2010 MAZDA MODEL CX-7 change time

6
Before Use
Navigation
Set Up
RDM-TMCIf
necessary
Rear View
Monitor
Safety Information
nRead this owner’s manual for your Navigation System carefully before using the system.
It contains instructions about how to use the system in a safe and effective manner.
Mazda assumes no responsibility for any problems resulting from failure to observe the instructions
given in this manual.
nThis manual uses pictographs to show you how to use the product safely and to alert you to potential
dangers resulting from improper connections and operation. The meanings of the pictographs are
explained below. It is important that you fully understand the pictographs and explanations in order to
use this manual and the system properly.
Warning
Warning
The presence of this warning symbol in the text is intended to
alert you to the importance of heeding the operation
instructions. Failure to heed the instructions may result in
severe injury or death.
nDo not keep your eyes fixed on the monitor screen or operate the system
while driving.
Do not change the settings and destination locations while driving. Minimize the time
spent viewing the monitor screen and listening to the voice guidance while driving.
Operating the system will distract the driver from looking ahead of the vehicle and can
cause accidents. Always stop the vehicle in a safe location and use the parking brake
before operating the system.
n
Always obey local traffic regulations. Your guided route may include roads that are not open to vehicles or are closed due to
traffic regulations. Comply with the local traffic regulations and take another route.
n
Do not use the unit when it is out of order.If the unit is out of order (no image, no sound) or in an abnormal state (has foreign matter
in it, is exposed to water, is smoking, or smells), turn it off immediately and consult an
Authorized dealer, we recommend an Authorized Mazda Dealer. Using the unit in an out-
of-order condition may lead to accidents, fires, or electric shocks.
n
Use the proper power supply. This product is designed for operation with a negative grounded 12 V DC battery system.
n
Do not disassemble. Do not disassemble the product or attempt to repair it yourself. If the product needs to be
repaired, take it to an Authorized dealer, we recommend an Authorized Mazda Dealer.
Warnings
<00320025003a00110038003a0039001500290012004600530053004f0004000400340045004b00490004001a00040004002a0056004d00480045005d001000040028004900470049005100460049005600040015001d00100004001600140014001c000400
040015001e0018001a000400340031>

12
RoutingAddress
Book
Getting Started
The language can be changed using the Language setting displayed in the upper
part of the screen.
Before activating the navigation system
After activating the navigation system
1. Press the INFO switch to display the SETTINGS screen.
2. Select PREFERENCES and press the Enter (up/down) switch.
3. Select SELECT LANGUAGE and press the Enter (up/down) switch.
4. Select the desired language from the list.
nThe following feature settings are possible, refer to the “Multi Information
Display” in the owner’s manual.
lClock: Constant display of time.
lOutside Temperature Display: Constant display of ambient temperature.
lSettings: Used to change the multi information display settings. (Distance unit, Display
language)
The map information version can be upgraded. If you require the latest SD card of
Navigation Map data, consult an Expert Dealer, we recommend an Authorized
Mazda Dealer.
Setting the Language
Select the desired language from the list.
Press the Enter (up/down) switch to switch the screen to
CAUTION. ( page 11)
Setting the Clock, Outside Temperature Display and Other Settings
Upgrading the Map Information Version
1
With the ignition switched to ACC OFF, insert a finger into the depression
above the lid housing SD card of Navigation Map data (next to the navigation
display), and open it.
2%:8:9)FSSO4EKI*VMHE](IGIQFIV41

15
Getting Started
Navigation Set Up
lYou can alter the map display conditions, the route guidance conditions and show the
system information.
nStop your vehicle before performing the following operations. Do not change the settings and destination locations while driving. Minimize the time
spent viewing the monitor screen and listening to the voice guidance while driving.
Operating the system will distract the driver from looking ahead of the vehicle and may
cause an accident.
Always stop the vehicle in a safe location and set the parking brake before operating the
system.
Before Stepsselect
Warning
Open the
[Navigation
Setup]
nAuto ZoomThe Auto Zoom function automatically switches the map scale depending
on the distance between the next guidance point and the current position.
Used to switch the Auto Zoom function.
nMap ColorUsed to switch the map mode.
nMap DirectionUsed to switch the map direction.
nShow POI IconsUsed to display the selected POI icons on the Map screen.
nGuidance VolumeUsed to adjust the guidance volume.
Also adjustable using the audio volume knob during
transmission of the voice guidance.
Day: To switch to the daytime screen.
Night: To switch to the nighttime screen.
Auto: The screen switches between
daytime and nighttime displays in
conjunction with the on/off of the
vehicle’s exterior lights.
North Up: Geographic north is up.
Head Up: The direction you are heading is up.
2%:8:9)FSSO4EKI1SRHE].ERYEV]41

19
Getting Started
The screen map can be scaled to 14 different sizes.
nBrightness/Contrast
Brightness and contrast of the navigation screen can be adjusted.
1. Press the INFO switch to display the SETTINGS screen.
2. Select PREFERENCES and press the Enter (up/down) switch.
3. Select SCREEN ADJUSTMENT and press the Enter (up/down) switch.
4. Select BRIGHTNESS/CONTRAST and press the Enter (up/down) switch.
5. Select BRIGHTNESS or CONTRAST using the left or right switch.
6. Adjust the tone by operating the Enter (up/down) switch upward/downward.
7. After setting, press the Enter (up/down) switch to finish the setting.
nDaytime/Night screen
When the headlights are on, daytime mode can also be selected (if a brighter screen is
needed at night). This selection can only be done when the headlights are on.
lThe screen can be returned to the daytime screen while the headlights or running lights are
on by pushing the dashboard illumination knob. You will hear a beep sound and the
illumination dimmer will be canceled. With each press of the dashboard illumination knob,
the dashboard illumination will change from dim to full bright and back to dim again.
Adjusting the Map Scale
1
Press the Enter (up/down) switch up or down while the Map screen is
displayed to zoom in/out of the Map screen.
Screen Adjustments
Scale bar
2%:8:9)FSSO4EKI*VMHE](IGIQFIV41

23
Before
UseGetting
started
Routing
lFor Character Entry, please refer to page 20.
select
lDo not keep your eyes fixed on the monitor screen or operate the system while driving.Do not change the settings and destination locations while driving. Minimize the time spent
viewing the monitor screen and listening to the voice guidance while driving. Operating the system
will distract the driver from looking ahead of the vehicle and may cause an accident. Always stop
the vehicle in a safe location before operating the system.
lRoute searches with the navigation system can include roads that you cannot drive on and roads that you
are prohibited from driving on due to traffic regulations. Please comply with the traffic regulations.
Warnings
Select the desired Search Area : ALASKA
: ALABAMA
: ARKANSAS
: ARIZONA
: CALIFORNIA
: COLORADO
: CONNECTICUT
:
WASHINGTON, D.C.
: DELAWARE
: FLORIDA
: GEORGIA
: HAWAII
: IOWA
: IDAHO
: ILLINOIS
: INDIANA
: KANSAS
: KENTUCKY
: LOUISIANA
:
MASSACHUSETTS
: MARYLAND
: MAINE
: MICHIGAN : MINNESOTA
: MISSOURI
: MISSISSIPPI
: MONTANA
:
NORTH CAROLINA
: NORTH DAKOTA
: NEBRASKA
: NEW HAMPSHIRE
: NEW JERSEY
: NEW MEXICO
: NEVADA
: NEW YORK
: OHIO
: OKLAHOMA
: OREGON
: PENNSYLVANIA
: PUERTO RICO
: RHODE ISLAND
:
SOUTH CAROLINA
: SOUTH DAKOTA
: TENNESSEE
: TEXAS
: UTAH : VIRGINIA
: VIRGIN ISLANDS
OF THE U.S
: VERMONT
: WASHINGTON
: WISCONSIN
: WEST VIRGINIA
: WYOMING
: ALBERTA
:
BRITISH COLUMBIA
: MANITOBA
:
NEW BRUNSWICK
: NEWFOUNDLAND AND LABRADOR
: NOVA SCOTIA
:
NORTHWEST TERRITORIES
: NUNAVUT
: ONTARIO
:
PRINCE EDWARD ISLAND
: QUEBEC
:
SASKATCHEWAN
: YUKON
AK
AL
AR
AZ
CA
CO
CT
DC
DE
GA
HI
IA
ID
IL
IN
KS
KY
LA
MA
MD
ME
MI
MN
MO
MS
MT
NC
ND
NE
NH
NJ
NM
NV
NY
OH
OK
OR
PA
PR
RI
SC
SD
TN
TX
UT
VA
VI
VT
WA
WI
WV
WY
AB
BC
MB
NB
NS
NT
NU
ON
PE
QC
SK
YT
2%:8:9)FSSO4EKI;IHRIWHE](IGIQFIV41

43
Before
UseGetting
startedRouting Routing
If Necessary
Precautions/System Performance
Voice guidance has the following functions:
nIntersection guidance.
lThe system voice announces the distance to an upcoming turn and the turning direction.
This guidance function is automatic. Therefore, you do not have to set it, and it cannot be
disabled.
lThe system vocally announces the distance to an upcoming highway branching point or
junction.
Pressing the Navi switch in the steering switches repeats the guidance if the voice
guidance has been missed.
Voice Guidance
lThe navigation system is just a support system for the driver. The driver should
always pay attention to the traffic situation to safely make decisions. You may
be unable at times to arrive at your destination due to out-of-date information
on a map disc. You should be especially careful when selecting an urgent
destination such as a hospital or a police station.
lYour route may sometimes include roads that are not open to vehicles or are
closed due to traffic regulations. Please comply with the local traffic
regulations.
lDo not change the settings and destination locations while driving. Minimize
the time spent viewing the monitor screen and listening to the voice guidance
while driving. Operating the system will distract the driver from looking ahead
of the vehicle and may cause an accident. Always stop the vehicle in a safe
location and use the parking brake before operating the system.
When two intersections are close together, the
voice guidance may be late.When two roundabouts are close together, the
voice guidance for the second one may be late.
Repeating Voice Guidance
Warnings
Second branching pointFirst branching point150m
100m
Route
In 700m left turn.Left turn ahead,
then right turn.
Roundabout.
Take the second
exit.
2%:8:9)FSSO4EKI*VMHE](IGIQFIV41