2010 LINCOLN NAVIGATOR radio controls

[x] Cancel search: radio controls

Page 42 of 385

LINCOLN NAVIGATOR 2010  Owners Manual The front speakers remain playing for the front passengers. Press the
speaker button, or the 2/4 preset buttons simultaneously on the radio
again to deactivate the headphones and dual play mode. The w

Page 47 of 385

LINCOLN NAVIGATOR 2010  Owners Manual FAMILY ENTERTAINMENT DVD SYSTEM (IF EQUIPPED)
WARNING:Driving while distracted can result in loss of vehicle
control, accident and injury. Ford strongly recommends that
drivers use extreme caution whe

Page 55 of 385

LINCOLN NAVIGATOR 2010  Owners Manual 11./(Headphones/Speakers): Press once for Dual Play
(Headphone mode- the rear speakers are muted) and press again for
Single Play (same media playing through all speakers). You can also
press the 2 an

Page 63 of 385

LINCOLN NAVIGATOR 2010  Owners Manual Single Play:Single play consists of all occupants in the vehicle listening
to the same playing media over the front and rear speakers. When the
DVD system is on, and the same source is playing through

Page 64 of 385

LINCOLN NAVIGATOR 2010  Owners Manual Press the Headphone Control button
A to change the audio source for
Channel A.
Press MEDIA to change the audio
source for Channel A. This
information will display on the DVD
system screen.
Press the H

Page 73 of 385

LINCOLN NAVIGATOR 2010  Owners Manual The B headphone jack (5) is located
on the right side of the DVD system.
Plug in wired headphones (not
included) here.
Note:The B headphones can only
access DVD and AUX modes. They
cannot access radio

Page 74 of 385

LINCOLN NAVIGATOR 2010  Owners Manual There are three levels of control of
the FES buttons. The states are
FULL (enabled), LOCAL or
LOCKED (disabled). To change the level of control, press the memory
preset controls 3 and 5 simultaneously

Page 112 of 385

LINCOLN NAVIGATOR 2010  Owners Manual Increasing speed while using speed control
To set a higher speed:
•Press and hold SET + until you get to the desired speed, then release.
You can also use SET + to operate the tap-up function. Press
Page:   < prev 1-8 9-16 17-24 next >