv eterminal clamp and
secur ethe cov er.
X Connect th enegative termina lclamp.
X Put th efilter box back in place, then clip in
and close th eretaining clamps.
X Close th ebonnet.
i If th epower supply has been interrupted,
e.g .ift he battery has been reconnected,
you must carry out the followin gtasks:
R set the clock (Y page 205)
R reset the function for folding the exterior
mirrors in/out automatically by folding
the mirrors out once (Y page 102)288
BatteryBreakdown assistance
BA 207 ECE ÄJ 2010/1a; 1; 2, en-GB
mkalafa
Version:3.0.2.11
2010-01-26T13:03:22+01:00
-Seite 288

X
To open: pull outcover :slightly at the
bottom in the direction of arrow =.
X Pull cover :outwards in the direction of
arrow ;and remove it.
X To close: clip in cover :on the front of
the dashboard.
X Fold cover :inwards until it engages. Fuse box in th
eengine compartment
X Make sure that the windscreen wiper sare
turne doff. G
Ris
kofi njury
Make sure that the windscreen wipers are
turned off and the key is pulled out of the igni-
tion lock befor eyou open the cover of the fuse
box. Otherwise, the windscreen wiper sand
the wipe rrods abov ethe cover coul dbeset
in motion .This coul dlead to you or others
being injured by the wiper rods.
X Open the bonnet (Y page 259). X
Remov eany existing moisture from the
fuse box using adry cloth.
X Take lines ;from th eguides.
X Move aside lines ;.Route the lines behind
con nection =to do this.
X To open: open clamps :.
X Remove the fuse bo xcover forwards.
X To close: checkwhether the rubber seal is
lyin gcorrectly in the cover.
X Insert the cover at the rea rofthe fuse box
int ot he retainer.
X Fold down the cover and close clamps :.
X Secur elines ;in the guides.
! The cover must be fitted properly, other-
wise moisture or dirt could impair the func-
tion of the fuses.
X Close the bonnet (Y page 260). Fuse box in the boot
X Open the boot lid. Coupé
X
To open: turn rotarycatch :clockwise.
X Open cover ;downwards. 294
FusesBreakdown assistance
BA 207 ECE ÄJ 2010/1a; 1; 2, en-GB
mkalafa
Version:3.0.2.11
2010-01-26T13:03:22+01:00
-Seite 294