2010 Lexus GX460 multi display

259
2-4. Using other driving systems
2
When driving
GX460_CANADA (OM60F29U)
Intuitive parking assist∗
∗: If equipped
The distance from your vehicle to nearby obstacles when parallel parking
or maneuvering into a garage is measured by the sensors and communi-
cated via the multi-information display and a buzzer. Always check the sur-
rounding area when using this system.
Vehicles with a navigation system
Refer to the “Navigation System Owner’s Manual”.
Vehicles without a navigation system
■ Types of sensors
Front corner sensors
Front center sensors
Rear corner sensors
Rear center sensors
GX460_CANADA.book Page 259 Thursday, February 4, 2010 11:54 AM

260
2-4. Using other driving systems
GX460_CANADA (OM60F29U)
■Intuitive parking assist switch
Press the menu switch.
The multi-information display
will change modes to elec-
tronic features control mode.
Press the “ENTER” switch
upwards or downwards until
the Intuitive parking assist
mark appears in the multi-
information display.
Press the “ENTER” switch to
change to “ON”.
The Intuitive parking assist indi-
cator will be displayed.
Each pressing of the switch
turns the Intuitive parking assist
on and off.
When on, the buzzer sounds to
inform the driver that the system
is operational.
Press the menu switch to
change to the normal display.
STEP1
STEP2
GX460_CANADA.book Page 260 Thursday, February 4, 2010 11:54 AM

261
2-4. Using other driving systems
2
When driving
GX460_CANADA (OM60F29U)
DisplayWhen the sensors detect an obstacle, a graphic is shown on the multi-
information display depending on the position and distance to the obsta-
cle.
■ Optitron meter
Front corner sensor operation
Front center sensor operation
Front tire angle
Rear corner sensor operation
Rear center sensor operation
■ Accessory meter
When the vehicle is moving for-
ward or backward
A simplified image is displayed
when an obstacle is detected.
GX460_CANADA.book Page 261 Thursday, February 4, 2010 11:54 AM

268
2-4. Using other driving systems
GX460_CANADA (OM60F29U)
LDA (Lane Departure Alert)∗
∗: If equipped
While driving on a freeway or motor highway that has lane markings, this
system recognizes the lanes using a camera as a sensor to alert the driver
when the vehicle deviates from its lane.
If the system judges that the vehicle may deviate from its lane, it alerts
the driver using rapid beeping and indications on the multi-information
display.
■Turning the LDA system on
The system will be activated depending on the recognizability of
lane markings and on the vehicle speed.
Press the “LDA” switch to acti-
vate the system.
The “LDA” indicator will come
on.
Press the switch again to turn
the LDA system off.
GX460_CANADA.book Page 268 Thursday, February 4, 2010 11:54 AM

269
2-4. Using other driving systems
2
When driving
GX460_CANADA (OM60F29U)
Indication on the multi-information displayWhile the LDA system is on, a lane line display is shown on the multi-
information display to inform the driver that the LDA system is on.
●When thin lines are shown:
Lane markings are not recog-
nized by the system, or the LDA
system is temporarily canceled.
● When solid lane lines are
shown: The LDA system is
active.
Lane line display
■The LDA system can be operated when
●The “LDA” switch is on.
●Vehicle speed is between 30 mph and 125 mph (48 km/h and 200 km/h).
■Temporary cancellation of the LDA system
If any of the following occurs, the LDA system will be temporarily canceled. The
functions will resume after the necessary operating conditions have returned.
●The turn signal lever is operated.
●The brake pedal is depressed.
●The vehicle speed deviates from the operating range of the LDA system.
●The lane lines cannot be recognized while driving.
●Low speed or high speed wiper operation states.
GX460_CANADA.book Page 269 Thursday, February 4, 2010 11:54 AM

280
2-4. Using other driving systems
GX460_CANADA (OM60F29U)
■Changing the display
The screen changes as follows with each press of the wide view front
& side monitor switch.
The wide view front monitor display and trip information are not accessi-
ble when the shift lever is in R.
On vehicles with Multi-terrain Select, the Multi-terrain Monitor can be
switched to by pressing the wide view front & side monitor switch while
the system is operating.
Trip information Wide view front monitor (Side monitor)
Side monitor (Wide view front monitor)
GX460_CANADA.book Page 280 Thursday, February 4, 2010 11:54 AM

290
2-4. Using other driving systems
GX460_CANADA (OM60F29U)
Multi-terrain Select∗
∗: If equipped
Multi-terrain Select is a system that improves drivability in off-road situa-
tions.
Select a mode that most closely matches the type of terrain on
which you are driving from among 4 modes.
Engine control and brake control can be optimized in accordance
with the selected mode.
Menu switch
“ENTER” switch
Multi-information display
Displays status information
including operating status
and road type selection.
Multi-terrain Select indicator
GX460_CANADA.book Page 290 Thursday, February 4, 2010 11:54 AM

291
2-4. Using other driving systems
2
When driving
GX460_CANADA (OM60F29U)
■Selectable modes
A mode which matches the road conditions can be selected from
among the following 4 modes.
■ Switching modes
Push the menu switch.
The multi-information display
will change to electronic fea-
tures control mode.
ModeRoad Conditions
MUD & SANDSuitable for muddy roads, sandy roads, snow-covered
roads, dirt trails and other slippery or dirty conditions
LOOSE ROCKSuitable for slippery conditions consisting of mixtures of
earth and loose rock
MOGULSuitable for a wide range of off-road conditions, particu-
larly very bumpy conditions
ROCKSuitable for rocky terrain
STEP1
GX460_CANADA.book Page 291 Thursday, February 4, 2010 11:54 AM