Page 530 of 608
530
5-2. Steps to take in an emergency
If the hybrid system will not start
Reasons for the hybrid system not starting vary depending on the situation.
Check the following and perform the appropriate procedure:
■The hybrid system will not start even though the correct starting
procedure is being followed. ( P. 1 4 7 )
One of the following may be the cause of the problem:
● The electr
onic key may not be functioning properly.* (P. 5 3 3 )
● Ther
e may not be sufficient fuel in the vehicle’s tank.
Refuel the vehicle.
● Ther
e may be a malfunction in the immobilizer system.* (P. 9 6 )
● Ther
e may be a malfunction in the P position control system.*
( P. 1 5 0 , 502 )
● The hybrid s
ystem may be malfunc tioning due to an electrical
problem such as an open circuit or a blown fuse. However,
depending on the type of malfunc tion, an interim measure is avail-
able to start the hybrid system. ( P. 4 5 5)
*: It may not be possible to shift out of the P position.
■The interior lights and headlights are dim, or the horn does not
sound or sounds at a low volume.
One of the following may be the cause of the problem:
● The 12-
volt battery may be discharged. (P. 5 3 6 )
● The 12-
volt battery terminal co nnections may be loose or cor-
roded.
Page 531 of 608
5
When trouble arises
531
5-2. Steps to take in an emergency
Emergency start function
When the hybrid system does not start, the following steps can be used as
an interim measure to start the hybrid system if the “POWER” switch is
functioning normally:Set the parking brake.
Turn the “POWER” switch to ACCESSORY mode.
Press and hold the “POWER” swit ch for abou
t 15 seconds while
depressing the brake pedal firmly.
Even if the hybrid system can be started using the above steps, the system
may be malfunctioning. Ha
ve the vehicle inspected by your Lexus dealer.
■The interior lights and headlights do not turn on, or the horn does
not sound.
One of the following may be the cause of the problem:
●One or both of the 12-
volt battery terminals may be discon -
nected.
● The 12-
volt battery may be discharged. (P. 5 3 6 )
Contact your Lexus dealer if the problem cannot be repaired, or if
repair procedures are unknown.
Page 533 of 608
5
When trouble arises
533
5-2. Steps to take in an emergency
If the electronic key does not operate properly
Locking and unlocking the doors, unlocking the trunk and key linked functions
Doors
Use the mechanical key (P
. 39)
in order to perform the following
oper
ations (driver’s door only):
Locks all the doors
Closes the windows and moon
roof (turn and hold)
*
Unlocks the door
Turning the key rearward unlocks
the driver's door. Turning the key
once again unlocks the other
doors.
Opens the windows and moon
roof (turn and hold)
*
*: This setting must be customized at your Lexus dealer.
If communication between the electron ic key and vehicle is interrupted
(
P. 4 9 ) or the electronic key cannot be used because the battery is
depleted, the smart access system with push-button start and wireless
r
emote control cannot be used. In such cases, the doors and trunk can be
opened and the hybrid system can be started by following the procedure
below.
Page 535 of 608
5
When trouble arises
535
5-2. Steps to take in an emergency
To change “POWER” switch modes: Within 10 seconds of the
buzzer sounding, release the brake pedal and press the
“P
OWER” switch. Modes can be changed each time the switch is
pressed. ( P. 1 4 8 )
To start the hybrid system: Press the “POWER” switch within 10
seconds of the buzz
er sounding, keeping the brake pedal
depressed.
In the event that the hybrid system still cannot be oper
ated, contact your
Lexus dealer.
■Stopping the hybrid system
In the same method as the normal hybrid system stopping procedure, completely
stop
the vehicle and then press the “POWER” switch.
■Replacing the key battery
As the above procedure is a temporary measure, it is recommended that the elec -
tronic key battery be replaced immediately when the battery is depleted.
( P. 4 5 3 )
■When the electronic key does not work properly
Make sure that the smart access system wi th
push-button start has not been deacti-
vated in the customization setting. If it is off, turn the function on.
(Customizable features P. 5 7 2)
Page 536 of 608
536
5-2. Steps to take in an emergency
If the vehicle 12-volt battery is discharged
The following procedures may be used to start the hybrid system if the vehi-
cle’s 12-volt battery is discharged.
You can also call your Lexus dealer or a qualified repair shop.
If you have a set of jumper (or booster) cables and a second vehicle
with a 12-volt battery, you can jump start your vehicle by following the
steps below.
Open the hood and fuse box
co
ver.
Push the tab in and lift the lid off.
Open the exclusive jump start -
ing terminal cover.
Slightly pull the tab to open the
cover.
Page 537 of 608
5
When trouble arises
537
5-2. Steps to take in an emergency
Connect the jumper cables according to the following procedure:
Connect a positive jumper cable clamp to the exclusive jump start-
ing terminal on your vehicle
Connect the clamp on the other end of the positiv
e cable to the pos-
itive (+) battery terminal on the second v
ehicle
Connect a negative cable clamp to the negative (-) battery terminal
on the second vehicle
Connect the clamp at the other end of the negative cable to a solid,
stationary, unpainted metallic point aw
ay from the exclusive jump
starting terminal and any moving part s, as shown in the illustration.
Start the engine of the second v
ehicle. Increase the engine
speed slightly and maintain that le
vel for approximately 5 min-
utes to recharge the 12-volt battery of your vehicle.
Maintain the engine sp eed of the second v
ehicle and start the
hybrid system of your vehicle by turning the “POWER” switch
to ON mode.
Make sure the “READY” indicator comes on. If the indicator
does not come on, contact your Lexus dealer.
Once the hybrid system has star
ted, remove the jumper cables
in the exact reverse order from which they were connected.
Page 538 of 608
538
5-2. Steps to take in an emergency
■Starting the hybrid system when the 12-volt battery is discharged
The hybrid system cannot be started by push-starting.
■To prevent 12-volt battery discharge
●Turn off the headlights and the audio system while the hybrid system is off.
●Turn off any unnecessary electrical components when the vehicle is running at a
low speed for an extended period, such as in heavy traffic.
■When the 12-volt battery is discharged
●The hybrid system may not start. (P. 4 3 4 )
●If the 12-volt battery is depleted with the shift position in P, it will not be possible
to shift out of P. In this case, the vehi cle cannot be towed without lifting both
front wheels because the front wheels are locked by the parking lock.
( P. 4 8 3 )
●When the 12-volt battery is reconnected, start the hybrid system, depress the
brake pedal, and confirm that it is poss ible to shift into each shift position.
Close the exclusive jump starting terminal cover and reinstall
the fuse box cover.
Once the hybrid system starts, have the vehicle inspected at your
L
exus dealer as soon as possible.
Page 539 of 608
5
When trouble arises
539
5-2. Steps to take in an emergency
CAUTION
■Avoiding battery fires or explosions
The flammable gas that may be generated by the assisting vehicle battery may
catch fire and explode. Make sure to observe the following to prevent fire or sparks.
●Make sure each jumper cable is connected to the correct terminal and that it is
not unintentionally in contact with any part other than the intended terminal.
●Do not allow the other end of the jumper cable connected to the “+” terminal to
come into contact with any other parts or metal surfaces in the area, such as
brackets or unpainted metal.
●Do not allow the + and - clamps of the ju mper cables to come into contact with
each other.
●Do not allow open flame or use matches, cigarette lighters or smoke near the
battery.
■12-volt battery precautions
The 12-volt battery contains poisonous and corrosive acidic electrolyte, while
related parts contain lead and lead comp ounds. Observe the following precautions
when handling the 12-volt battery:
●When working with the 12-volt battery, always wear safety glasses and take care
not to allow any battery fluids (acid) to co me into contact with skin, clothing or the
vehicle body.
●Do not lean over the 12-volt battery.
●In the event that battery fluid comes into contact with the skin or eyes, immedi-
ately wash the affected area with water and seek medical attention. Place a wet
sponge or cloth over the affected area until medical attention can be received.
●Always wash your hands after handling the battery support, terminals, and other
battery-related parts.
●Do not allow children near the 12-volt battery.
