17
Power (Ignition) Switch
■Starting the hybrid system
Check that the parking brake is set.
Firmly depress the brake pedal.
The “POWER” switch indicator will
turn green. If the indicator does not
turn green, the hybrid system cannot
be started.
When shift position N is selected, the
hybrid system cannot start. Select the
P position when starting the hybrid
system.
Press the “POWER” switch.
After a while, the “READY” indictor
comes on with a beep sound.
The vehicle can move when the
“READY” indicator is on even if the
engine is stopped.
Continue depressing the brake pedal
until the hybrid system is completely
started.
The hybrid system can be started
from any mode.
■Stopping the hybrid system
Stop the vehicle by depressing the brake pedal.
Set the parking brake.
Press the P position switch to shift into P.
Check that the shift position indicator on the instrument cluster shows P.
Press the “POWER” switch.
Slowly release the brake pedal and check that the indicator on the “POWER” switch is
off.
Performing the following operations when carrying the electronic key on your person
starts the hybrid system or changes “POWER” switch modes.
19
Hybrid transmission
■Shifting the shift lever
Shift lever
Operate the shift lever gently and
ensure correct shifting operation.
When shifting to the D or R
positions, move the shift lever
along the shift gate.
To shift to the N position, slide
the shift lever to the left and hold
it. The shift position will change
to N.
Shifting to B is only possible
when shift position D is selected.
The shift lever will always return
to this position after a shifting
operation.
When shifting from P to D or R, from D
to R, or from R to D, ensure that the
brake pedal is being depressed and the
vehicle is stationary.
Shift position indicator
When selecting the shift position, make
sure that the shift position has been
changed to the desired position by
checking the shift position indicator pro-
vided on the instrument panel.
When any shift position other than D or
B is selected, the arrow toward B disap-
pears from the shift position indicator.
■Shift position purpose
*: For good fuel economy and noise reduction, the D position should usually be used.
Shift positionFunction
PParking the vehicle/starting the hybrid system
RReversing
NNeutral
DNormal driving*
BApplying moderate engine braking when driving down hills or on
steep slopes
